[PATCH v26 17/22] x86/fault: Add helper function to sanitize error code

[Jarkko Sakkinen <jarkko.sakkinen@linux.intel.com>]

From: Sean Christopherson <sean.j.christopherson@intel.com>

Add helper function to sanitize error code to prepare for vDSO exception
fixup, which will expose the error code to userspace and runs before
set_signal_archinfo(), i.e. suppresses the signal when fixup is successful.

Signed-off-by: Sean Christopherson <sean.j.christopherson@intel.com>
Signed-off-by: Jarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
---
 arch/x86/mm/fault.c | 24 +++++++++++++++++-------
 1 file changed, 17 insertions(+), 7 deletions(-)

diff --git a/arch/x86/mm/fault.c b/arch/x86/mm/fault.c
index dee9504cde79..6b662d272af6 100644
--- a/arch/x86/mm/fault.c
+++ b/arch/x86/mm/fault.c
@@ -682,6 +682,18 @@ pgtable_bad(struct pt_regs *regs, unsigned long error_code,
 	oops_end(flags, regs, sig);
 }
 
+static void sanitize_error_code(unsigned long address,
+				unsigned long *error_code)
+{
+	/*
+	 * To avoid leaking information about the kernel page
+	 * table layout, pretend that user-mode accesses to
+	 * kernel addresses are always protection faults.
+	 */
+	if (address >= TASK_SIZE_MAX)
+		*error_code |= X86_PF_PROT;
+}
+
 static void set_signal_archinfo(unsigned long address,
 				unsigned long error_code)
 {
@@ -738,6 +750,8 @@ no_context(struct pt_regs *regs, unsigned long error_code,
 		 * faulting through the emulate_vsyscall() logic.
 		 */
 		if (current->thread.sig_on_uaccess_err && signal) {
+			sanitize_error_code(address, &error_code);
+
 			set_signal_archinfo(address, error_code);
 
 			/* XXX: hwpoison faults will set the wrong code. */
@@ -886,13 +900,7 @@ __bad_area_nosemaphore(struct pt_regs *regs, unsigned long error_code,
 		if (is_errata100(regs, address))
 			return;
 
-		/*
-		 * To avoid leaking information about the kernel page table
-		 * layout, pretend that user-mode accesses to kernel addresses
-		 * are always protection faults.
-		 */
-		if (address >= TASK_SIZE_MAX)
-			error_code |= X86_PF_PROT;
+		sanitize_error_code(address, &error_code);
 
 		if (likely(show_unhandled_signals))
 			show_signal_msg(regs, error_code, address, tsk);
@@ -1009,6 +1017,8 @@ do_sigbus(struct pt_regs *regs, unsigned long error_code, unsigned long address,
 	if (is_prefetch(regs, error_code, address))
 		return;
 
+	sanitize_error_code(address, &error_code);
+
 	set_signal_archinfo(address, error_code);
 
 #ifdef CONFIG_MEMORY_FAILURE
-- 
2.20.1