Re: pcieport bug?

[Randy Dunlap <rdunlap@infradead.org>]

[adding linux-pci mailing list]


On 8/29/22 10:59, Steven J Abner wrote:
> Hi
> Building a kernel tailored for AMD 2400g on ASRock B450 using 5.18.12 as base, OS
> is Elementary 6.1 on top of Ubuntu 20.04.5.
> In a config I changed some which lead to this query,'cause not sure what it means.
> So up to you see if it is of concern. Notation igpu# refers to build sequence tests.
> Also note that pcieport may affect other drivers?
> 
> config differences
> igpu33
> # CONFIG_PCIEPORTBUS is not set
> # CONFIG_PCI_IOV is not set
> # CONFIG_VGA_ARB is not set
> # CONFIG_HOTPLUG_PCI is not set
> igpu32
> CONFIG_PCIEPORTBUS=y
> CONFIG_HOTPLUG_PCI_PCIE=y
> CONFIG_PCIEAER=y
> # CONFIG_PCIEAER_INJECT is not set
> # CONFIG_PCIE_ECRC is not set
> CONFIG_PCIE_PME=y
> CONFIG_PCIE_DPC=y
> # CONFIG_PCIE_EDR is not set
> CONFIG_PCI_REALLOC_ENABLE_AUTO=y
> # CONFIG_PCI_PF_STUB is not set
> CONFIG_PCI_IOV=y
> CONFIG_VGA_ARB=y
> CONFIG_VGA_ARB_MAX_GPUS=16
> CONFIG_HOTPLUG_PCI=y
> CONFIG_HOTPLUG_PCI_ACPI=y
> # CONFIG_HOTPLUG_PCI_ACPI_IBM is not set
> CONFIG_HOTPLUG_PCI_CPCI=y
> # CONFIG_HOTPLUG_PCI_CPCI_ZT5550 is not set
> # CONFIG_HOTPLUG_PCI_CPCI_GENERIC is not set
> CONFIG_HOTPLUG_PCI_SHPC=y
> # CONFIG_RAPIDIO_TSI721 is not set
> # CONFIG_EEEPC_LAPTOP is not set
> 
> lspci differences:
> start with identical:
> 00:00.0 Host bridge
> 00:00.2 IOMMU
> 00:01.0 Host bridge
> 
> kernel builds after igpu33 stable flags, only irq differences
> kernel builds upto igpu32 flags differ including non-pcieport drivers,
> there was a few builds where flags matched out of 32 different builds
> I thought was normal that flags changed prior to 33-37 being very stable.
> 
> under 00:01.1 PCI bridge:
> igpu33
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
> DevCtl: CorrErr- NonFatalErr- FatalErr- UnsupReq-
> RootCtl: ErrCorrectable- ErrNon-Fatal- ErrFatal- PMEIntEna- CRSVisible+
> Capabilities: [a0] MSI: Enable- Count=1/1 Maskable- 64bit+
>  Address: 0000000000000000 Data: 0000
> RootCmd: CERptEn- NFERptEn- FERptEn-
> 
> igpu32
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
> Interrupt: pin ? routed to IRQ 26
> DevCtl: CorrErr+ NonFatalErr+ FatalErr+ UnsupReq+
> RootCtl: ErrCorrectable- ErrNon-Fatal- ErrFatal- PMEIntEna+ CRSVisible+
> Capabilities: [a0] MSI: Enable+ Count=1/1 Maskable- 64bit+
>  Address: 00000000fee00000 Data: 0000
> RootCmd: CERptEn+ NFERptEn+ FERptEn+
> Kernel driver in use: pcieport
> 
> under these, nearly same readout as above (32vs33 use of pcieport)
> 00:01.6 PCI bridge
> 00:08.1 PCI bridge
> 00:08.2 PCI bridge
> 11:01.0 PCI bridge
> 11:02.0 PCI bridge
> 15:00.2 PCI bridge
> 1d:00.0 PCI bridge
> 1d:01.0 PCI bridge
> 1d:04.0 PCI bridge
> 1d:05.0 PCI bridge
> 1d:06.0 PCI bridge
> 1d:07.0 PCI bridge
> 
> on non-pcieport drivers minor differences in +- states
> on nvme added line:
> Physical Slot: 0
> but +- state can change like others
> 
> dmesg differences (alphabetical):
> igu33
> acpi PNP0A08:00: PCIe port services disabled; not requesting _OSC control
> igpu32
> acpiphp: ACPI Hot Plug PCI Controller Driver version: 0.5
> acpi PNP0A08:00: _OSC: OS now controls [PCIeHotplug PME AER PCIeCapability]
> acpi PNP0A08:00: _OSC: platform does not support [SHPCHotplug LTR]
> amdgpu 0000:38:00.0: vgaarb: deactivate vga console
> pci 0000:38:00.0: vgaarb: bridge control possible
> pci 0000:38:00.0: vgaarb: setting as boot VGA device
> pci 0000:38:00.0: vgaarb: VGA device added: decodes=io+mem,owns=none,locks=none
> pcieport 0000:00:01.1: AER: enabled with IRQ 26
> pcieport 0000:00:01.1: PME: Signaling with IRQ 26
> pcieport 0000:00:01.2: AER: enabled with IRQ 27
> pcieport 0000:00:01.2: PME: Signaling with IRQ 27
> pcieport 0000:00:01.6: AER: enabled with IRQ 28
> pcieport 0000:00:01.6: pciehp: Slot #0 AttnBtn- PwrCtrl- MRL- AttnInd- PwrInd- HotPlug+ Surprise- Interlock- NoCompl+ IbPresDis- LLActRep+
> pcieport 0000:00:01.6: PME: Signaling with IRQ 28
> pcieport 0000:00:08.1: PME: Signaling with IRQ 29
> pcieport 0000:00:08.2: PME: Signaling with IRQ 30
> shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
> vgaarb: loaded
> 
> Steve
> 
> I wish to be personally CC'ed the answers/comments posted to the list
> in response to your posting, please.
> 
> 
> 
> 
> 
> 

-- 
~Randy