linux-spi.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Cyril Chemparathy <cyril-l0cyMroinI0@public.gmane.org>
To: davinci-linux-open-source-VycZQUHpC/PFrsHnngEfi1aTQe2KTcn/@public.gmane.org,
	spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org,
	sameo-VuQAYsv1563Yd54FQh9/CA@public.gmane.org,
	lrg-kDsPt+C1G03kYMGBc/C6ZA@public.gmane.org,
	broonie-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org,
	rpurdie@rpsys
Cc: dbrownell-Rn4VEauK+AKRv+LV9MX5uipxlwaOVQ5f@public.gmane.org,
	khilman-1D3HCaltpLuhEniVeURVKkEOCMrvLtNR@public.gmane.org,
	Cyril Chemparathy <cyril-l0cyMroinI0@public.gmane.org>,
	akpm-de/tnXTf+JLsfHDXvbKv3WD2FQJk+8+b@public.gmane.org,
	alan-qBU/x9rampVanCEyBjwyrvXRex20P6io@public.gmane.org
Subject: [PATCH v6 03/12] davinci: add ssp config for tnetv107x evm board
Date: Fri, 19 Nov 2010 10:55:47 -0500	[thread overview]
Message-ID: <1290182156-20104-4-git-send-email-cyril@ti.com> (raw)
In-Reply-To: <1290182156-20104-1-git-send-email-cyril-l0cyMroinI0@public.gmane.org>

This patch adds SSP configuration and pin muxing info for tnetv107x
evm boards.

Signed-off-by: Cyril Chemparathy <cyril-l0cyMroinI0@public.gmane.org>
---
 arch/arm/mach-davinci/board-tnetv107x-evm.c |   14 ++++++++++++++
 1 files changed, 14 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-davinci/board-tnetv107x-evm.c b/arch/arm/mach-davinci/board-tnetv107x-evm.c
index a6db854..ef526b1 100644
--- a/arch/arm/mach-davinci/board-tnetv107x-evm.c
+++ b/arch/arm/mach-davinci/board-tnetv107x-evm.c
@@ -99,6 +99,12 @@ static const short uart1_pins[] __initdata = {
 	-1
 };
 
+static const short ssp_pins[] __initdata = {
+	TNETV107X_SSP0_0, TNETV107X_SSP0_1, TNETV107X_SSP0_2,
+	TNETV107X_SSP1_0, TNETV107X_SSP1_1, TNETV107X_SSP1_2,
+	TNETV107X_SSP1_3, -1
+};
+
 static struct mtd_partition nand_partitions[] = {
 	/* bootloader (U-Boot, etc) in first 12 sectors */
 	{
@@ -196,17 +202,25 @@ static struct matrix_keypad_platform_data keypad_config = {
 	.no_autorepeat	= 0,
 };
 
+static struct ti_ssp_data ssp_config = {
+	.out_clock	= 250 * 1000,
+	.dev_data	= {
+	},
+};
+
 static struct tnetv107x_device_info evm_device_info __initconst = {
 	.serial_config		= &serial_config,
 	.mmc_config[1]		= &mmc_config,	/* controller 1 */
 	.nand_config[0]		= &nand_config,	/* chip select 0 */
 	.keypad_config		= &keypad_config,
+	.ssp_config		= &ssp_config,
 };
 
 static __init void tnetv107x_evm_board_init(void)
 {
 	davinci_cfg_reg_list(sdio1_pins);
 	davinci_cfg_reg_list(uart1_pins);
+	davinci_cfg_reg_list(ssp_pins);
 
 	tnetv107x_devices_init(&evm_device_info);
 }
-- 
1.7.1


------------------------------------------------------------------------------
Beautiful is writing same markup. Internet Explorer 9 supports
standards for HTML5, CSS3, SVG 1.1,  ECMAScript5, and DOM L2 & L3.
Spend less time writing and  rewriting code and more time creating great
experiences on the web. Be a part of the beta today
http://p.sf.net/sfu/msIE9-sfdev2dev

  parent reply	other threads:[~2010-11-19 15:55 UTC|newest]

Thread overview: 22+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2010-11-19 15:55 [PATCH v6 00/12] tnetv107x ssp drivers Cyril Chemparathy
     [not found] ` <1290182156-20104-1-git-send-email-cyril-l0cyMroinI0@public.gmane.org>
2010-11-19 15:55   ` [PATCH v6 01/12] misc: add driver for sequencer serial port Cyril Chemparathy
2010-11-19 15:55   ` [PATCH v6 02/12] davinci: add tnetv107x ssp platform device Cyril Chemparathy
2010-11-19 15:55   ` Cyril Chemparathy [this message]
2010-11-19 15:55   ` [PATCH v6 04/12] spi: add ti-ssp spi master driver Cyril Chemparathy
2010-11-19 15:55   ` [PATCH v6 05/12] davinci: add spi devices on tnetv107x evm Cyril Chemparathy
     [not found]     ` <1290182156-20104-6-git-send-email-cyril-l0cyMroinI0@public.gmane.org>
2010-11-19 16:25       ` Sergei Shtylyov
     [not found]         ` <4CE6A516.402-Igf4POYTYCDQT0dZR+AlfA@public.gmane.org>
2010-11-19 17:11           ` Cyril Chemparathy
2010-11-19 15:55   ` [PATCH v6 06/12] regulator: add driver for tps6524x regulator Cyril Chemparathy
2010-11-19 15:55   ` [PATCH v6 07/12] davinci: add tnetv107x evm regulators Cyril Chemparathy
2010-11-19 15:55   ` [PATCH v6 08/12] gpio: add ti-ssp gpio driver Cyril Chemparathy
     [not found]     ` <1290182156-20104-9-git-send-email-cyril-l0cyMroinI0@public.gmane.org>
2010-11-21 20:02       ` Ryan Mallon
     [not found]         ` <4CE97AE5.3040801-7Wk5F4Od5/oYd5yxfr4S2w@public.gmane.org>
2010-11-21 21:31           ` Grant Likely
2010-11-22 11:20             ` Mark Brown
2010-11-22 19:35               ` Ryan Mallon
2010-11-19 15:55   ` [PATCH v6 09/12] davinci: add tnetv107x evm ti-ssp gpio device Cyril Chemparathy
2010-11-19 15:55   ` [PATCH v6 10/12] backlight: add support for tps6116x controller Cyril Chemparathy
2010-11-19 15:55   ` [PATCH v6 11/12] davinci: add tnetv107x evm backlight device Cyril Chemparathy
     [not found]     ` <1290182156-20104-12-git-send-email-cyril-l0cyMroinI0@public.gmane.org>
2010-11-19 16:44       ` Sergei Shtylyov
     [not found]         ` <4CE6A950.8040704-Igf4POYTYCDQT0dZR+AlfA@public.gmane.org>
2010-11-19 17:04           ` Cyril Chemparathy
     [not found]             ` <4CE6AE19.6090600-l0cyMroinI0@public.gmane.org>
2010-11-19 17:11               ` Sergei Shtylyov
2010-11-19 15:55   ` [PATCH v6 12/12] davinci: add tnetv107x evm i2c eeprom device Cyril Chemparathy

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1290182156-20104-4-git-send-email-cyril@ti.com \
    --to=cyril-l0cymroini0@public.gmane.org \
    --cc=akpm-de/tnXTf+JLsfHDXvbKv3WD2FQJk+8+b@public.gmane.org \
    --cc=alan-qBU/x9rampVanCEyBjwyrvXRex20P6io@public.gmane.org \
    --cc=broonie-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org \
    --cc=davinci-linux-open-source-VycZQUHpC/PFrsHnngEfi1aTQe2KTcn/@public.gmane.org \
    --cc=dbrownell-Rn4VEauK+AKRv+LV9MX5uipxlwaOVQ5f@public.gmane.org \
    --cc=khilman-1D3HCaltpLuhEniVeURVKkEOCMrvLtNR@public.gmane.org \
    --cc=lrg-kDsPt+C1G03kYMGBc/C6ZA@public.gmane.org \
    --cc=rpurdie@rpsys \
    --cc=sameo-VuQAYsv1563Yd54FQh9/CA@public.gmane.org \
    --cc=spi-devel-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).