linux-pci.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Robin Murphy <robin.murphy@arm.com>
To: Laurentiu Tudor <laurentiu.tudor@nxp.com>,
	Li Yang <leoyang.li@nxp.com>, Olof Johansson <olof@lixom.net>
Cc: "mark.rutland@arm.com" <mark.rutland@arm.com>,
	"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
	Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>,
	"arnd@arndb.de" <arnd@arndb.de>,
	"m.karthikeyan@mobiveil.co.in" <m.karthikeyan@mobiveil.co.in>,
	"linux-pci@vger.kernel.org" <linux-pci@vger.kernel.org>,
	"Z.q. Hou" <zhiqiang.hou@nxp.com>,
	"l.subrahmanya@mobiveil.co.in" <l.subrahmanya@mobiveil.co.in>,
	"will.deacon@arm.com" <will.deacon@arm.com>,
	Russell King - ARM Linux admin <linux@armlinux.org.uk>,
	"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
	"M.h. Lian" <minghuan.lian@nxp.com>,
	"robh+dt@kernel.org" <robh+dt@kernel.org>,
	Xiaowei Bao <xiaowei.bao@nxp.com>,
	"catalin.marinas@arm.com" <catalin.marinas@arm.com>,
	"bhelgaas@google.com" <bhelgaas@google.com>,
	"andrew.murray@arm.com" <andrew.murray@arm.com>,
	"shawnguo@kernel.org" <shawnguo@kernel.org>,
	Mingkai Hu <mingkai.hu@nxp.com>,
	"linux-arm-kernel@lists.infradead.org" 
	<linux-arm-kernel@lists.infradead.org>
Subject: Re: [PATCHv9 00/12] PCI: Recode Mobiveil driver and add PCIe Gen4 driver for NXP Layerscape SoCs
Date: Tue, 11 Feb 2020 13:04:14 +0000	[thread overview]
Message-ID: <aec47903-50e4-c61b-6aec-63e3e9bc9332@arm.com> (raw)
In-Reply-To: <da4dcdc7-c022-db67-cda2-f90f086b729e@nxp.com>

On 2020-02-11 12:13 pm, Laurentiu Tudor wrote:
[...]
>> This is a known issue about DPAA2 MC bus not working well with SMMU
>> based IO mapping.  Adding Laurentiu to the chain who has been looking
>> into this issue.
> 
> Yes, I'm closely following the issue. I actually have a workaround 
> (attached) but haven't submitted as it will probably raise a lot of 
> eyebrows. In the mean time I'm following some discussions [1][2][3] on 
> the iommu list which seem to try to tackle what appears to be a similar 
> issue but with framebuffers. My hope is that we will be able to leverage 
> whatever turns out.

Indeed it's more general than framebuffers - in fact there was a 
specific requirement from the IORT side to accommodate network/storage 
controllers with in-memory firmware/configuration data/whatever set up 
by the bootloader that want to be handed off 'live' to Linux because the 
overhead of stopping and restarting them is impractical. Thus this DPAA2 
setup is very much within scope of the desired solution, so please feel 
free to join in (particularly on the DT parts) :)

As for right now, note that your patch would only be a partial 
mitigation to slightly reduce the fault window but not remove it 
entirely. To be robust the SMMU driver *has* to know about live streams 
before the first arm_smmu_reset() - hence the need for generic firmware 
bindings - so doing anything from the MC driver is already too late (and 
indeed the current iommu_request_dm_for_dev() mechanism is itself a 
microcosm of the same problem).

> In the mean time, can you try the workaround Leo suggested?

Agreed, I'd imagine the command-line option is probably the best choice 
for these platforms, since it's likely to be easier to set that by 
default in the bootloader than faff with rebuilding generic kernel configs.

Robin.

> [1] https://patchwork.kernel.org/patch/11327667/
> [2] https://patchwork.kernel.org/patch/10967729/
> [3] https://patchwork.kernel.org/cover/11279577/
> 
> ---
> Best Regards, Laurentiu
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
> 

  reply	other threads:[~2020-02-11 13:04 UTC|newest]

Thread overview: 64+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-11-20  3:45 [PATCHv9 00/12] PCI: Recode Mobiveil driver and add PCIe Gen4 driver for NXP Layerscape SoCs Z.q. Hou
2019-11-20  3:45 ` [PATCHv9 01/12] PCI: mobiveil: Re-abstract the private structure Z.q. Hou
2020-01-13 10:09   ` Andrew Murray
2020-02-06 11:04     ` Z.q. Hou
2020-02-06 11:27       ` Andrew Murray
2019-11-20  3:45 ` [PATCHv9 02/12] PCI: mobiveil: Move the host initialization into a routine Z.q. Hou
2020-01-13 10:19   ` Andrew Murray
2020-02-06 11:14     ` Z.q. Hou
2019-11-20  3:45 ` [PATCHv9 03/12] PCI: mobiveil: Collect the interrupt related operations " Z.q. Hou
2020-01-13 10:34   ` Andrew Murray
2020-02-06 11:30     ` Z.q. Hou
2019-11-20  3:45 ` [PATCHv9 04/12] PCI: mobiveil: Modularize the Mobiveil PCIe Host Bridge IP driver Z.q. Hou
2020-01-13 11:05   ` Andrew Murray
2020-02-06 12:25     ` Z.q. Hou
2019-11-20  3:45 ` [PATCHv9 05/12] PCI: mobiveil: Add callback function for interrupt initialization Z.q. Hou
2020-01-13 11:19   ` Andrew Murray
2020-02-06 13:25     ` Z.q. Hou
2019-11-20  3:45 ` [PATCHv9 06/12] PCI: mobiveil: Add callback function for link up check Z.q. Hou
2020-01-13 11:22   ` Andrew Murray
2020-02-06 13:25     ` Z.q. Hou
2019-11-20  3:46 ` [PATCHv9 07/12] PCI: mobiveil: Make mobiveil_host_init() can be used to re-init host Z.q. Hou
2020-01-13 11:26   ` Andrew Murray
2020-02-06 13:27     ` Z.q. Hou
2019-11-20  3:46 ` [PATCHv9 08/12] PCI: mobiveil: Add 8-bit and 16-bit CSR register accessors Z.q. Hou
2020-01-13 11:31   ` Andrew Murray
2020-02-06 13:45     ` Z.q. Hou
2019-11-20  3:46 ` [PATCHv9 09/12] dt-bindings: PCI: Add NXP Layerscape SoCs PCIe Gen4 controller Z.q. Hou
2019-11-20  3:46 ` [PATCHv9 10/12] PCI: mobiveil: Add PCIe Gen4 RC driver for NXP Layerscape SoCs Z.q. Hou
2020-01-13 12:02   ` Andrew Murray
2020-02-06 13:45     ` Z.q. Hou
2020-02-06 14:29       ` Andrew Murray
2019-11-20  3:46 ` [PATCHv9 11/12] arm64: dts: lx2160a: Add PCIe controller DT nodes Z.q. Hou
2019-11-20  3:46 ` [PATCHv9 12/12] arm64: defconfig: Enable CONFIG_PCIE_LAYERSCAPE_GEN4 Z.q. Hou
2019-11-20  9:57 ` [PATCHv9 00/12] PCI: Recode Mobiveil driver and add PCIe Gen4 driver for NXP Layerscape SoCs Russell King - ARM Linux admin
2019-11-20 10:30   ` Z.q. Hou
2019-12-13 18:37 ` Olof Johansson
2019-12-17  2:50   ` Z.q. Hou
2020-01-10 15:33     ` Lorenzo Pieralisi
2020-01-10 17:05       ` Olof Johansson
2020-02-06 10:57         ` Z.q. Hou
2020-02-10 15:12           ` Olof Johansson
2020-02-10 15:22             ` Russell King - ARM Linux admin
2020-02-10 15:28               ` Olof Johansson
2020-02-10 16:15                 ` Russell King - ARM Linux admin
2020-02-10 17:20                   ` Russell King - ARM Linux admin
2020-02-10 18:33                   ` Olof Johansson
2020-02-10 18:41                 ` Li Yang
2020-02-10 19:48                   ` Li Yang
2020-02-11 12:13                   ` Laurentiu Tudor
2020-02-11 13:04                     ` Robin Murphy [this message]
2020-02-11 13:55                       ` Laurentiu Tudor
2020-02-11 14:51                         ` Robin Murphy
2020-02-11 14:48                       ` Olof Johansson
2020-02-11 15:14                         ` Laurentiu Tudor
2020-02-29  9:55               ` Russell King - ARM Linux admin
2020-02-29 11:04                 ` Russell King - ARM Linux admin
2020-02-29 12:08                   ` Russell King - ARM Linux admin
2020-02-29 13:32                     ` Russell King - ARM Linux admin
2020-02-29 15:19                   ` Theodore Y. Ts'o
2020-02-29 17:03                     ` Russell King - ARM Linux admin
2020-02-29 18:03                       ` Theodore Y. Ts'o
2020-06-05 23:53                   ` Russell King - ARM Linux admin
2020-06-06 10:19                     ` Russell King - ARM Linux admin
2020-02-10 15:33             ` Lorenzo Pieralisi

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=aec47903-50e4-c61b-6aec-63e3e9bc9332@arm.com \
    --to=robin.murphy@arm.com \
    --cc=andrew.murray@arm.com \
    --cc=arnd@arndb.de \
    --cc=bhelgaas@google.com \
    --cc=catalin.marinas@arm.com \
    --cc=devicetree@vger.kernel.org \
    --cc=l.subrahmanya@mobiveil.co.in \
    --cc=laurentiu.tudor@nxp.com \
    --cc=leoyang.li@nxp.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-pci@vger.kernel.org \
    --cc=linux@armlinux.org.uk \
    --cc=lorenzo.pieralisi@arm.com \
    --cc=m.karthikeyan@mobiveil.co.in \
    --cc=mark.rutland@arm.com \
    --cc=minghuan.lian@nxp.com \
    --cc=mingkai.hu@nxp.com \
    --cc=olof@lixom.net \
    --cc=robh+dt@kernel.org \
    --cc=shawnguo@kernel.org \
    --cc=will.deacon@arm.com \
    --cc=xiaowei.bao@nxp.com \
    --cc=zhiqiang.hou@nxp.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).