On Thu, Feb 27, 2020 at 02:19:08PM +0100, Geert Uytterhoeven wrote: > Hi Maxime, > > On Thu, Feb 27, 2020 at 2:09 PM Maxime Ripard wrote: > > On Thu, Feb 27, 2020 at 02:03:23PM +0100, Geert Uytterhoeven wrote: > > > Currently, the DT bindings for an SPI controller specify that > > > "#address-cells" must be fixed to one. However, that applies to an SPI > > > controller in master mode only. When running in SPI slave mode, > > > "#address-cells" should be zero. > > > > > > Fix this making the value of "#address-cells" dependent on the presence > > > of "spi-slave". > > > > > > Fixes: 0a1b929356830257 ("spi: Add YAML schemas for the generic SPI options") > > > Reported-by: Yoshihiro Shimoda > > > Signed-off-by: Geert Uytterhoeven > > > > --- a/Documentation/devicetree/bindings/spi/spi-controller.yaml > > > +++ b/Documentation/devicetree/bindings/spi/spi-controller.yaml > > > > @@ -52,6 +53,18 @@ properties: > > > description: > > > The SPI controller acts as a slave, instead of a master. > > > > > > +if: > > > + required: > > > + [ spi-slave ] > > > > Nit: Usually, that notation is when you would do it on the same line, > > if you want to go to a new line, it would make more sense to use - > > Sorry, being a poor yaml-by-example programmer, I don't understand what > you mean. Which part do you refer to by "that notation"? I meant that usually the [] notation is used over a single line. If you want to have a list over multiple lines, usually you would have required: - spi-slave Maxime