messages from 2019-01-21 11:21:42 to 2019-02-12 14:29:47 UTC [more...]
[RFC PATCH v1 00/25] printk: new implementation
2019-02-12 14:29 UTC (10+ messages)
` [RFC PATCH v1 01/25] printk-rb: add printk ring buffer documentation
` [RFC PATCH v1 02/25] printk-rb: add prb locking functions
` [RFC PATCH v1 03/25] printk-rb: define ring buffer struct and initializer
` [RFC PATCH v1 04/25] printk-rb: add writer interface
` [RFC PATCH v1 05/25] printk-rb: add basic non-blocking reading interface
` [RFC PATCH v1 06/25] printk-rb: add blocking reader support
` [RFC PATCH v1 07/25] printk-rb: add functionality required by printk
` [RFC PATCH v1 08/25] printk: add ring buffer and kthread
` [RFC PATCH v1 09/25] printk: remove exclusive console hack
RFC: drop ISA support in the synlink tty driver?
2019-02-12 8:40 UTC (6+ messages)
` [PATCH] tty/synclink: remove ISA support
[PATCH] tty: serial: qcom_geni_serial: Allow mctrl when flow control is disabled
2019-02-12 0:03 UTC (3+ messages)
[PATCH v6 0/6] Add basic and clock support for Mediatek MT8183 SoC
2019-02-11 13:01 UTC (24+ messages)
` [PATCH v6 1/6] irqchip/mtk-sysirq: support 4 interrupt parameters for sysirq
` [PATCH v6 2/6] dt-bindings: arm: Add bindings for Mediatek MT8183 SoC Platform
` [PATCH v6 3/6] dt-bindings: mtk-sysirq: Add compatible for Mediatek MT8183
` [PATCH v6 4/6] dt-bindings: serial: "
` [PATCH v6 5/6] dt-bindings: pinctrl: mt8183: add binding document
` [PATCH v6 6/6] arm64: dts: Add Mediatek SoC MT8183 and evaluation board dts and Makefile
[GIT PULL] TTY/Serial fixes for 5.0-rc6
2019-02-08 19:45 UTC (2+ messages)
[PATCH v2 10/15] serial: Add Milbeaut serial control
2019-02-08 12:27 UTC
[PATCH v2 09/15] dt-bindings: serial: Add Milbeaut serial driver description
2019-02-08 12:27 UTC
[PATCH v2 00/15] Add basic support for Socionext Milbeaut M10V SoC
2019-02-08 12:24 UTC
[RFC/PATCH 0/5] DVFS in the OPP core
2019-02-08 10:33 UTC (22+ messages)
` [RFC/PATCH 1/5] OPP: Don't overwrite rounded clk rate
` [RFC/PATCH 2/5] OPP: Make dev_pm_opp_set_rate() with freq=0 as valid
` [RFC/PATCH 3/5] tty: serial: qcom_geni_serial: Use OPP API to set clk/perf state
` [RFC/PATCH 4/5] spi: spi-geni-qcom: "
` [RFC/PATCH 5/5] arm64: dts: sdm845: Add OPP table for all qup devices
[PATCH v2] tty: serial: meson_uart: Add support for kernel debugger
2019-02-07 17:11 UTC
[PATCH] tty: serial: meson_uart: Add support for kernel debugger
2019-02-07 17:04 UTC (3+ messages)
[PATCH 1/2] tty: serial: meson_uart: Add support for kernel debugger
2019-02-07 11:26 UTC
[PATCH] serial: uartps: Fix stuck ISR if RX disabled with non-empty FIFO
2019-02-06 14:08 UTC
[PATCH v10 0/3] add uart DMA function
2019-02-04 7:21 UTC (6+ messages)
` [PATCH v10 1/3] dmaengine: 8250_mtk_dma: add MediaTek uart DMA support
` [PATCH v10 3/3] dt-bindings: dma: uart: rename binding
[PATCH 3.16 165/305] arch/alpha, termios: implement BOTHER, IBSHIFT and termios2
2019-02-03 13:45 UTC
[PATCH 1/2] tty: serial: meson_uart: Add support for kernel debugger
2019-02-01 7:36 UTC
[PATCH 0/3] serdev support for n_gsm
2019-01-31 23:34 UTC (7+ messages)
[PATCH] tty: Fix WARNING in tty_set_termios
2019-01-31 23:23 UTC (8+ messages)
[PATCH][V5] tty: fix race between flush_to_ldisc and tty_open
2019-01-31 18:44 UTC (4+ messages)
` 答复: "
[PATCH] serial: mps2-uart: Add parentheses around conditional in mps2_uart_shutdown
2019-01-31 18:21 UTC (3+ messages)
答复: [PATCH][v4] tty: fix race between flush_to_ldisc and tty_open
2019-01-31 7:40 UTC (5+ messages)
` 答复: "
` 答复: "
[PATCH 0/6] Add interconnect support for GENI QUPs
2019-01-30 22:29 UTC (28+ messages)
` [PATCH 1/6] dt-bindings: soc: qcom: Add interconnect binding for GENI QUP
` [PATCH 2/6] soc: qcom: Add wrapper to support for Interconnect path
` [PATCH 3/6] i2c: i2c-qcom-geni: Add interconnect support
` [PATCH 4/6] spi: spi-geni-qcom: "
` [PATCH 5/6] tty: serial: qcom_geni_serial: "
` [PATCH 6/6] arm64: dts: sdm845: Add interconnect for GENI QUP
Add Ingenic X1000 serial support
2019-01-30 18:46 UTC (15+ messages)
` [PATCH 1/2] Serial: Ingenic: Add support for the X1000
` [PATCH 2/2] "
` Serial: Ingenic: Add X1000 suppor for the UART driver
` [PATCH v2 1/2] "
` [PATCH v2 2/2] "
` [PATCH v3 1/2] Serial: Ingenic: Add support for the X1000
` [PATCH v3 2/2] Dt-bindings: Serial: Add X1000 serial bindings
[PATCH v2 0/2] serial: mps2-uart: minor improvements
2019-01-30 9:55 UTC (3+ messages)
` [PATCH v2 1/2] serial: mps2-uart: move to dynamic port allocation
` [PATCH v2 2/2] serial: mps2-uart: support combined irq
[PATCH] serdev: ttyport: call tiocmget and tiocmset ops directly
2019-01-30 9:52 UTC
[PATCH 0/2] serial: mps2-uart: minor improvements
2019-01-30 9:33 UTC (8+ messages)
` [PATCH 1/2] serial: mps2-uart: move to dynamic port allocation
` [PATCH 2/2] serial: mps2-uart: support combined tx and rx irq
[PATCH 00/14] Add basic support for Socionext Milbeaut M10V SoCs
2019-01-30 8:40 UTC (13+ messages)
` [PATCH 02/14] dt-bindings: soc: milbeaut: Add Milbeaut trampoline description
[PATCH] tty: ldisc: add sysctl to prevent autoloading of ldiscs
2019-01-30 8:28 UTC (3+ messages)
[PATCH AUTOSEL 3.18 08/61] serial: fsl_lpuart: clear parity enable bit when disable parity
2019-01-28 16:25 UTC (2+ messages)
` [PATCH AUTOSEL 3.18 34/61] tty: serial: samsung: Properly set flags in autoCTS mode
[PATCH AUTOSEL 4.4 11/80] serial: fsl_lpuart: clear parity enable bit when disable parity
2019-01-28 16:23 UTC (2+ messages)
` [PATCH AUTOSEL 4.4 45/80] tty: serial: samsung: Properly set flags in autoCTS mode
[PATCH AUTOSEL 4.9 013/107] serial: fsl_lpuart: clear parity enable bit when disable parity
2019-01-28 16:18 UTC (2+ messages)
` [PATCH AUTOSEL 4.9 059/107] tty: serial: samsung: Properly set flags in autoCTS mode
[PATCH AUTOSEL 4.14 020/170] serial: fsl_lpuart: clear parity enable bit when disable parity
2019-01-28 16:10 UTC (2+ messages)
` [PATCH AUTOSEL 4.14 105/170] tty: serial: samsung: Properly set flags in autoCTS mode
[PATCH AUTOSEL 4.19 028/258] serial: fsl_lpuart: clear parity enable bit when disable parity
2019-01-28 15:57 UTC (4+ messages)
` [PATCH AUTOSEL 4.19 162/258] serial: sh-sci: Fix locking in sci_submit_rx()
` [PATCH AUTOSEL 4.19 163/258] serial: sh-sci: Resume PIO in sci_rx_interrupt() on DMA failure
` [PATCH AUTOSEL 4.19 164/258] tty: serial: samsung: Properly set flags in autoCTS mode
[PATCH AUTOSEL 4.20 034/304] serial: fsl_lpuart: clear parity enable bit when disable parity
2019-01-28 15:41 UTC (4+ messages)
` [PATCH AUTOSEL 4.20 193/304] serial: sh-sci: Fix locking in sci_submit_rx()
` [PATCH AUTOSEL 4.20 194/304] serial: sh-sci: Resume PIO in sci_rx_interrupt() on DMA failure
` [PATCH AUTOSEL 4.20 195/304] tty: serial: samsung: Properly set flags in autoCTS mode
[PATCH] 8250_pci.c: Update NI specific devices class to multi serial
2019-01-28 8:04 UTC (7+ messages)
[GIT PULL] TTY/Serial fixes for 5.0-rc4
2019-01-25 23:20 UTC (2+ messages)
[PATCH] 8250_pci.c: Update NI specific devices class to multi serial
2019-01-24 7:07 UTC
[PATCH] tty/serial: use uart_console_write in the RISC-V SBL early console
2019-01-23 23:58 UTC (2+ messages)
[PATCH 2/6] soc: qcom: Add wrapper to support for Interconnect path
2019-01-23 6:49 UTC
[PATCH] tty: serial: lpc32xx_hs: fix missing console boot messages
2019-01-22 22:38 UTC (2+ messages)
[PATCH] tty: serial: 8250_mtk: Fix potential NULL pointer dereference
2019-01-22 19:57 UTC
[PATCH v2] 8250_pci.c: Update NI specific devices class to multi serial
2019-01-22 9:19 UTC
[PATCH 0/3] 8250_omap: use clk APIs to get fclk freqeuncy
2019-01-21 21:08 UTC (3+ messages)
` [PATCH 2/3] dt-bindings: serial: omap_serial: add clocks entry
[BUG] tiocsti() NULL dereference if ld->ops->receive_buf==NULL
2019-01-21 16:14 UTC (3+ messages)
[PATCH 5/6] tty: serial: qcom_geni_serial: Add interconnect support
2019-01-21 11:21 UTC
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).