[PATCH v3 2/2] PCI: qcom: Add basic interconnect support

[Johan Hovold <johan+linaro@kernel.org>]

On Qualcomm platforms like SC8280XP and SA8540P, interconnect bandwidth
must be requested before enabling interconnect clocks.

Add basic support for managing an optional "pcie-mem" interconnect path
by setting a low constraint before enabling clocks and updating it after
the link is up.

Note that it is not possible for a controller driver to set anything but
a maximum peak bandwidth as expected average bandwidth will vary with
use case and actual use (and power policy?). This very much remains an
unresolved problem with the interconnect framework.

Also note that no constraint is set for the SC8280XP/SA8540P "cpu-pcie"
path for now as it is not clear what an appropriate constraint would be
(and the system does not crash when left unspecified).

Fixes: 70574511f3fc ("PCI: qcom: Add support for SC8280XP")
Reviewed-by: Brian Masney <bmasney@redhat.com>
Acked-by: Georgi Djakov <djakov@kernel.org>
Signed-off-by: Johan Hovold <johan+linaro@kernel.org>
---
 drivers/pci/controller/dwc/pcie-qcom.c | 76 ++++++++++++++++++++++++++
 1 file changed, 76 insertions(+)

diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 7db94a22238d..91b113d0c02a 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -12,6 +12,7 @@
 #include <linux/crc8.h>
 #include <linux/delay.h>
 #include <linux/gpio/consumer.h>
+#include <linux/interconnect.h>
 #include <linux/interrupt.h>
 #include <linux/io.h>
 #include <linux/iopoll.h>
@@ -224,6 +225,7 @@ struct qcom_pcie {
 	union qcom_pcie_resources res;
 	struct phy *phy;
 	struct gpio_desc *reset;
+	struct icc_path *icc_mem;
 	const struct qcom_pcie_cfg *cfg;
 };
 
@@ -1644,6 +1646,74 @@ static const struct dw_pcie_ops dw_pcie_ops = {
 	.start_link = qcom_pcie_start_link,
 };
 
+static int qcom_pcie_icc_init(struct qcom_pcie *pcie)
+{
+	struct dw_pcie *pci = pcie->pci;
+	int ret;
+
+	pcie->icc_mem = devm_of_icc_get(pci->dev, "pcie-mem");
+	if (IS_ERR(pcie->icc_mem))
+		return PTR_ERR(pcie->icc_mem);
+
+	/*
+	 * Some Qualcomm platforms require interconnect bandwidth constraints
+	 * to be set before enabling interconnect clocks.
+	 *
+	 * Set an initial peak bandwidth corresponding to single-lane Gen 1
+	 * for the pcie-mem path.
+	 */
+	ret = icc_set_bw(pcie->icc_mem, 0, MBps_to_icc(250));
+	if (ret) {
+		dev_err(pci->dev, "failed to set interconnect bandwidth: %d\n",
+			ret);
+		return ret;
+	}
+
+	return 0;
+}
+
+static void qcom_pcie_icc_update(struct qcom_pcie *pcie)
+{
+	struct dw_pcie *pci = pcie->pci;
+	u32 offset, status, bw;
+	int speed, width;
+	int ret;
+
+	if (!pcie->icc_mem)
+		return;
+
+	offset = dw_pcie_find_capability(pci, PCI_CAP_ID_EXP);
+	status = readw(pci->dbi_base + offset + PCI_EXP_LNKSTA);
+
+	/* Only update constraints if link is up. */
+	if (!(status & PCI_EXP_LNKSTA_DLLLA))
+		return;
+
+	speed = FIELD_GET(PCI_EXP_LNKSTA_CLS, status);
+	width = FIELD_GET(PCI_EXP_LNKSTA_NLW, status);
+
+	switch (speed) {
+	case 1:
+		bw = MBps_to_icc(250);
+		break;
+	case 2:
+		bw = MBps_to_icc(500);
+		break;
+	default:
+		WARN_ON_ONCE(1);
+		fallthrough;
+	case 3:
+		bw = MBps_to_icc(985);
+		break;
+	}
+
+	ret = icc_set_bw(pcie->icc_mem, 0, width * bw);
+	if (ret) {
+		dev_err(pci->dev, "failed to set interconnect bandwidth: %d\n",
+			ret);
+	}
+}
+
 static int qcom_pcie_probe(struct platform_device *pdev)
 {
 	struct device *dev = &pdev->dev;
@@ -1704,6 +1774,10 @@ static int qcom_pcie_probe(struct platform_device *pdev)
 		goto err_pm_runtime_put;
 	}
 
+	ret = qcom_pcie_icc_init(pcie);
+	if (ret)
+		goto err_pm_runtime_put;
+
 	ret = pcie->cfg->ops->get_resources(pcie);
 	if (ret)
 		goto err_pm_runtime_put;
@@ -1722,6 +1796,8 @@ static int qcom_pcie_probe(struct platform_device *pdev)
 		goto err_phy_exit;
 	}
 
+	qcom_pcie_icc_update(pcie);
+
 	return 0;
 
 err_phy_exit:
-- 
2.37.3