From mboxrd@z Thu Jan 1 00:00:00 1970 From: Konrad Kociolek Subject: [PATCH 0/2] spi: cadence-xspi: Add support for the Cadence XSPI controller Date: Mon, 20 Jan 2020 13:51:27 +0100 Message-ID: <20200120125149.7607-1-konrad@cadence.com> Mime-Version: 1.0 Content-Type: text/plain Cc: Konrad Kociolek , Mark Brown , , To: unlisted-recipients:; (no To-header on input) Return-path: Sender: linux-spi-owner-u79uwXL29TY76Z2rM5mHXA@public.gmane.org List-ID: Driver for Cadence xSPI flash controller. Command processing Driver uses STIG work mode to communicate with flash memories. In this mode, controller sends low-level instructions to memory. Each instruction is 128-bit width. There is special instruction DataSequence which carries information about data phase. Driver uses Slave DMA interface to transfer data as only this interface can be used in STIG work mode. PHY initialization The initialization of PHY module in Cadence XSPI controller is done by driving external pin-strap signals to controller. Next, driver runs PHY training to find optimal value of read_dqs_delay parameter. Controller checks device discovery status and if it's completed and with no error PHY training passes. Konrad Kociolek (2): Add dt-bindings schema for Cadence XSPI controller driver Add support for Cadence XSPI controller .../devicetree/bindings/spi/cdns,xspi.yaml | 164 ++++ drivers/spi/Kconfig | 11 + drivers/spi/Makefile | 1 + drivers/spi/spi-cadence-xspi.c | 895 +++++++++++++++++++++ 4 files changed, 1071 insertions(+) create mode 100644 Documentation/devicetree/bindings/spi/cdns,xspi.yaml create mode 100644 drivers/spi/spi-cadence-xspi.c -- 2.7.4