* [PATCH] ARM: dts: Unify pinctrl-single pin group nodes for ti81xx
@ 2023-05-23 7:58 Tony Lindgren
0 siblings, 0 replies; only message in thread
From: Tony Lindgren @ 2023-05-23 7:58 UTC (permalink / raw)
To: linux-omap
Cc: Benoît Cousson, devicetree, Conor Dooley,
Krzysztof Kozlowski, Rob Herring
We want to unify the pinctrl-single pin group nodes to use naming "pins".
Otherwise non-standad pin group names will add make dtbs checks errors
when the pinctrl-single yaml binding gets merged.
Cc: Conor Dooley <conor+dt@kernel.org>
Cc: Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>
Cc: Rob Herring <robh+dt@kernel.org>
Signed-off-by: Tony Lindgren <tony@atomide.com>
---
arch/arm/boot/dts/am3874-iceboard.dts | 16 ++++++++--------
arch/arm/boot/dts/dm8148-evm.dts | 6 +++---
arch/arm/boot/dts/dm8148-t410.dts | 6 +++---
arch/arm/boot/dts/dm8168-evm.dts | 10 +++++-----
arch/arm/boot/dts/dra62x-j5eco-evm.dts | 4 ++--
5 files changed, 21 insertions(+), 21 deletions(-)
diff --git a/arch/arm/boot/dts/am3874-iceboard.dts b/arch/arm/boot/dts/am3874-iceboard.dts
--- a/arch/arm/boot/dts/am3874-iceboard.dts
+++ b/arch/arm/boot/dts/am3874-iceboard.dts
@@ -285,7 +285,7 @@ i2c@6 {
};
&pincntl {
- mmc2_pins: pinmux_mmc2_pins {
+ mmc2_pins: mmc2-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0800, PIN_INPUT | 0x1) /* SD1_CLK */
DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP | 0x1) /* SD1_CMD */
@@ -299,19 +299,19 @@ DM814X_IOPAD(0x093C, PIN_INPUT | 0x2) /* SD1_SDCD */
>;
};
- usb0_pins: pinmux_usb0_pins {
+ usb0_pins: usb0-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */
>;
};
- usb1_pins: pinmux_usb1_pins {
+ usb1_pins: usb1-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0834, PIN_OUTPUT | 0x80) /* USB1_DRVVBUS */
>;
};
- gpio1_pins: pinmux_gpio1_pins {
+ gpio1_pins: gpio1-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x081c, PIN_OUTPUT | 0x80) /* PROGRAM_B */
DM814X_IOPAD(0x0820, PIN_INPUT | 0x80) /* INIT_B */
@@ -336,7 +336,7 @@ DM814X_IOPAD(0x0ab0, PIN_INPUT_PULLUP | 0x80) /* FPGA_TDI */
>;
};
- gpio2_pins: pinmux_gpio2_pins {
+ gpio2_pins: gpio2-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x090c, PIN_INPUT_PULLUP | 0x80) /* PHY A IRQ */
DM814X_IOPAD(0x0910, PIN_INPUT_PULLUP | 0x80) /* PHY A RESET */
@@ -349,7 +349,7 @@ DM814X_IOPAD(0x0a2c, PIN_INPUT_PULLUP | 0x80) /* GPIO RESET */
>;
};
- gpio4_pins: pinmux_gpio4_pins {
+ gpio4_pins: gpio4-pins {
pinctrl-single,pins = <
/* The PLL doesn't react well to the SPI controller reset, so
* we force the CS lines to pull up as GPIOs until we're ready.
@@ -364,14 +364,14 @@ DM814X_IOPAD(0x0b50, PIN_INPUT_PULLUP | 0x80) /* BP_ARM_GPIO5 */
>;
};
- spi2_pins: pinmux_spi2_pins {
+ spi2_pins: spi2-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0950, PIN_INPUT_PULLUP | 0x80) /* PLL SPI CS1 as GPIO */
DM814X_IOPAD(0x0818, PIN_INPUT_PULLUP | 0x80) /* PLL SPI CS2 as GPIO */
>;
};
- spi4_pins: pinmux_spi4_pins {
+ spi4_pins: spi4-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0a7c, 0x20)
DM814X_IOPAD(0x0b74, 0x20)
diff --git a/arch/arm/boot/dts/dm8148-evm.dts b/arch/arm/boot/dts/dm8148-evm.dts
--- a/arch/arm/boot/dts/dm8148-evm.dts
+++ b/arch/arm/boot/dts/dm8148-evm.dts
@@ -116,7 +116,7 @@ &mmc3 {
};
&pincntl {
- sd1_pins: pinmux_sd1_pins {
+ sd1_pins: sd1-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0800, PIN_INPUT | 0x1) /* SD1_CLK */
DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP | 0x1) /* SD1_CMD */
@@ -129,13 +129,13 @@ DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP | 0x80) /* GP1[6] */
>;
};
- usb0_pins: pinmux_usb0_pins {
+ usb0_pins: usb0-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */
>;
};
- usb1_pins: pinmux_usb1_pins {
+ usb1_pins: usb1-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0834, PIN_OUTPUT | 0x80) /* USB1_DRVVBUS */
>;
diff --git a/arch/arm/boot/dts/dm8148-t410.dts b/arch/arm/boot/dts/dm8148-t410.dts
--- a/arch/arm/boot/dts/dm8148-t410.dts
+++ b/arch/arm/boot/dts/dm8148-t410.dts
@@ -71,7 +71,7 @@ &mmc3 {
};
&pincntl {
- sd2_pins: pinmux_sd2_pins {
+ sd2_pins: sd2-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x09c0, PIN_INPUT_PULLUP | 0x1) /* SD2_DAT[7] */
DM814X_IOPAD(0x09c4, PIN_INPUT_PULLUP | 0x1) /* SD2_DAT[6] */
@@ -87,13 +87,13 @@ DM814X_IOPAD(0x0920, PIN_INPUT | 0x40) /* SD2_SDCD */
>;
};
- usb0_pins: pinmux_usb0_pins {
+ usb0_pins: usb0-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */
>;
};
- usb1_pins: pinmux_usb1_pins {
+ usb1_pins: usb1-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0834, PIN_OUTPUT | 0x80) /* USB1_DRVVBUS */
>;
diff --git a/arch/arm/boot/dts/dm8168-evm.dts b/arch/arm/boot/dts/dm8168-evm.dts
--- a/arch/arm/boot/dts/dm8168-evm.dts
+++ b/arch/arm/boot/dts/dm8168-evm.dts
@@ -30,7 +30,7 @@ sata_refclk: fixedclock0 {
};
&dm816x_pinmux {
- mcspi1_pins: pinmux_mcspi1_pins {
+ mcspi1_pins: mcspi1-pins {
pinctrl-single,pins = <
DM816X_IOPAD(0x0a94, MUX_MODE0) /* SPI_SCLK */
DM816X_IOPAD(0x0a98, MUX_MODE0) /* SPI_SCS0 */
@@ -39,7 +39,7 @@ DM816X_IOPAD(0x0aac, MUX_MODE0) /* SPI_D1 */
>;
};
- mmc_pins: pinmux_mmc_pins {
+ mmc_pins: mmc-pins {
pinctrl-single,pins = <
DM816X_IOPAD(0x0a70, MUX_MODE0) /* SD_POW */
DM816X_IOPAD(0x0a74, MUX_MODE0) /* SD_CLK */
@@ -53,19 +53,19 @@ DM816X_IOPAD(0x0a90, MUX_MODE2) /* GP1[8] */
>;
};
- usb0_pins: pinmux_usb0_pins {
+ usb0_pins: usb0-pins {
pinctrl-single,pins = <
DM816X_IOPAD(0x0d04, MUX_MODE0) /* USB0_DRVVBUS */
>;
};
- usb1_pins: pinmux_usb1_pins {
+ usb1_pins: usb1-pins {
pinctrl-single,pins = <
DM816X_IOPAD(0x0d08, MUX_MODE0) /* USB1_DRVVBUS */
>;
};
- nandflash_pins: nandflash_pins {
+ nandflash_pins: nandflash-pins {
pinctrl-single,pins = <
DM816X_IOPAD(0x0b38, PULL_UP | MUX_MODE0) /* PINCTRL207 GPMC_CS0*/
DM816X_IOPAD(0x0b60, PULL_ENA | MUX_MODE0) /* PINCTRL217 GPMC_ADV_ALE */
diff --git a/arch/arm/boot/dts/dra62x-j5eco-evm.dts b/arch/arm/boot/dts/dra62x-j5eco-evm.dts
--- a/arch/arm/boot/dts/dra62x-j5eco-evm.dts
+++ b/arch/arm/boot/dts/dra62x-j5eco-evm.dts
@@ -108,7 +108,7 @@ &mmc2 {
};
&pincntl {
- sd1_pins: pinmux_sd1_pins {
+ sd1_pins: sd1-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0800, PIN_INPUT | 0x1) /* SD1_CLK */
DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP | 0x1) /* SD1_CMD */
@@ -121,7 +121,7 @@ DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP | 0x80) /* GP1[6] */
>;
};
- usb0_pins: pinmux_usb0_pins {
+ usb0_pins: usb0-pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */
>;
--
2.40.1
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2023-05-23 8:06 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2023-05-23 7:58 [PATCH] ARM: dts: Unify pinctrl-single pin group nodes for ti81xx Tony Lindgren
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).