Linux-Renesas-SoC Archive on lore.kernel.org
 help / color / Atom feed
From: "Niklas Söderlund" <niklas.soderlund@ragnatech.se>
To: Suresh Udipi <sudipi@jp.adit-jv.com>
Cc: mrodin@de.adit-jv.com, akiyama@nds-osk.co.jp,
	efriedrich@de.adit-jv.com, erosca@de.adit-jv.com,
	linux-kernel@vger.kernel.org, linux-media@vger.kernel.org,
	linux-renesas-soc@vger.kernel.org, mchehab@kernel.org,
	michael@rodin.online, securitycheck@denso.co.jp
Subject: Re: [PATCH v8 2/3] media: rcar-csi2: Add warning for PHY speed less than minimum
Date: Wed, 1 Jul 2020 00:05:02 +0200
Message-ID: <20200630220502.GK2365286@oden.dyn.berto.se> (raw)
In-Reply-To: <1592476472-26235-2-git-send-email-sudipi@jp.adit-jv.com>

Hi Suresh,

Thanks for your patch.

On 2020-06-18 19:34:31 +0900, Suresh Udipi wrote:
> Add a warning message when the selected PHY speed is less
> than supported minimum PHY speed given in the hsfreq table[1].
> 
> For raspberry pi camera capture on Kingfisher board with resolution
> 640x480, the calculated PHY speed is 48 mbps which is less than
> the minimum PHY speed 80 Mbps from the table[1]. But in this cases
> capture is successful.
> 
> [1] specs r19uh0105ej0200-r-car-3rd-generation.pdf [Table 25.9]
> 
> Signed-off-by: Suresh Udipi <sudipi@jp.adit-jv.com>
> Signed-off-by: Michael Rodin <mrodin@de.adit-jv.com>

Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>

> ---
>  drivers/media/platform/rcar-vin/rcar-csi2.c | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/drivers/media/platform/rcar-vin/rcar-csi2.c b/drivers/media/platform/rcar-vin/rcar-csi2.c
> index f18dedc..1184527 100644
> --- a/drivers/media/platform/rcar-vin/rcar-csi2.c
> +++ b/drivers/media/platform/rcar-vin/rcar-csi2.c
> @@ -433,6 +433,10 @@ static int rcsi2_set_phypll(struct rcar_csi2 *priv, unsigned int mbps)
>  	const struct rcsi2_mbps_reg *hsfreq;
>  	const struct rcsi2_mbps_reg *hsfreq_prev = NULL;
>  
> +	if (mbps < priv->info->hsfreqrange->mbps)
> +		dev_warn(priv->dev, "%u Mbps less than min PHY speed %u Mbps",
> +			 mbps, priv->info->hsfreqrange->mbps);
> +
>  	for (hsfreq = priv->info->hsfreqrange; hsfreq->mbps != 0; hsfreq++) {
>  		if (hsfreq->mbps >= mbps)
>  			break;
> -- 
> 2.7.4
> 

-- 
Regards,
Niklas Söderlund

  reply index

Thread overview: 34+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-02-20  4:49 [PATCH] [RFC] media: rcar-csi2: Corrects the selection of hsfreqrange Suresh Udipi
2020-03-04 19:46 ` Niklas Söderlund
2020-03-16 13:02   ` Niklas Söderlund
2020-03-17  7:08     ` [PATCH v2] [RFC] rcar-vin: rcar-csi2: Correct " Suresh Udipi
2020-03-17 10:37       ` Niklas Söderlund
2020-03-18  9:00         ` Suresh Udipi
2020-03-18 10:19           ` Niklas Söderlund
2020-03-20  8:00             ` [PATCH v3] media: " Suresh Udipi
2020-03-23  4:48               ` [PATCH v4] " Suresh Udipi
2020-04-14 11:56                 ` Niklas Söderlund
2020-04-30  6:03                   ` [PATCH v5] " Suresh Udipi
2020-05-04 15:01                     ` Michael Rodin
2020-05-12 21:30                       ` Niklas Söderlund
2020-05-27 15:47                         ` Michael Rodin
2020-05-27 16:16                         ` [PATCH] rcar-vin: " Michael Rodin
2020-06-05 18:44                           ` Michael Rodin
2020-06-08  3:25                             ` [PATCH v6] media: " Suresh Udipi
2020-06-10 13:40                               ` Niklas Söderlund
2020-06-12  3:10                                 ` Suresh Udipi
2020-06-12 17:28                                   ` Michael Rodin
2020-06-15 14:11                                     ` Niklas Söderlund
2020-06-17  4:57                                       ` [PATCH v7 1/2] " Suresh Udipi
2020-06-17  4:57                                         ` [PATCH v7 2/2] media: rcar-csi2: Add warning for PHY speed less than minimum Suresh Udipi
2020-06-17 13:37                                         ` [PATCH v7 1/2] media: rcar-csi2: Correct the selection of hsfreqrange Michael Rodin
2020-06-18 10:34                                           ` [PATCH v8 1/3] " Suresh Udipi
2020-06-18 10:34                                             ` [PATCH v8 2/3] media: rcar-csi2: Add warning for PHY speed less than minimum Suresh Udipi
2020-06-30 22:05                                               ` Niklas Söderlund [this message]
2020-06-18 10:34                                             ` [PATCH v8 3/3] media: rcar-csi2: Optimize the selection PHTW register Suresh Udipi
2020-06-30 22:08                                               ` Niklas Söderlund
2020-07-01  9:52                                                 ` [PATCH v9 1/3] media: rcar-csi2: Correct the selection of hsfreqrange Suresh Udipi
2020-07-01  9:53                                                   ` [PATCH v9 2/3] media: rcar-csi2: Add warning for PHY speed less than minimum Suresh Udipi
2020-07-01  9:53                                                   ` [PATCH v9 3/3] media: rcar-csi2: Optimize the selection PHTW register Suresh Udipi
2020-06-30 22:03                                             ` [PATCH v8 1/3] media: rcar-csi2: Correct the selection of hsfreqrange Niklas Söderlund
2020-05-27 16:17                         ` [PATCH] rcar-vin: rcar-csi2: Select the correct PHTW register Michael Rodin

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200630220502.GK2365286@oden.dyn.berto.se \
    --to=niklas.soderlund@ragnatech.se \
    --cc=akiyama@nds-osk.co.jp \
    --cc=efriedrich@de.adit-jv.com \
    --cc=erosca@de.adit-jv.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-media@vger.kernel.org \
    --cc=linux-renesas-soc@vger.kernel.org \
    --cc=mchehab@kernel.org \
    --cc=michael@rodin.online \
    --cc=mrodin@de.adit-jv.com \
    --cc=securitycheck@denso.co.jp \
    --cc=sudipi@jp.adit-jv.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-Renesas-SoC Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-renesas-soc/0 linux-renesas-soc/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-renesas-soc linux-renesas-soc/ https://lore.kernel.org/linux-renesas-soc \
		linux-renesas-soc@vger.kernel.org
	public-inbox-index linux-renesas-soc

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-renesas-soc


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git