From: Pratyush Yadav <p.yadav@ti.com>
To: Tudor Ambarus <tudor.ambarus@microchip.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Richard Weinberger <richard@nod.at>,
Vignesh Raghavendra <vigneshr@ti.com>,
Mark Brown <broonie@kernel.org>,
Nicolas Ferre <nicolas.ferre@microchip.com>,
Alexandre Belloni <alexandre.belloni@bootlin.com>,
Ludovic Desroches <ludovic.desroches@microchip.com>,
Matthias Brugger <matthias.bgg@gmail.com>,
<linux-mtd@lists.infradead.org>, <linux-kernel@vger.kernel.org>,
<linux-spi@vger.kernel.org>,
<linux-arm-kernel@lists.infradead.org>,
<linux-mediatek@lists.infradead.org>
Cc: Mason Yang <masonccyang@mxic.com.tw>,
Boris Brezillon <boris.brezillon@collabora.com>,
Sekhar Nori <nsekhar@ti.com>, Pratyush Yadav <p.yadav@ti.com>
Subject: [PATCH v6 03/19] spi: spi-mtk-nor: reject DTR ops
Date: Wed, 20 May 2020 22:00:37 +0530 [thread overview]
Message-ID: <20200520163053.24357-4-p.yadav@ti.com> (raw)
In-Reply-To: <20200520163053.24357-1-p.yadav@ti.com>
Double Transfer Rate (DTR) ops are added in spi-mem. But this controller
doesn't support DTR transactions. Since we don't use the default
supports_op(), which rejects all DTR ops, do that explicitly in our
supports_op().
Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
---
drivers/spi/spi-mtk-nor.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/drivers/spi/spi-mtk-nor.c b/drivers/spi/spi-mtk-nor.c
index 7bc302b50396..7015dccedf00 100644
--- a/drivers/spi/spi-mtk-nor.c
+++ b/drivers/spi/spi-mtk-nor.c
@@ -211,6 +211,10 @@ static bool mtk_nor_supports_op(struct spi_mem *mem,
if (op->cmd.buswidth != 1)
return false;
+ /* DTR ops not supported. */
+ if (op->cmd.dtr || op->addr.dtr || op->dummy.dtr || op->data.dtr)
+ return false;
+
if ((op->addr.nbytes == 3) || (op->addr.nbytes == 4)) {
if ((op->data.dir == SPI_MEM_DATA_IN) && mtk_nor_match_read(op))
return true;
--
2.26.2
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
next prev parent reply other threads:[~2020-05-20 16:33 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-05-20 16:30 [PATCH v6 00/19] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 01/19] spi: spi-mem: allow specifying whether an op is DTR or not Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 02/19] spi: atmel-quadspi: reject DTR ops Pratyush Yadav
2020-05-20 16:30 ` Pratyush Yadav [this message]
2020-05-20 16:30 ` [PATCH v6 04/19] spi: spi-mem: allow specifying a command's extension Pratyush Yadav
2020-05-21 18:22 ` Boris Brezillon
2020-05-21 19:41 ` Pratyush Yadav
2020-05-21 20:03 ` Pratyush Yadav
2020-05-21 20:16 ` Boris Brezillon
2020-05-22 18:23 ` Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 05/19] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 06/19] mtd: spi-nor: sfdp: default to addr_width of 3 for configurable widths Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 07/19] mtd: spi-nor: sfdp: prepare BFPT parsing for JESD216 rev D Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 08/19] mtd: spi-nor: sfdp: get command opcode extension type from BFPT Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 09/19] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 10/19] mtd: spi-nor: core: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 11/19] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 12/19] mtd: spi-nor: core: enable octal DTR mode when possible Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 13/19] mtd: spi-nor: sfdp: do not make invalid quad enable fatal Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 14/19] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 15/19] mtd: spi-nor: core: perform a Soft Reset on shutdown Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 16/19] mtd: spi-nor: core: disable Octal DTR mode on suspend Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 17/19] mtd: spi-nor: core: expose spi_nor_default_setup() in core.h Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 18/19] mtd: spi-nor: spansion: add support for Cypress Semper flash Pratyush Yadav
2020-05-20 16:30 ` [PATCH v6 19/19] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-05-21 16:39 ` [PATCH v6 00/19] mtd: spi-nor: add xSPI Octal DTR support Mark Brown
2020-05-21 18:05 ` Pratyush Yadav
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200520163053.24357-4-p.yadav@ti.com \
--to=p.yadav@ti.com \
--cc=alexandre.belloni@bootlin.com \
--cc=boris.brezillon@collabora.com \
--cc=broonie@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mediatek@lists.infradead.org \
--cc=linux-mtd@lists.infradead.org \
--cc=linux-spi@vger.kernel.org \
--cc=ludovic.desroches@microchip.com \
--cc=masonccyang@mxic.com.tw \
--cc=matthias.bgg@gmail.com \
--cc=miquel.raynal@bootlin.com \
--cc=nicolas.ferre@microchip.com \
--cc=nsekhar@ti.com \
--cc=richard@nod.at \
--cc=tudor.ambarus@microchip.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).