Re: [PATCH V2 8/8] qcom-geni-se: remove has_opp_table

[Viresh Kumar <viresh.kumar@linaro.org>]

On 28-08-20, 11:37, Viresh Kumar wrote:
> has_opp_table isn't used anymore, remove it.
> 
> Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org>
> 
> ---
> V2: No changes.
> ---
>  include/linux/qcom-geni-se.h | 2 --
>  1 file changed, 2 deletions(-)
> 
> diff --git a/include/linux/qcom-geni-se.h b/include/linux/qcom-geni-se.h
> index 8f385fbe5a0e..02d1417c8ecf 100644
> --- a/include/linux/qcom-geni-se.h
> +++ b/include/linux/qcom-geni-se.h
> @@ -48,7 +48,6 @@ struct geni_icc_path {
>   * @clk_perf_tbl:	Table of clock frequency input to serial engine clock
>   * @icc_paths:		Array of ICC paths for SE
>   * @opp_table:		Pointer to the OPP table
> - * @has_opp_table:	Specifies if the SE has an OPP table
>   */
>  struct geni_se {
>  	void __iomem *base;
> @@ -59,7 +58,6 @@ struct geni_se {
>  	unsigned long *clk_perf_tbl;
>  	struct geni_icc_path icc_paths[3];
>  	struct opp_table *opp_table;
> -	bool has_opp_table;
>  };
>  
>  /* Common SE registers */

Rajendra,

This patch depended on following patches which are part of Linus's master now:

7d568edff5cb spi: spi-geni-qcom: Unconditionally call dev_pm_opp_of_remove_table()
c7ac46dac744 tty: serial: qcom_geni_serial: Unconditionally call dev_pm_opp_of_remove_table()

Who is going to merge this one ? Should I ask Greg or you can take it ?

-- 
viresh