linux-spi.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
* [PATCH] spi: rspi: Add support for active-high chip selects
@ 2020-03-09 17:15 Geert Uytterhoeven
  2020-03-10 14:31 ` Applied "spi: rspi: Add support for active-high chip selects" to the spi tree Mark Brown
  0 siblings, 1 reply; 2+ messages in thread
From: Geert Uytterhoeven @ 2020-03-09 17:15 UTC (permalink / raw)
  To: Mark Brown
  Cc: Yoshihiro Shimoda, Chris Brandt, Wolfram Sang, linux-spi,
	linux-renesas-soc, linux-sh, Geert Uytterhoeven

All RSPI variants support setting the polarity of the SSL signal.
Advertize support for active-high chip selects, and configure polarity
according to the state of the flag.

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
---
Tested on r8a7791/koelsch using spidev_test and a logic analyzer.
---
 drivers/spi/spi-rspi.c | 36 ++++++++++++++++++++++++++++++++----
 1 file changed, 32 insertions(+), 4 deletions(-)

diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c
index aef05f2ac749c21d..06192c9ea8132911 100644
--- a/drivers/spi/spi-rspi.c
+++ b/drivers/spi/spi-rspi.c
@@ -24,6 +24,7 @@
 #include <linux/sh_dma.h>
 #include <linux/spi/spi.h>
 #include <linux/spi/rspi.h>
+#include <linux/spinlock.h>
 
 #define RSPI_SPCR		0x00	/* Control Register */
 #define RSPI_SSLP		0x01	/* Slave Select Polarity Register */
@@ -79,8 +80,7 @@
 #define SPCR_BSWAP		0x01	/* Byte Swap of read-data for DMAC */
 
 /* SSLP - Slave Select Polarity Register */
-#define SSLP_SSL1P		0x02	/* SSL1 Signal Polarity Setting */
-#define SSLP_SSL0P		0x01	/* SSL0 Signal Polarity Setting */
+#define SSLP_SSLP(i)		BIT(i)	/* SSLi Signal Polarity Setting */
 
 /* SPPCR - Pin Control Register */
 #define SPPCR_MOIFE		0x20	/* MOSI Idle Value Fixing Enable */
@@ -181,7 +181,9 @@ struct rspi_data {
 	void __iomem *addr;
 	u32 max_speed_hz;
 	struct spi_controller *ctlr;
+	struct platform_device *pdev;
 	wait_queue_head_t wait;
+	spinlock_t lock;		/* Protects RMW-access to RSPI_SSLP */
 	struct clk *clk;
 	u16 spcmd;
 	u8 spsr;
@@ -919,6 +921,29 @@ static int qspi_setup_sequencer(struct rspi_data *rspi,
 	return 0;
 }
 
+static int rspi_setup(struct spi_device *spi)
+{
+	struct rspi_data *rspi = spi_controller_get_devdata(spi->controller);
+	u8 sslp;
+
+	if (spi->cs_gpiod)
+		return 0;
+
+	pm_runtime_get_sync(&rspi->pdev->dev);
+	spin_lock_irq(&rspi->lock);
+
+	sslp = rspi_read8(rspi, RSPI_SSLP);
+	if (spi->mode & SPI_CS_HIGH)
+		sslp |= SSLP_SSLP(spi->chip_select);
+	else
+		sslp &= ~SSLP_SSLP(spi->chip_select);
+	rspi_write8(rspi, sslp, RSPI_SSLP);
+
+	spin_unlock_irq(&rspi->lock);
+	pm_runtime_put(&rspi->pdev->dev);
+	return 0;
+}
+
 static int rspi_prepare_message(struct spi_controller *ctlr,
 				struct spi_message *msg)
 {
@@ -1248,17 +1273,20 @@ static int rspi_probe(struct platform_device *pdev)
 		goto error1;
 	}
 
+	rspi->pdev = pdev;
 	pm_runtime_enable(&pdev->dev);
 
 	init_waitqueue_head(&rspi->wait);
+	spin_lock_init(&rspi->lock);
 
 	ctlr->bus_num = pdev->id;
+	ctlr->setup = rspi_setup;
 	ctlr->auto_runtime_pm = true;
 	ctlr->transfer_one = ops->transfer_one;
 	ctlr->prepare_message = rspi_prepare_message;
 	ctlr->unprepare_message = rspi_unprepare_message;
-	ctlr->mode_bits = SPI_CPHA | SPI_CPOL | SPI_LSB_FIRST | SPI_LOOP |
-			  ops->extra_mode_bits;
+	ctlr->mode_bits = SPI_CPHA | SPI_CPOL | SPI_CS_HIGH | SPI_LSB_FIRST |
+			  SPI_LOOP | ops->extra_mode_bits;
 	ctlr->flags = ops->flags;
 	ctlr->dev.of_node = pdev->dev.of_node;
 	ctlr->use_gpio_descriptors = true;
-- 
2.17.1

^ permalink raw reply	[flat|nested] 2+ messages in thread

* Applied "spi: rspi: Add support for active-high chip selects" to the spi tree
  2020-03-09 17:15 [PATCH] spi: rspi: Add support for active-high chip selects Geert Uytterhoeven
@ 2020-03-10 14:31 ` Mark Brown
  0 siblings, 0 replies; 2+ messages in thread
From: Mark Brown @ 2020-03-10 14:31 UTC (permalink / raw)
  To: Geert Uytterhoeven
  Cc: Chris Brandt, linux-renesas-soc, linux-sh, linux-spi, Mark Brown,
	Wolfram Sang, Yoshihiro Shimoda

The patch

   spi: rspi: Add support for active-high chip selects

has been applied to the spi tree at

   https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git 

All being well this means that it will be integrated into the linux-next
tree (usually sometime in the next 24 hours) and sent to Linus during
the next merge window (or sooner if it is a bug fix), however if
problems are discovered then the patch may be dropped or reverted.  

You may get further e-mails resulting from automated or manual testing
and review of the tree, please engage with people reporting problems and
send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they
should be sent as incremental updates against current git, existing
patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying
to this mail.

Thanks,
Mark

>From f3a14a3a4d9a54c665e979b1dedbbab1f7503a43 Mon Sep 17 00:00:00 2001
From: Geert Uytterhoeven <geert+renesas@glider.be>
Date: Mon, 9 Mar 2020 18:15:37 +0100
Subject: [PATCH] spi: rspi: Add support for active-high chip selects

All RSPI variants support setting the polarity of the SSL signal.
Advertize support for active-high chip selects, and configure polarity
according to the state of the flag.

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Link: https://lore.kernel.org/r/20200309171537.21551-1-geert+renesas@glider.be
Signed-off-by: Mark Brown <broonie@kernel.org>
---
 drivers/spi/spi-rspi.c | 36 ++++++++++++++++++++++++++++++++----
 1 file changed, 32 insertions(+), 4 deletions(-)

diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c
index aef05f2ac749..06192c9ea813 100644
--- a/drivers/spi/spi-rspi.c
+++ b/drivers/spi/spi-rspi.c
@@ -24,6 +24,7 @@
 #include <linux/sh_dma.h>
 #include <linux/spi/spi.h>
 #include <linux/spi/rspi.h>
+#include <linux/spinlock.h>
 
 #define RSPI_SPCR		0x00	/* Control Register */
 #define RSPI_SSLP		0x01	/* Slave Select Polarity Register */
@@ -79,8 +80,7 @@
 #define SPCR_BSWAP		0x01	/* Byte Swap of read-data for DMAC */
 
 /* SSLP - Slave Select Polarity Register */
-#define SSLP_SSL1P		0x02	/* SSL1 Signal Polarity Setting */
-#define SSLP_SSL0P		0x01	/* SSL0 Signal Polarity Setting */
+#define SSLP_SSLP(i)		BIT(i)	/* SSLi Signal Polarity Setting */
 
 /* SPPCR - Pin Control Register */
 #define SPPCR_MOIFE		0x20	/* MOSI Idle Value Fixing Enable */
@@ -181,7 +181,9 @@ struct rspi_data {
 	void __iomem *addr;
 	u32 max_speed_hz;
 	struct spi_controller *ctlr;
+	struct platform_device *pdev;
 	wait_queue_head_t wait;
+	spinlock_t lock;		/* Protects RMW-access to RSPI_SSLP */
 	struct clk *clk;
 	u16 spcmd;
 	u8 spsr;
@@ -919,6 +921,29 @@ static int qspi_setup_sequencer(struct rspi_data *rspi,
 	return 0;
 }
 
+static int rspi_setup(struct spi_device *spi)
+{
+	struct rspi_data *rspi = spi_controller_get_devdata(spi->controller);
+	u8 sslp;
+
+	if (spi->cs_gpiod)
+		return 0;
+
+	pm_runtime_get_sync(&rspi->pdev->dev);
+	spin_lock_irq(&rspi->lock);
+
+	sslp = rspi_read8(rspi, RSPI_SSLP);
+	if (spi->mode & SPI_CS_HIGH)
+		sslp |= SSLP_SSLP(spi->chip_select);
+	else
+		sslp &= ~SSLP_SSLP(spi->chip_select);
+	rspi_write8(rspi, sslp, RSPI_SSLP);
+
+	spin_unlock_irq(&rspi->lock);
+	pm_runtime_put(&rspi->pdev->dev);
+	return 0;
+}
+
 static int rspi_prepare_message(struct spi_controller *ctlr,
 				struct spi_message *msg)
 {
@@ -1248,17 +1273,20 @@ static int rspi_probe(struct platform_device *pdev)
 		goto error1;
 	}
 
+	rspi->pdev = pdev;
 	pm_runtime_enable(&pdev->dev);
 
 	init_waitqueue_head(&rspi->wait);
+	spin_lock_init(&rspi->lock);
 
 	ctlr->bus_num = pdev->id;
+	ctlr->setup = rspi_setup;
 	ctlr->auto_runtime_pm = true;
 	ctlr->transfer_one = ops->transfer_one;
 	ctlr->prepare_message = rspi_prepare_message;
 	ctlr->unprepare_message = rspi_unprepare_message;
-	ctlr->mode_bits = SPI_CPHA | SPI_CPOL | SPI_LSB_FIRST | SPI_LOOP |
-			  ops->extra_mode_bits;
+	ctlr->mode_bits = SPI_CPHA | SPI_CPOL | SPI_CS_HIGH | SPI_LSB_FIRST |
+			  SPI_LOOP | ops->extra_mode_bits;
 	ctlr->flags = ops->flags;
 	ctlr->dev.of_node = pdev->dev.of_node;
 	ctlr->use_gpio_descriptors = true;
-- 
2.20.1

^ permalink raw reply	[flat|nested] 2+ messages in thread

end of thread, other threads:[~2020-03-10 14:31 UTC | newest]

Thread overview: 2+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2020-03-09 17:15 [PATCH] spi: rspi: Add support for active-high chip selects Geert Uytterhoeven
2020-03-10 14:31 ` Applied "spi: rspi: Add support for active-high chip selects" to the spi tree Mark Brown

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).