From: Vignesh Raghavendra <vigneshr@ti.com>
To: <linux-kernel@vger.kernel.org>, Pratyush Yadav <p.yadav@ti.com>,
Tudor Ambarus <tudor.ambarus@microchip.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
<linux-mtd@lists.infradead.org>,
Richard Weinberger <richard@nod.at>
Cc: Boris Brezillon <boris.brezillon@collabora.com>,
Sekhar Nori <nsekhar@ti.com>,
Vignesh Raghavendra <vigneshr@ti.com>
Subject: Re: [PATCH v16 00/15] mtd: spi-nor: add xSPI Octal DTR support
Date: Mon, 9 Nov 2020 22:55:49 +0530 [thread overview]
Message-ID: <160494271262.25072.15509428200904851771.b4-ty@ti.com> (raw)
In-Reply-To: <20201005153138.6437-1-p.yadav@ti.com>
On Mon, 5 Oct 2020 21:01:23 +0530, Pratyush Yadav wrote:
> This series adds support for Octal DTR flashes in the SPI NOR framework,
> and then adds hooks for the Cypress Semper and Micron Xcella flashes to
> allow running them in Octal DTR mode. This series assumes that the flash
> is handed to the kernel in Legacy SPI mode.
>
> Tested on Micron MT35X and S28HS flashes for Octal DTR. Tested on Micron
> MT25Q, and Cypress S25FL for regressions. All flashes were tested by
> running a read/write stress test on top of UBIFS. On the Cypress S28HS
> flash 1-bit ECC had to be used to allow UBIFS to work since partial page
> writes don't work with 2-bit ECC.
>
> [...]
With comments on 14/15 addressed:
Applied to https://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux.git spi-nor/next, thanks!
[01/15] mtd: spi-nor: core: use EOPNOTSUPP instead of ENOTSUPP
https://git.kernel.org/mtd/c/39bdfb789b
[02/15] mtd: spi-nor: add spi_nor_controller_ops_{read_reg, write_reg, erase}()
https://git.kernel.org/mtd/c/6e1bf55d72
[03/15] mtd: spi-nor: add support for DTR protocol
https://git.kernel.org/mtd/c/0e30f47232
[04/15] mtd: spi-nor: sfdp: get command opcode extension type from BFPT
https://git.kernel.org/mtd/c/0e1b2fc4e5
[05/15] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table
https://git.kernel.org/mtd/c/fb27f19897
[06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP
https://git.kernel.org/mtd/c/6c6a2b2b8e
[07/15] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode
https://git.kernel.org/mtd/c/354b412967
[08/15] mtd: spi-nor: Introduce SNOR_F_IO_MODE_EN_VOLATILE
https://git.kernel.org/mtd/c/c6908077b1
[09/15] mtd: spi-nor: Parse SFDP SCCR Map
https://git.kernel.org/mtd/c/981a8d60e0
[10/15] mtd: spi-nor: core: enable octal DTR mode when possible
https://git.kernel.org/mtd/c/a33c89db4c
[11/15] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT
https://git.kernel.org/mtd/c/1131324aa5
[12/15] mtd: spi-nor: core: perform a Soft Reset on shutdown
https://git.kernel.org/mtd/c/d73ee7534c
[13/15] mtd: spi-nor: core: disable Octal DTR mode on suspend.
https://git.kernel.org/mtd/c/1b65c43f70
[14/15] mtd: spi-nor: spansion: add support for Cypress Semper flash
https://git.kernel.org/mtd/c/c3266af101
[15/15] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode
https://git.kernel.org/mtd/c/ad624dfd7b
--
Regards
Vignesh
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
prev parent reply other threads:[~2020-11-09 17:27 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-10-05 15:31 [PATCH v16 00/15] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 01/15] mtd: spi-nor: core: use EOPNOTSUPP instead of ENOTSUPP Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 02/15] mtd: spi-nor: add spi_nor_controller_ops_{read_reg, write_reg, erase}() Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 03/15] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 04/15] mtd: spi-nor: sfdp: get command opcode extension type from BFPT Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 05/15] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table Pratyush Yadav
2020-10-27 9:58 ` Tudor.Ambarus
2020-10-05 15:31 ` [PATCH v16 06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 07/15] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 08/15] mtd: spi-nor: Introduce SNOR_F_IO_MODE_EN_VOLATILE Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 09/15] mtd: spi-nor: Parse SFDP SCCR Map Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 10/15] mtd: spi-nor: core: enable octal DTR mode when possible Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 11/15] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 12/15] mtd: spi-nor: core: perform a Soft Reset on shutdown Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 13/15] mtd: spi-nor: core: disable Octal DTR mode on suspend Pratyush Yadav
2020-10-05 15:31 ` [PATCH v16 14/15] mtd: spi-nor: spansion: add support for Cypress Semper flash Pratyush Yadav
2020-11-07 7:58 ` Vignesh Raghavendra
2020-11-09 11:45 ` Pratyush Yadav
2020-11-09 13:28 ` Tudor.Ambarus
2020-10-05 15:31 ` [PATCH v16 15/15] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-10-06 8:11 ` Tudor.Ambarus
2020-10-28 7:53 ` [PATCH v16 00/15] mtd: spi-nor: add xSPI Octal DTR support Tudor.Ambarus
2020-10-28 12:49 ` Pratyush Yadav
2020-10-28 15:21 ` Tudor.Ambarus
2020-10-28 20:02 ` Pratyush Yadav
2020-10-29 6:26 ` Vignesh Raghavendra
2020-11-09 17:25 ` Vignesh Raghavendra [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=160494271262.25072.15509428200904851771.b4-ty@ti.com \
--to=vigneshr@ti.com \
--cc=boris.brezillon@collabora.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=nsekhar@ti.com \
--cc=p.yadav@ti.com \
--cc=richard@nod.at \
--cc=tudor.ambarus@microchip.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).