messages from 2019-04-27 13:30:50 to 2019-05-23 07:35:09 UTC [more...]
[PATCH v13 0/2] add uart DMA function
2019-05-23 7:35 UTC (3+ messages)
` [PATCH v13 1/2] arm: dts: mt2712: add uart APDMA to device tree
` [PATCH 2/2] serial: 8250-mtk: modify uart DMA rx
[PATCH 0/6] arm64: Initial support Texas Instrument's J721E Platform
2019-05-22 16:19 UTC (7+ messages)
` [PATCH 1/6] dt-bindings: arm: ti: Add bindings for J721E SoC
` [PATCH 2/6] dt-bindings: serial: 8250_omap: Add compatible for J721E UART controller
` [PATCH 3/6] arm64: dts: ti: Add Support for J721E SoC
` [PATCH 4/6] soc: ti: Add Support for J721E SoC config option
` [PATCH 5/6] arm64: dts: ti: Add support for J721E Common Processor Board
` [PATCH 6/6] arm64: defconfig: Enable TI's J721E SoC platform
[PATCH] tty: serial: cpm_uart - fix init when SMC is relocated
2019-05-22 12:17 UTC
[PATCH 1/2] serial: mctrl_gpio: Check if GPIO property exisits before requesting it
2019-05-22 12:11 UTC (2+ messages)
` [PATCH 2/2] tty/serial/8250: use mctrl_gpio helpers
[PATCH v12 0/4] add uart DMA function
2019-05-22 5:24 UTC (11+ messages)
` [PATCH 1/4] dmaengine: mediatek: Add MediaTek UART APDMA support
` [PATCH 3/4] dt-bindings: dma: uart: rename binding
` [PATCH 4/4] serial: 8250-mtk: modify uart DMA rx
[PATCH] serial: 8250: Add support for using platform_device resources
2019-05-21 17:03 UTC (34+ messages)
` [PATCH resend] "
[PATCH 0/7] usart various fixes for STM32
2019-05-21 15:45 UTC (8+ messages)
` [PATCH 1/7] serial: stm32: fix word length configuration
` [PATCH 2/7] serial: stm32: fix rx error handling
` [PATCH 3/7] serial: stm32: fix rx data length when parity enabled
` [PATCH 4/7] serial: stm32: fix transmit_chars when tx is stopped
` [PATCH 5/7] serial: stm32: Add support of TC bit status check
` [PATCH 6/7] serial: stm32: fix wakeup source initialization
` [PATCH 7/7] serial: stm32: fix the get_irq error case
[PATCH] tracing: fix typos in code and comments
2019-05-21 14:59 UTC (3+ messages)
[PATCH 0/2] serial: 8250: Add support for 8250/16550 as MFD function
2019-05-21 14:43 UTC (30+ messages)
` [PATCH 1/2] serial: 8250: Allow port registration without UPF_BOOT_AUTOCONF
` [PATCH 2/2] serial: 8250: Add support for 8250/16550 as MFD function
[PATCH v2] tty: serial: msm_serial: Fix XON/XOFF
2019-05-21 10:31 UTC (5+ messages)
[PATCH 0/7] tty: max310x: Simplify the code and fix a few bugs
2019-05-21 10:17 UTC (9+ messages)
` [PATCH 1/7] tty: max310x: Simplify tx-work item code
` [PATCH 2/7] tty: max310x: Introduce max310x_one port macro-wrapper
` [PATCH 3/7] tty: max310x: Don't pass stacked buffers to SPI
` [PATCH 4/7] tty: max310x: Fix invalid baudrate divisors calculator
` [PATCH 5/7] tty: max310x: Add rx-during-tx rs485 flag support
` [PATCH 6/7] tty: max310x: Optionally enable rs485 on startup
` [PATCH 7/7] tty: max310x: Split uart characters insertion loop
[PATCH] serial-uartlite: Fix null-ptr-deref in ulite_exit
2019-05-21 10:10 UTC (4+ messages)
[PATCH 0/2] support 8250-mtk uart in-band wake up
2019-05-21 9:44 UTC (4+ messages)
` [PATCH 1/2] dt-bindings: serial: add documentation for Rx in-band wakeup support
` [PATCH 2/2] uart: mediatek: support Rx in-band wakeup
[RFC v2 00/11] DVFS in the OPP core
2019-05-21 6:22 UTC (4+ messages)
` [RFC v2 08/11] arm64: dts: sdm845: Add ufs opps and power-domains
[PATCH] tty: serial: msm_serial: Fix XON/XOFF
2019-05-20 15:20 UTC (9+ messages)
[PATCH] tty: serial_core: Fix the incorrect configuration of baud rate and data length at the console serial port resume
2019-05-15 9:15 UTC (3+ messages)
[PATCH v3] serial: sh-sci: disable DMA for uart_console
2019-05-15 3:29 UTC
[PATCH v2] serial: sh-sci: disable DMA for uart_console
2019-05-14 16:16 UTC (5+ messages)
[PATCH v2 0/4] Use MFD framework for SGI IOC3 drivers
2019-05-14 14:29 UTC (7+ messages)
` [PATCH v2 2/4] mfd: ioc3: Add driver for SGI IOC3 chip
[PATCH] tty: serial: uartlite: avoid null pointer dereference during rmmod
2019-05-14 7:08 UTC (2+ messages)
[PATCH] serial: sh-sci: disable DMA for uart_console
2019-05-13 15:43 UTC (7+ messages)
[PATCH] tty: amba-pl011: allow shared interrupt
2019-05-09 21:11 UTC
[GIT PULL] TTY/Serial patches for 5.2-rc1
2019-05-08 18:30 UTC (2+ messages)
serial: Add Milbeaut serial control
2019-05-08 12:55 UTC (2+ messages)
[PATCH v3] serial: Add Milbeaut serial control
2019-05-08 12:22 UTC (3+ messages)
[PATCH] tty: serial_core: Set port active bit in uart_port_activate
2019-05-08 10:44 UTC
[PATCH v5 0/2] tty: serial: add DT bindings and serial driver for the SiFive FU540 UART
2019-05-03 19:05 UTC (11+ messages)
` [PATCH v5 2/2] tty: serial: add driver for the SiFive UART
cpu power up timing changes causes UART rx character loss on imx6ull
2019-05-02 11:31 UTC
[PATCH] PM / core: Propagate dev->power.wakeup_path when no callbacks
2019-05-01 10:21 UTC (2+ messages)
serial drivers polishing
2019-05-01 2:29 UTC (60+ messages)
` [PATCH 01/41] drivers: tty: serial: dz: use dev_err() instead of printk()
` [PATCH 05/41] drivers: tty: serial: dz: use pr_info() instead of incomplete printk()
` [PATCH 06/41] drivers: tty: serial: sb1250-duart: use dev_err() instead of printk()
` [PATCH 10/41] drivers: tty: serial: sb1250-duart: fix missing parentheses
` [PATCH 12/41] drivers: tty: serial: uartlite: use dev_dbg() instead of pr_debug()
` [PATCH 13/41] drivers: tty: serial: uartlite: fill mapsize and use it
` [PATCH 14/41] drivers: tty: serial: uartlite: remove unnecessary braces
` [PATCH 15/41] drivers: tty: serial: uartlite: fix use fix bare 'unsigned'
` [PATCH 16/41] drivers: tty: serial: uartlite: fix overlong lines
` [PATCH 20/41] drivers: tty: serial: cpm_uart: use dev_err()/dev_warn() instead of printk()
` [PATCH 21/41] drivers: tty: serial: cpm_uart: fix includes
` [PATCH 22/41] drivers: tty: serial: cpm_uart: fix logging calls
` [PATCH 23/41] drivers: tty: serial: cpm_uart: fix styling issues
` [PATCH 35/41] drivers: tty: serial: 8250: add mapsize to platform data
` [PATCH 36/41] drivers: tty: serial: 8250: store mmio resource size in port struct
` [PATCH 37/41] drivers: tty: serial: 8250: simplify io resource size computation
` [PATCH 40/41] drivers: tty: serial: helper for setting mmio range
` [PATCH 41/41] drivers: tty: serial: lpc32xx_hs: fill mapsize and use it
cpu power up timing changes causes UART rx character loss on imx6ull
2019-04-30 15:35 UTC (2+ messages)
[PATCH v3] tty: serial: 8250: Fix type field in format string
2019-04-29 16:24 UTC
[PATCH v2] tty: serial: 8250: Fix type field in format string
2019-04-29 16:23 UTC (3+ messages)
[PATCH 0/2] Perfect 8250 mtk uart function
2019-04-28 17:40 UTC (3+ messages)
` [PATCH 1/2] serial: 8250-mtk: add follow control
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).