From: <Tudor.Ambarus@microchip.com>
To: <p.yadav@ti.com>, <miquel.raynal@bootlin.com>, <richard@nod.at>,
<vigneshr@ti.com>, <linux-mtd@lists.infradead.org>,
<linux-kernel@vger.kernel.org>
Cc: boris.brezillon@collabora.com, nsekhar@ti.com
Subject: Re: [PATCH v14 11/15] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT
Date: Thu, 1 Oct 2020 08:21:54 +0000 [thread overview]
Message-ID: <42ac8a85-8d39-07c9-e117-1c26f11c18e4@microchip.com> (raw)
In-Reply-To: <20200930185732.6201-12-p.yadav@ti.com>
On 9/30/20 9:57 PM, Pratyush Yadav wrote:
> EXTERNAL EMAIL: Do not click links or open attachments unless you know the content is safe
>
> A Soft Reset sequence will return the flash to Power-on-Reset (POR)
> state. It consists of two commands: Soft Reset Enable and Soft Reset.
> Find out if the sequence is supported from BFPT DWORD 16.
>
> Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
Reviewed-by: Tudor Ambarus <tudor.ambarus@microchip.com>
> ---
> drivers/mtd/spi-nor/core.h | 1 +
> drivers/mtd/spi-nor/sfdp.c | 4 ++++
> drivers/mtd/spi-nor/sfdp.h | 2 ++
> 3 files changed, 7 insertions(+)
>
> diff --git a/drivers/mtd/spi-nor/core.h b/drivers/mtd/spi-nor/core.h
> index 105a4ddeb309..0a775a7b5606 100644
> --- a/drivers/mtd/spi-nor/core.h
> +++ b/drivers/mtd/spi-nor/core.h
> @@ -27,6 +27,7 @@ enum spi_nor_option_flags {
> SNOR_F_HAS_4BIT_BP = BIT(12),
> SNOR_F_HAS_SR_BP3_BIT6 = BIT(13),
> SNOR_F_IO_MODE_EN_VOLATILE = BIT(14),
> + SNOR_F_SOFT_RESET = BIT(15),
> };
>
> struct spi_nor_read_command {
> diff --git a/drivers/mtd/spi-nor/sfdp.c b/drivers/mtd/spi-nor/sfdp.c
> index 0b5b9ea44cfc..f6d77004fd4e 100644
> --- a/drivers/mtd/spi-nor/sfdp.c
> +++ b/drivers/mtd/spi-nor/sfdp.c
> @@ -608,6 +608,10 @@ static int spi_nor_parse_bfpt(struct spi_nor *nor,
> break;
> }
>
> + /* Soft Reset support. */
> + if (bfpt.dwords[BFPT_DWORD(16)] & BFPT_DWORD16_SWRST_EN_RST)
> + nor->flags |= SNOR_F_SOFT_RESET;
> +
> /* Stop here if not JESD216 rev C or later. */
> if (bfpt_header->length == BFPT_DWORD_MAX_JESD216B)
> return spi_nor_post_bfpt_fixups(nor, bfpt_header, &bfpt,
> diff --git a/drivers/mtd/spi-nor/sfdp.h b/drivers/mtd/spi-nor/sfdp.h
> index 6d7243067252..89152ae1cf3e 100644
> --- a/drivers/mtd/spi-nor/sfdp.h
> +++ b/drivers/mtd/spi-nor/sfdp.h
> @@ -90,6 +90,8 @@ struct sfdp_bfpt {
> #define BFPT_DWORD15_QER_SR2_BIT1_NO_RD (0x4UL << 20)
> #define BFPT_DWORD15_QER_SR2_BIT1 (0x5UL << 20) /* Spansion */
>
> +#define BFPT_DWORD16_SWRST_EN_RST BIT(12)
> +
> #define BFPT_DWORD18_CMD_EXT_MASK GENMASK(30, 29)
> #define BFPT_DWORD18_CMD_EXT_REP (0x0UL << 29) /* Repeat */
> #define BFPT_DWORD18_CMD_EXT_INV (0x1UL << 29) /* Invert */
> --
> 2.28.0
>
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
next prev parent reply other threads:[~2020-10-01 8:22 UTC|newest]
Thread overview: 40+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-09-30 18:57 [PATCH v14 00/15] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 01/15] mtd: spi-nor: core: use EOPNOTSUPP instead of ENOTSUPP Pratyush Yadav
2020-10-01 7:19 ` Tudor.Ambarus
2020-10-01 7:34 ` Pratyush Yadav
2020-10-01 7:50 ` Miquel Raynal
2020-10-01 8:18 ` Tudor.Ambarus
2020-10-01 10:50 ` Vignesh Raghavendra
2020-09-30 18:57 ` [PATCH v14 02/15] mtd: spi-nor: add spi_nor_controller_ops_{read_reg, write_reg, erase}() Pratyush Yadav
2020-10-01 7:21 ` [PATCH v14 02/15] mtd: spi-nor: add spi_nor_controller_ops_{read_reg,write_reg,erase}() Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 03/15] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-10-01 7:46 ` Tudor.Ambarus
2020-10-01 8:37 ` Pratyush Yadav
2020-10-01 8:49 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 04/15] mtd: spi-nor: sfdp: get command opcode extension type from BFPT Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 05/15] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table Pratyush Yadav
2020-10-01 7:49 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-10-01 7:50 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 07/15] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-10-01 7:52 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 08/15] mtd: spi-nor: core: enable octal DTR mode when possible Pratyush Yadav
2020-10-01 8:09 ` Tudor.Ambarus
2020-10-01 8:42 ` Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 09/15] mtd: spi-nor: Introduce SNOR_F_IO_MODE_EN_VOLATILE Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 10/15] mtd: spi-nor: Parse SFDP SCCR Map Pratyush Yadav
2020-10-01 8:20 ` Tudor.Ambarus
2020-10-01 11:56 ` Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 11/15] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT Pratyush Yadav
2020-10-01 8:21 ` Tudor.Ambarus [this message]
2020-09-30 18:57 ` [PATCH v14 12/15] mtd: spi-nor: core: perform a Soft Reset on shutdown Pratyush Yadav
2020-10-01 8:23 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 13/15] mtd: spi-nor: core: disable Octal DTR mode on suspend Pratyush Yadav
2020-10-01 8:26 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 14/15] mtd: spi-nor: spansion: add support for Cypress Semper flash Pratyush Yadav
2020-10-01 8:35 ` Tudor.Ambarus
2020-10-01 8:40 ` Pratyush Yadav
2020-10-01 8:50 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 15/15] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-10-01 8:38 ` Tudor.Ambarus
2020-10-01 19:43 ` Pratyush Yadav
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=42ac8a85-8d39-07c9-e117-1c26f11c18e4@microchip.com \
--to=tudor.ambarus@microchip.com \
--cc=boris.brezillon@collabora.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=nsekhar@ti.com \
--cc=p.yadav@ti.com \
--cc=richard@nod.at \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).