[PATCH v2] PCI: ftpci100: rename macro name collision

[Randy Dunlap <rdunlap@infradead.org>]

PCI_IOSIZE is defined in mach-loongson64/spaces.h, so change the name
of the PCI_* macros in pci-ftpci100.c to use FTPCI_* so that they are
more localized and won't conflict with other drivers or arches.

../drivers/pci/controller/pci-ftpci100.c:37: warning: "PCI_IOSIZE" redefined
   37 | #define PCI_IOSIZE 0x00
      | 
In file included from ../arch/mips/include/asm/addrspace.h:13,
...              from ../drivers/pci/controller/pci-ftpci100.c:15:
arch/mips/include/asm/mach-loongson64/spaces.h:11: note: this is the location of the previous definition
   11 | #define PCI_IOSIZE SZ_16M

Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Reported-by: kernel test robot <lkp@intel.com>
Suggested-by: Linus Walleij <linus.walleij@linaro.org>
Cc: Jiaxun Yang <jiaxun.yang@flygoat.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
Cc: Krzysztof Wilczyński <kw@linux.com>
Cc: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
Cc: linux-mips@vger.kernel.org
---
v2: prefix PCI_ macro names with "FT", thus use FTPCI_ for these macro names.
    (suggested by Linus Walleij)

 drivers/pci/controller/pci-ftpci100.c |   30 ++++++++++++------------
 1 file changed, 15 insertions(+), 15 deletions(-)

--- linux-next-20210514.orig/drivers/pci/controller/pci-ftpci100.c
+++ linux-next-20210514/drivers/pci/controller/pci-ftpci100.c
@@ -34,12 +34,12 @@
  * Special configuration registers directly in the first few words
  * in I/O space.
  */
-#define PCI_IOSIZE	0x00
-#define PCI_PROT	0x04 /* AHB protection */
-#define PCI_CTRL	0x08 /* PCI control signal */
-#define PCI_SOFTRST	0x10 /* Soft reset counter and response error enable */
-#define PCI_CONFIG	0x28 /* PCI configuration command register */
-#define PCI_DATA	0x2C
+#define FTPCI_IOSIZE	0x00
+#define FTPCI_PROT	0x04 /* AHB protection */
+#define FTPCI_CTRL	0x08 /* PCI control signal */
+#define FTPCI_SOFTRST	0x10 /* Soft reset counter and response error enable */
+#define FTPCI_CONFIG	0x28 /* PCI configuration command register */
+#define FTPCI_DATA	0x2C
 
 #define FARADAY_PCI_STATUS_CMD		0x04 /* Status and command */
 #define FARADAY_PCI_PMC			0x40 /* Power management control */
@@ -195,9 +195,9 @@ static int faraday_raw_pci_read_config(s
 			PCI_CONF_FUNCTION(PCI_FUNC(fn)) |
 			PCI_CONF_WHERE(config) |
 			PCI_CONF_ENABLE,
-			p->base + PCI_CONFIG);
+			p->base + FTPCI_CONFIG);
 
-	*value = readl(p->base + PCI_DATA);
+	*value = readl(p->base + FTPCI_DATA);
 
 	if (size == 1)
 		*value = (*value >> (8 * (config & 3))) & 0xFF;
@@ -230,17 +230,17 @@ static int faraday_raw_pci_write_config(
 			PCI_CONF_FUNCTION(PCI_FUNC(fn)) |
 			PCI_CONF_WHERE(config) |
 			PCI_CONF_ENABLE,
-			p->base + PCI_CONFIG);
+			p->base + FTPCI_CONFIG);
 
 	switch (size) {
 	case 4:
-		writel(value, p->base + PCI_DATA);
+		writel(value, p->base + FTPCI_DATA);
 		break;
 	case 2:
-		writew(value, p->base + PCI_DATA + (config & 3));
+		writew(value, p->base + FTPCI_DATA + (config & 3));
 		break;
 	case 1:
-		writeb(value, p->base + PCI_DATA + (config & 3));
+		writeb(value, p->base + FTPCI_DATA + (config & 3));
 		break;
 	default:
 		ret = PCIBIOS_BAD_REGISTER_NUMBER;
@@ -469,7 +469,7 @@ static int faraday_pci_probe(struct plat
 		if (!faraday_res_to_memcfg(io->start - win->offset,
 					   resource_size(io), &val)) {
 			/* setup I/O space size */
-			writel(val, p->base + PCI_IOSIZE);
+			writel(val, p->base + FTPCI_IOSIZE);
 		} else {
 			dev_err(dev, "illegal IO mem size\n");
 			return -EINVAL;
@@ -477,11 +477,11 @@ static int faraday_pci_probe(struct plat
 	}
 
 	/* Setup hostbridge */
-	val = readl(p->base + PCI_CTRL);
+	val = readl(p->base + FTPCI_CTRL);
 	val |= PCI_COMMAND_IO;
 	val |= PCI_COMMAND_MEMORY;
 	val |= PCI_COMMAND_MASTER;
-	writel(val, p->base + PCI_CTRL);
+	writel(val, p->base + FTPCI_CTRL);
 	/* Mask and clear all interrupts */
 	faraday_raw_pci_write_config(p, 0, 0, FARADAY_PCI_CTRL2 + 2, 2, 0xF000);
 	if (variant->cascaded_irq) {