linux-mtd.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: Pratyush Yadav <p.yadav@ti.com>
To: Tudor Ambarus <tudor.ambarus@microchip.com>,
	Miquel Raynal <miquel.raynal@bootlin.com>,
	Richard Weinberger <richard@nod.at>,
	Vignesh Raghavendra <vigneshr@ti.com>,
	Mark Brown <broonie@kernel.org>,
	Nicolas Ferre <nicolas.ferre@microchip.com>,
	Alexandre Belloni <alexandre.belloni@bootlin.com>,
	Ludovic Desroches <ludovic.desroches@microchip.com>,
	Matthias Brugger <matthias.bgg@gmail.com>,
	Michal Simek <michal.simek@xilinx.com>,
	<linux-mtd@lists.infradead.org>, <linux-kernel@vger.kernel.org>,
	<linux-spi@vger.kernel.org>,
	<linux-arm-kernel@lists.infradead.org>,
	<linux-mediatek@lists.infradead.org>
Cc: Boris Brezillon <boris.brezillon@collabora.com>,
	Sekhar Nori <nsekhar@ti.com>, Pratyush Yadav <p.yadav@ti.com>
Subject: [PATCH v10 11/17] mtd: spi-nor: sfdp: do not make invalid quad enable fatal
Date: Wed, 24 Jun 2020 00:00:24 +0530	[thread overview]
Message-ID: <20200623183030.26591-12-p.yadav@ti.com> (raw)
In-Reply-To: <20200623183030.26591-1-p.yadav@ti.com>

The Micron MT35XU512ABA flash does not support the quad enable bit. But
instead of programming the Quad Enable Require field to 000b ("Device
does not have a QE bit"), it is programmed to 111b ("Reserved").

While this is technically incorrect, it is not reason enough to abort
BFPT parsing. Instead, continue BFPT parsing and let flashes set it in
their fixup hooks.

Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
---
 drivers/mtd/spi-nor/sfdp.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/spi-nor/sfdp.c b/drivers/mtd/spi-nor/sfdp.c
index d5a24e61813c..7983ff431346 100644
--- a/drivers/mtd/spi-nor/sfdp.c
+++ b/drivers/mtd/spi-nor/sfdp.c
@@ -612,7 +612,8 @@ static int spi_nor_parse_bfpt(struct spi_nor *nor,
 		break;
 
 	default:
-		return -EINVAL;
+		dev_dbg(nor->dev, "BFPT QER reserved value used\n");
+		break;
 	}
 
 	/* Stop here if not JESD216 rev C or later. */
-- 
2.27.0


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/

  parent reply	other threads:[~2020-06-23 18:37 UTC|newest]

Thread overview: 43+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-06-23 18:30 [PATCH v10 00/17] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 01/17] spi: spi-mem: allow specifying whether an op is DTR or not Pratyush Yadav
2020-07-08 16:22   ` Tudor.Ambarus
2020-07-13  3:55   ` Tudor.Ambarus
2020-06-23 18:30 ` [PATCH v10 02/17] spi: spi-mem: allow specifying a command's extension Pratyush Yadav
2020-07-13  6:15   ` Tudor.Ambarus
2020-06-23 18:30 ` [PATCH v10 03/17] spi: atmel-quadspi: reject DTR ops Pratyush Yadav
2020-07-13  6:19   ` Tudor.Ambarus
2020-06-23 18:30 ` [PATCH v10 04/17] spi: spi-mtk-nor: " Pratyush Yadav
2020-07-13  6:24   ` Tudor.Ambarus
2020-06-23 18:30 ` [PATCH v10 05/17] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-07-07 17:37   ` Tudor.Ambarus
2020-07-21 11:29     ` Pratyush Yadav
2020-09-29 15:42       ` Tudor.Ambarus
2020-09-29 16:29         ` Pratyush Yadav
2020-09-29 18:34           ` Tudor.Ambarus
2020-09-29 16:57         ` Vignesh Raghavendra
2020-06-23 18:30 ` [PATCH v10 06/17] mtd: spi-nor: sfdp: get command opcode extension type from BFPT Pratyush Yadav
2020-07-07 17:53   ` Tudor.Ambarus
2020-06-23 18:30 ` [PATCH v10 07/17] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table Pratyush Yadav
2020-07-08 16:01   ` Tudor.Ambarus
2020-07-20 16:38     ` Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 08/17] mtd: spi-nor: core: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-07-08 16:03   ` Tudor.Ambarus
2020-07-20 16:24     ` Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 09/17] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 10/17] mtd: spi-nor: core: enable octal DTR mode when possible Pratyush Yadav
2020-06-23 18:30 ` Pratyush Yadav [this message]
2020-07-13  9:33   ` [PATCH v10 11/17] mtd: spi-nor: sfdp: do not make invalid quad enable fatal Tudor.Ambarus
2020-06-23 18:30 ` [PATCH v10 12/17] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT Pratyush Yadav
2020-07-08 16:08   ` Tudor.Ambarus
2020-07-20 16:21     ` Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 13/17] mtd: spi-nor: core: perform a Soft Reset on shutdown Pratyush Yadav
2020-07-08 16:10   ` Tudor.Ambarus
2020-07-20 16:11     ` Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 14/17] mtd: spi-nor: core: disable Octal DTR mode on suspend Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 15/17] mtd: spi-nor: core: expose spi_nor_default_setup() in core.h Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 16/17] mtd: spi-nor: spansion: add support for Cypress Semper flash Pratyush Yadav
2020-06-23 18:30 ` [PATCH v10 17/17] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-07-13  6:34 ` [PATCH v10 00/17] mtd: spi-nor: add xSPI Octal DTR support Tudor.Ambarus
2020-07-14 19:19   ` Mark Brown
2020-07-15  3:40     ` Tudor.Ambarus
2020-07-14 16:40 ` Mark Brown

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200623183030.26591-12-p.yadav@ti.com \
    --to=p.yadav@ti.com \
    --cc=alexandre.belloni@bootlin.com \
    --cc=boris.brezillon@collabora.com \
    --cc=broonie@kernel.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mediatek@lists.infradead.org \
    --cc=linux-mtd@lists.infradead.org \
    --cc=linux-spi@vger.kernel.org \
    --cc=ludovic.desroches@microchip.com \
    --cc=matthias.bgg@gmail.com \
    --cc=michal.simek@xilinx.com \
    --cc=miquel.raynal@bootlin.com \
    --cc=nicolas.ferre@microchip.com \
    --cc=nsekhar@ti.com \
    --cc=richard@nod.at \
    --cc=tudor.ambarus@microchip.com \
    --cc=vigneshr@ti.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).