Re: [PATCH v8 07/10] PCI: qcom: Handle MSIs routed to multiple GIC interrupts

[Johan Hovold <johan@kernel.org>]

On Thu, May 12, 2022 at 01:45:42PM +0300, Dmitry Baryshkov wrote:
> On some of Qualcomm platforms each group of 32 MSI vectors is routed to the
> separate GIC interrupt. Thus, to receive higher MSI vectors properly,
> declare that the host should use split MSI IRQ handling on these
> platforms.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
> ---
>  drivers/pci/controller/dwc/pcie-qcom.c | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index 2e5464edc36e..f79752d1d680 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -194,6 +194,7 @@ struct qcom_pcie_ops {
>  
>  struct qcom_pcie_cfg {
>  	const struct qcom_pcie_ops *ops;
> +	unsigned int has_split_msi_irq:1;
>  	unsigned int pipe_clk_need_muxing:1;
>  	unsigned int has_tbu_clk:1;
>  	unsigned int has_ddrss_sf_tbu_clk:1;

> @@ -1592,6 +1599,11 @@ static int qcom_pcie_probe(struct platform_device *pdev)
>  
>  	pcie->cfg = pcie_cfg;
>  
> +	if (pcie->cfg->has_split_msi_irq) {
> +		pp->num_vectors = MAX_MSI_IRQS;
> +		pp->has_split_msi_irq = true;
> +	}

If all qcom platform that can support more than 32 MSI require multiple
IRQs, how about adding num_vectors to the config instead and set
pp->has_split_msi_irq when cfg->num_vectors is set (or unconditionally
if you remove the corresponding warning you just added to the dwc host
code)?

At least some sc8280xp seem to only support 128 MSI (using 4 IRQs).

> +
>  	pcie->reset = devm_gpiod_get_optional(dev, "perst", GPIOD_OUT_HIGH);
>  	if (IS_ERR(pcie->reset)) {
>  		ret = PTR_ERR(pcie->reset);

Johan