messages from 2019-07-29 14:46:39 to 2019-08-08 10:02:08 UTC [more...]
[PATCH v2 0/3] serial: lantiq: Update driver to support new SoC
2019-08-08 10:02 UTC (4+ messages)
` [PATCH v2 1/3] serial: lantiq: Use proper DT compatible string
` [PATCH v2 2/3] serial: lantiq: Make IRQ & ISR assignment dynamic
` [PATCH v2 3/3] serial: lantiq: Add support for Lightning Mountain SoC
[PATCH 0/9] dt-bindings: first tentative of conversion to yaml format
2019-08-08 8:51 UTC (2+ messages)
` [PATCH 8/9] dt-bindings: serial: meson-uart: convert to yaml
[PATCH 0/6] Add initial support for S32V234-EVB
2019-08-08 8:08 UTC (16+ messages)
` [PATCH 1/6] dt-bindings: arm: fsl: Add the S32V234-EVB board
` [EXT] "
` [PATCH 2/6] arm64: Introduce config for S32
` [PATCH 3/6] arm64: dts: fsl: Add device tree for S32V234-EVB
` [PATCH 4/6] dt-bindings: serial: Document Freescale LINFlex UART
` [PATCH 5/6] tty: serial: Add linflexuart driver for S32V234
` [PATCH 6/6] arm64: defconfig: Enable configs "
[PATCH V38 18/29] Lock down TIOCSSERIAL
2019-08-08 0:07 UTC
[PATCH 4/5] dt-bindings: serial: lantiq: Update for new SoC
2019-08-07 13:31 UTC (5+ messages)
` [PATCH 1/5] serial: lantiq: Add SMP support
` [PATCH 2/5] serial: lantiq: Use proper DT compatible string
` [PATCH 3/5] serial: lantiq: Make IRQ & ISR assignment dynamic
` [PATCH 5/5] serial: lantiq: Add support for Lightning Mountain SoC
[PATCH] tty: serial: Introduce uart_tx_stoppped_or_empty()
2019-08-07 8:02 UTC (4+ messages)
[PATCH 00/14] ARM: move lpc32xx and dove to multiplatform
2019-08-06 20:16 UTC (35+ messages)
` [PATCH 01/14] usb: ohci-nxp: enable compile-testing
` [PATCH 02/14] usb: udc: lpc32xx: allow compile-testing
` [PATCH 03/14] watchdog: pnx4008_wdt: "
` [PATCH 04/14] serial: lpc32xx_hs: "
` [PATCH 05/14] gpio: lpc32xx: allow building on non-lpc32xx targets
` [PATCH 06/14] net: lpc-enet: factor out iram access
` [PATCH 07/14] net: lpc-enet: move phy setup into platform code
` [PATCH 08/14] net: lpc-enet: allow compile testing
` [PATCH 09/14] serial: lpc32xx: "
` [PATCH 10/14] ARM: lpc32xx: clean up header files
` [PATCH 11/14] ARM: lpc32xx: allow multiplatform build
` [PATCH 12/14] ARM: dove: clean up mach/*.h headers
` [PATCH 13/14] ARM: orion/mvebu: unify debug-ll virtual addresses
` [PATCH 14/14] ARM: dove: multiplatform support
[RFCv2 0/9] dt-bindings: first tentative of conversion to yaml format
2019-08-06 19:18 UTC (5+ messages)
` [RFCv2 8/9] dt-bindings: serial: meson-uart: convert to yaml
[PATCH v3 1/4] serial: mctrl_gpio: Avoid probe failures in case of missing gpiolib
2019-08-06 8:09 UTC (15+ messages)
` [PATCH v3 2/4] serial: mctrl_gpio: Add a NULL check to mctrl_gpio_to_gpiod()
` [PATCH v3 3/4] serial: sh-sci: Don't check for mctrl_gpio_init() returning -ENOSYS
` [PATCH v3 4/4] serial: 8250: "
[PATCH v3 0/6] LPUART fixes and improvements
2019-08-05 18:57 UTC (7+ messages)
` [PATCH v3 1/6] tty: serial: fsl_lpuart: Introduce lpuart_tx_dma_startup()
` [PATCH v3 2/6] tty: serial: fsl_lpuart: Introduce lpuart_rx_dma_startup()
` [PATCH v3 3/6] tty: serial: fsl_lpuart: Introduce lpuart32_configure()
` [PATCH v3 4/6] tty: serial: fsl_lpuart: Introduce lpuart*_setup_watermark_enable()
` [PATCH v3 5/6] tty: serial: fsl_lpuart: Don't enable TIE in .startup() or .resume()
` [PATCH v3 6/6] tty: serial: fsl_lpuart: Ignore TX/RX interrupts if DMA is enabled
[engineering.redhat.com #494100] Question on submitting patch for a security bug
2019-08-05 17:38 UTC
Device to write to all (serial) consoles
2019-08-03 15:15 UTC (7+ messages)
[PATCH -next] tty: serial: qcom_geni_serial: use devm_platform_ioremap_resource() to simplify code
2019-08-02 13:08 UTC
[PATCH v2 0/7] TTY Keyboard Status Request
2019-08-02 11:04 UTC (9+ messages)
` [PATCH v2 7/7] n_tty: Provide an informational line on VSTATUS receipt
[PATCH v2 1/3] serial: mctrl_gpio: Avoid probe failures in case of missing gpiolib
2019-08-02 8:24 UTC (8+ messages)
` [PATCH v2 2/3] serial: sh-sci: Remove check for specific mctrl_gpio_init() return value
` [PATCH v2 3/3] serial: 8250: "
[patch v4 0/5] *** AST2500 DMA UART driver ***
2019-08-01 19:28 UTC (6+ messages)
` [patch v4 1/5] AST2500 DMA UART driver
` [patch v4 3/5] DT nodes for "
[RFC 0/9] dt-bindings: first tentative of conversion to yaml format
2019-08-01 15:20 UTC (5+ messages)
` [RFC 8/9] dt-bindings: serial: meson-uart: convert to yaml
[PATCH v2 00/23] LPUART fixes and improvements
2019-08-01 15:14 UTC (26+ messages)
` [PATCH v2 01/23] tty: serial: fsl_lpuart: fix framing error handling when using DMA
` [PATCH v2 02/23] tty: serial: fsl_lpuart: flush receive FIFO after overruns
` [PATCH v2 03/23] tty: serial: fsl_lpuart: Flush HW FIFOs in .flush_buffer
` [PATCH v2 04/23] tty: serial: fsl_lpuart: Simplify RX/TX IRQ handlers
` [PATCH v2 05/23] tty: serial: fsl_lpuart: Fix bogus indentation
` [PATCH v2 06/23] tty: serial: fsl_lpuart: Drop unnecessary uart_write_wakeup()
` [PATCH v2 07/23] tty: serial: fsl_lpuart: Fix issue in software flow control
` [PATCH v2 08/23] tty: serial: fls_lpuart: Split shared TX IRQ handler into two
` [PATCH v2 09/23] tty: serial: fsl_lpuart: Drop no-op bit opearation
` [PATCH v2 10/23] tty: serial: fsl_lpuart: Drop unnecessary extra parenthesis
` [PATCH v2 11/23] tty: serial: fsl_lpuart: Clear CSTOPB unconditionally
` [PATCH v2 12/23] tty: serial: fsl_lpuart: Use appropriate lpuart32_* I/O funcs
` [PATCH v2 13/23] tty: serial: fsl_lpuart: Introduce lpuart_wait_bit_set()
` [PATCH v2 14/23] tty: serial: fsl_lpuart: Use cpu_relax() instead of barrier()
` [PATCH v2 15/23] tty: serial: fsl_lpuart: Introduce lpuart_stopped_or_empty()
` [PATCH v2 16/23] tty: serial: fsl_lpuart: Drop unnecessary lpuart*_stop_tx()
` [PATCH v2 17/23] tty: serial: fsl_lpuart: Introduce lpuart_dma_shutdown()
` [PATCH v2 18/23] tty: serial: fsl_lpuart: Introduce lpuart_tx_dma_startup()
` [PATCH v2 19/23] tty: serial: fsl_lpuart: Introduce lpuart_rx_dma_startup()
` [PATCH v2 20/23] tty: serial: fsl_lpuart: Introduce lpuart32_configure()
` [PATCH v2 21/23] tty: serial: fsl_lpuart: Introduce lpuart*_setup_watermark_enable()
` [PATCH v2 22/23] tty: serial: fsl_lpuart: Don't enable TIE in .startup() or .resume()
` [PATCH v2 23/23] tty: serial: fsl_lpuart: Ignore TX/RX interrupts if DMA is enabled
[PATCH] serial: mctrl_gpio: Avoid probe failures in case of missing gpiolib
2019-08-01 14:47 UTC (3+ messages)
[PATCH 1/1] tty: serial: qcom_geni_serial: Update the oversampling rate
2019-08-01 12:11 UTC
[PATCH] serial: imx: Avoid probe failure in case of missing gpiolib
2019-08-01 11:50 UTC (6+ messages)
[PATCH V37 18/29] Lock down TIOCSSERIAL
2019-07-31 22:16 UTC
[PATCH] serial: sh-sci: Use DEVICE_ATTR_RW() for rx_fifo_trigger
2019-07-31 13:24 UTC (2+ messages)
xilinx_uartps.c: suppress "may be used uninitialised" warning
2019-07-31 6:05 UTC
[PATCH 00/24] LPUART fixes and improvements
2019-07-31 2:09 UTC (31+ messages)
` [PATCH 01/24] tty: serial: fsl_lpuart: fix framing error handling when using DMA
` [PATCH 02/24] tty: serial: fsl_lpuart: flush receive FIFO after overruns
` [PATCH 03/24] tty: serial: fsl_lpuart: Flush HW FIFOs in .flush_buffer
` [PATCH 04/24] tty: serial: fsl_lpuart: Simplify RX/TX IRQ handlers
` [PATCH 05/24] tty: serial: fsl_lpuart: Fix bogus indentation
` [PATCH 06/24] tty: serial: fsl_lpuart: Drop unnecessary sg_set_buf() call
` [PATCH 07/24] tty: serial: fsl_lpuart: Drop unnecessary uart_write_wakeup()
` [PATCH 08/24] tty: serial: fsl_lpuart: Fix issue in software flow control
` [PATCH 09/24] tty: serial: fls_lpuart: Split shared TX IRQ handler into two
` [PATCH 10/24] tty: serial: fsl_lpuart: Drop no-op bit opearation
` [PATCH 11/24] tty: serial: fsl_lpuart: Drop unnecessary extra parenthesis
` [PATCH 12/24] tty: serial: fsl_lpuart: Clear CSTOPB unconditionally
` [PATCH 13/24] tty: serial: fsl_lpuart: Use appropriate lpuart32_* I/O funcs
` [PATCH 14/24] tty: serial: fsl_lpuart: Introduce lpuart_wait_bit_set()
` [PATCH 15/24] tty: serial: fsl_lpuart: Use cpu_relax() instead of barrier()
` [PATCH 16/24] tty: serial: fsl_lpuart: Introduce lpuart_stopped_or_empty()
` [PATCH 17/24] tty: serial: fsl_lpuart: Drop unnecessary lpuart*_stop_tx()
` [PATCH 18/24] tty: serial: fsl_lpuart: Introduce lpuart_dma_shutdown()
` [PATCH 19/24] tty: serial: fsl_lpuart: Introduce lpuart_tx_dma_startup()
` [PATCH 20/24] tty: serial: fsl_lpuart: Introduce lpuart_rx_dma_startup()
` [PATCH 21/24] tty: serial: fsl_lpuart: Introduce lpuart32_configure()
` [PATCH 22/24] tty: serial: fsl_lpuart: Introduce lpuart*_setup_watermark_enable()
` [PATCH 23/24] tty: serial: fsl_lpuart: Don't enable TIE in .startup() or .resume()
` [PATCH 24/24] tty: serial: fsl_lpuart: Ignore TX/RX interrupts if DMA is enabled
[PATCH] kgdboc: disable the console lock when in kgdb
2019-07-30 15:38 UTC (4+ messages)
[PATCH v3 0/7] Use MFD framework for SGI IOC3 drivers
2019-07-29 18:45 UTC (4+ messages)
` [PATCH v3 5/7] mfd: ioc3: Add driver for SGI IOC3 chip
[PATCH] drivers: tty: serial: amba-pl011: use generic ops request/release port
2019-07-29 14:46 UTC (2+ messages)
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).