messages from 2020-05-15 16:18:18 to 2020-05-27 00:23:37 UTC [more...]
[PATCH 1/2] alpha: add a delay between RTC port write and read
2020-05-27 0:23 UTC (35+ messages)
` [PATCH 1/2 v2] alpha: add a delay to inb_p, inb_w and inb_l
` [PATCH 1/2 v3] "
` [PATCH v4] alpha: fix memory barriers so that they conform to the specification
` [PATCH v5] "
` [PATCH v6] "
` [PATCH v7] "
[PATCH v5 0/3] serial: 8250_dw: Fix ref clock usage
2020-05-26 18:12 UTC (4+ messages)
` [PATCH v5 1/3] serial: 8250: Add 8250 port clock update method
` [PATCH v5 2/3] serial: 8250_dw: Simplify the ref clock rate setting procedure
` [PATCH v5 3/3] serial: 8250_dw: Fix common clocks usage race condition
[PATCH v4 0/3] serial: 8250_dw: Fix ref clock usage
2020-05-26 17:41 UTC (6+ messages)
` [PATCH v4 1/3] serial: 8250: Add 8250 port clock update method
` [PATCH v4 2/3] serial: 8250_dw: Simplify the ref clock rate setting procedure
` [PATCH v4 3/3] serial: 8250_dw: Fix common clocks usage race condition
[PATCH V7 0/7] Add interconnect support to QSPI and QUP drivers
2020-05-26 17:36 UTC (9+ messages)
` [PATCH V7 1/7] soc: qcom: geni: Support for ICC voting
` [PATCH V7 2/7] soc: qcom-geni-se: Add interconnect support to fix earlycon crash
` [PATCH V7 3/7] i2c: i2c-qcom-geni: Add interconnect support
` [PATCH V7 4/7] spi: spi-geni-qcom: "
` [PATCH V7 5/7] tty: serial: qcom_geni_serial: "
` [PATCH V7 6/7] spi: spi-qcom-qspi: "
` [PATCH V7 7/7] arm64: dts: sc7180: Add interconnect for QUP and QSPI
[PATCH v2] serial: 8250: Enable 16550A variants by default on non-x86
2020-05-26 16:13 UTC
[PATCH] serial: 8250: Enable 16550A variants by default on non-x86
2020-05-26 16:05 UTC (3+ messages)
[PATCH] tty: hvc_console, fix crashes on parallel open/close
2020-05-26 14:56 UTC
[PATCH V6 0/7] [PATCH V5 0/7] Add interconnect support to QSPI and QUP drivers
2020-05-26 12:41 UTC (16+ messages)
` [PATCH V6 1/7] soc: qcom: geni: Support for ICC voting
` [PATCH V6 2/7] soc: qcom-geni-se: Add interconnect support to fix earlycon crash
` [PATCH V6 3/7] i2c: i2c-qcom-geni: Add interconnect support
` [PATCH V6 4/7] spi: spi-geni-qcom: "
` [PATCH V6 5/7] tty: serial: qcom_geni_serial: "
` [PATCH V6 6/7] spi: spi-qcom-qspi: "
` [PATCH V6 7/7] arm64: dts: sc7180: Add interconnect for QUP and QSPI
[PATCH] serial: 8250: probe all 16550A variants by default
2020-05-26 8:35 UTC (7+ messages)
[PATCH] 16C950 UART enable Hardware Flow Control
2020-05-25 17:49 UTC (3+ messages)
[PATCH v1] serial: imx: Initialize lock for non-registered console
2020-05-25 15:52 UTC (7+ messages)
[PATCH v3 0/6] serial: Disable DMA and PM on kernel console
2020-05-25 13:59 UTC (5+ messages)
` [PATCH v3 2/6] serial: core: Allow detach and attach serial device for console
[RFC PATCH v2 0/3] Prefer working VT console over SPCR and device-tree chosen stdout-path
2020-05-25 13:04 UTC (7+ messages)
` [RFC PATCH v2 1/3] printk: Add function to set console to preferred console's driver
[RFC PATCH v4] GCOV: profile by modules
2020-05-25 10:00 UTC
[PATCHv8 0/6] n_gsm serdev support and GNSS driver for droid4
2020-05-25 7:44 UTC (3+ messages)
Hardwore FlowControl for 16C950 is not activated
2020-05-24 15:19 UTC (2+ messages)
[tty:tty-testing] BUILD SUCCESS 2aa916e67db3e625cc0bfe577f67034a46f81c8a
2020-05-24 14:01 UTC
[GIT PULL] TTY/Serial driver fix for 5.7-rc7
2020-05-23 18:30 UTC (2+ messages)
[PATCH v3 0/6] sc16is7xx: IrDA mode and threaded IRQs
2020-05-23 12:27 UTC (9+ messages)
` [PATCH v3 1/6] dt-bindings: sc16is7xx: Add flag to activate IrDA mode
` [PATCH v3 2/6] "
` [PATCH v3 3/6] sc16is7xx: Always use falling edge IRQ
` [PATCH v3 4/6] sc16is7xx: Use threaded IRQ
` [PATCH v3 5/6] sc16is7xx: Allow sharing the IRQ line
` [PATCH v3 6/6] sc16is7xx: Read the LSR register for basic device presence check
[PATCH 2/2] alpha: add a delay before serial port read
2020-05-23 10:37 UTC (11+ messages)
` [PATCH 2/2 v2] "
` [PATCH 2/2 v3] "
` [PATCH 2/2 v4] "
[PATCH] serial: kgdboc: Allow earlycon initialization to be deferred
2020-05-22 15:30 UTC (5+ messages)
` [PATCH v2] "
[PATCH V5] serial: msm_geni_serial_console : Add Earlycon support
2020-05-22 13:13 UTC (2+ messages)
[PATCH V4] serial: msm_geni_serial_console : Add Earlycon support
2020-05-22 12:41 UTC (3+ messages)
[RFC][PATCH V3] GCOV: profile by modules
2020-05-22 10:46 UTC (3+ messages)
Generic CONFIG_SERIAL_DEV_CTRL_TTYPORT to be disabled to enable BBB overlay /dev/ttySC0
2020-05-22 5:57 UTC
[PATCH v12 0/4] add uart DMA function
2020-05-21 15:35 UTC (3+ messages)
` [PATCH 2/4] arm: dts: mt2712: add uart APDMA to device tree
[PATCH v2 0/6] sc16is7xx: IrDA mode and threaded IRQs
2020-05-21 8:43 UTC (8+ messages)
` [PATCH v2 1/6] dt-bindings: sc16is7xx: Add flag to activate IrDA mode
` [PATCH v2 2/6] "
` [PATCH v2 3/6] sc16is7xx: Always use falling edge IRQ
` [PATCH v2 4/6] sc16is7xx: Use threaded IRQ
` [PATCH v2 5/6] sc16is7xx: Allow sharing the IRQ line
` [PATCH v2 6/6] sc16is7xx: Read the LSR register for basic device presence check
[PATCH 0/2] add generic DT binding for RTS/CTS
2020-05-20 13:39 UTC (3+ messages)
` [PATCH 1/2] dt-bindings: serial: add generic DT binding for announcing RTS/CTS lines
` [PATCH 2/2] serial: stm32: Use "
[PATCH] kgdboc: Disable all the early code when kgdboc is a module
2020-05-20 10:34 UTC (3+ messages)
[RFC][PATCH V2] GCOV: profile by modules
2020-05-20 9:20 UTC (5+ messages)
[tty:tty-testing] BUILD SUCCESS 4dd31f1ffec6c370c3c2e0c605628bf5e16d5c46
2020-05-20 5:19 UTC
[PATCH 0/4] sc16is7xx: Add IrDA mode and threaded IRQ
2020-05-19 17:37 UTC (12+ messages)
` [PATCH 1/4] dt-bindings: sc16is7xx: Add flag to activate IrDA mode
` [PATCH 4/4] sc16is7xx: Use threaded IRQ
[PATCH] dt-bindings: serial: Add renesas,em-uart bindings
2020-05-19 13:24 UTC (2+ messages)
[PATCH V3] serial: msm_geni_serial_console : Add Earlycon support
2020-05-19 12:06 UTC (3+ messages)
[PATCH v4 00/12] kgdb: Support late serial drivers; enable early debug w/ boot consoles
2020-05-19 10:37 UTC (10+ messages)
` [PATCH v4 03/12] kgdboc: Use a platform device to handle tty drivers showing up late
` [PATCH v4 04/12] kgdb: Delay "kgdbwait" to dbg_late_init() by default
[PATCH 1/1] serial: stm32: add no_console_suspend support
2020-05-19 9:41 UTC
[PATCH v10 1/3] serial: samsung: Replace rd_regb/wr_regb with rd_reg/wr_reg
2020-05-19 5:55 UTC (3+ messages)
` [PATCH v10 3/3] tty: samsung_tty: 32-bit access for TX/RX hold registers
[PATCH v1] dt-bindings: serial: qca,ar9330-uart: Convert to json-schema
2020-05-18 18:29 UTC (2+ messages)
[PATCH v3 0/5] serial: 8250: Add rs485 emulation to 8250_dw
2020-05-18 17:16 UTC (19+ messages)
` [PATCH v3 1/5] serial: 8520_port: Fix function param documentation
` [PATCH v3 2/5] dt-bindings: serial: Add binding for rs485 receiver enable GPIO
` [PATCH v3 3/5] serial: 8250: Support separate rs485 rx-enable GPIO
` [PATCH v3 4/5] serial: 8250: Handle implementations not having TEMT interrupt using em485
` [PATCH v3 5/5] serial: 8250_dw: add em485 support
[PATCH 00/28] DT: Improve validation for Marvell SoCs
2020-05-18 15:20 UTC (24+ messages)
` [PATCH 19/28] dt-bindings: mmc: Convert sdhci-pxa to json-schema
` [PATCH 21/28] dt-bindings: gpio: Convert mrvl-gpio "
` [PATCH 23/28] dt-bindings: interrupt-controller: Convert mrvl,intc "
` [PATCH 24/28] dt-bindings: media: Convert marvell,mmp2-ccic "
` [PATCH 25/28] dt-bindings: rtc: Convert sa1100-rtc "
` [PATCH 26/28] dt-bindings: spi: Convert spi-pxa2xx "
` [PATCH 28/28] dt-bindings: usb: Convert ehci-mv "
[PATCH 0/3] add wakeup_irq for in-band wakeup support
2020-05-18 14:56 UTC (5+ messages)
` [PATCH 1/3] serdev: ttyport: add devt for tty port
[PATCH v3 0/2] rs485 bus termination GPIO
2020-05-18 14:45 UTC (3+ messages)
` [PATCH v3 1/2] dt-bindings: serial: Add binding for "
` [PATCH v3 2/2] serial: 8250: Support "
[PATCH V5 0/7] Add interconnect support to QSPI and QUP drivers
2020-05-18 13:10 UTC (4+ messages)
` [PATCH V5 6/7] spi: spi-qcom-qspi: Add interconnect support
[RFC][PATCH] GCOV: profile by modules
2020-05-18 10:00 UTC (2+ messages)
[PATCH v3 0/2] Add CTS/RTS gpio support to STM32 UART
2020-05-18 7:25 UTC (4+ messages)
` [PATCH v3 1/2] dt-bindings: serial: Document CTS/RTS gpios in "
` [Linux-stm32] "
[PATCH] tty: serial: fsl_lpuart: Use __maybe_unused instead of #if CONFIG_PM_SLEEP
2020-05-18 3:43 UTC (2+ messages)
[PATCH RFC v2 0/7] serial: 8250: Add rs485 emulation to 8250_dw
2020-05-17 22:01 UTC (10+ messages)
` [PATCH v2 4/7] serial: 8250: Handle implementations not having TEMT interrupt using em485
` [PATCH v2 6/7] serial: 8250: Support separate rs485 rx-enable GPIO
[PATCH v13 0/2] add uart DMA function
2020-05-16 16:52 UTC (3+ messages)
` [PATCH v13 1/2] arm: dts: mt2712: add uart APDMA to device tree
[tty:tty-testing] BUILD SUCCESS b14109f302d01899a8d7aad0d9a2097faa5fb486
2020-05-15 21:51 UTC
[tty:tty-linus] BUILD SUCCESS 17b4efdf4e4867079012a48ca10d965fe9d68822
2020-05-15 20:58 UTC
page: next (older) | prev (newer) | latest
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).