From: Pratyush Yadav <p.yadav@ti.com>
To: Mark Brown <broonie@kernel.org>
Cc: Tudor Ambarus <tudor.ambarus@microchip.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Richard Weinberger <richard@nod.at>,
Vignesh Raghavendra <vigneshr@ti.com>,
Nicolas Ferre <nicolas.ferre@microchip.com>,
Alexandre Belloni <alexandre.belloni@bootlin.com>,
Ludovic Desroches <ludovic.desroches@microchip.com>,
<linux-mtd@lists.infradead.org>, <linux-kernel@vger.kernel.org>,
<linux-spi@vger.kernel.org>,
<linux-arm-kernel@lists.infradead.org>,
Sekhar Nori <nsekhar@ti.com>
Subject: Re: [PATCH v4 02/16] spi: atmel-quadspi: reject DTR ops
Date: Thu, 30 Apr 2020 17:47:39 +0530 [thread overview]
Message-ID: <20200430121737.37dghomlluzqcxxi@ti.com> (raw)
In-Reply-To: <20200430113243.GB4633@sirena.org.uk>
On 30/04/20 12:32PM, Mark Brown wrote:
> On Sat, Apr 25, 2020 at 12:13:56AM +0530, Pratyush Yadav wrote:
>
> > Double Transfer Rate (DTR) ops are added in spi-mem. But this controller
> > doesn't support DTR transactions. Since we don't use the default
> > supports_op(), which rejects all DTR ops, do that explicitly in our
> > supports_op().
>
> It's not ideal that we'd need to explicitly add checks in individual
> controller drivers - are we sure that all the others do?
Most other controllers either don't specify a supports_op function at
all, in which case spi_mem_default_supports_op() is called, or do their
custom logic and then call spi_mem_default_supports_op(). In both those
cases, DTR ops would get rejected because of the call to
spi_mem_default_supports_op(). So they do not need to add the check
explicitly there.
The two exceptions are atmel-quadspi and spi-mtk-nor (which I missed
updating). They don't call the default supports_op, so they need to be
updated to explicitly to reject DTR ops.
Earlier versions of this series discovered the DTR capability from
devicetree. In that case, no change would be required at all, but review
comments suggested I drop those changes. Instead, the controllers should
accept/reject DTR ops in their supports_op hooks.
--
Regards,
Pratyush Yadav
Texas Instruments India
next prev parent reply other threads:[~2020-04-30 12:18 UTC|newest]
Thread overview: 34+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-04-24 18:43 [PATCH v4 00/16] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-04-24 18:43 ` [PATCH v4 01/16] spi: spi-mem: allow specifying whether an op is DTR or not Pratyush Yadav
2020-04-24 18:43 ` [PATCH v4 02/16] spi: atmel-quadspi: reject DTR ops Pratyush Yadav
2020-04-30 11:32 ` Mark Brown
2020-04-30 12:17 ` Pratyush Yadav [this message]
2020-04-30 12:19 ` Mark Brown
2020-04-24 18:43 ` [PATCH v4 03/16] spi: spi-mem: allow specifying a command's extension Pratyush Yadav
2020-04-24 18:43 ` [PATCH v4 04/16] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-04-24 18:43 ` [PATCH v4 05/16] mtd: spi-nor: default to address width of 3 for configurable widths Pratyush Yadav
2020-04-26 3:53 ` Yicong Yang
2020-04-27 17:23 ` Pratyush Yadav
2020-04-28 1:34 ` Yicong Yang
2020-04-28 5:25 ` Tudor.Ambarus
2020-04-24 18:44 ` [PATCH v4 06/16] mtd: spi-nor: prepare BFPT parsing for JESD216 rev D Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 07/16] mtd: spi-nor: get command opcode extension type from BFPT Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 08/16] mtd: spi-nor: parse xSPI Profile 1.0 table Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 09/16] mtd: spi-nor: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 10/16] mtd: spi-nor: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 11/16] mtd: spi-nor: enable octal DTR mode when possible Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 12/16] mtd: spi-nor: perform a Soft Reset on shutdown Pratyush Yadav
2020-05-10 11:22 ` Tudor.Ambarus
2020-05-11 18:01 ` Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 13/16] mtd: spi-nor: Disable Octal DTR mode on suspend Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 14/16] mtd: spi-nor: expose spi_nor_default_setup() in core.h Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 15/16] mtd: spi-nor: add support for Cypress Semper flash Pratyush Yadav
2020-04-24 18:44 ` [PATCH v4 16/16] mtd: spi-nor: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-05-11 9:00 ` [PATCH v4 00/16] mtd: spi-nor: add xSPI Octal DTR support Tudor.Ambarus
2020-05-11 9:27 ` Boris Brezillon
2020-05-11 18:24 ` Pratyush Yadav
2020-05-12 6:16 ` Tudor.Ambarus
2020-05-12 9:49 ` Vignesh Raghavendra
2020-05-12 11:29 ` Tudor.Ambarus
2020-05-12 18:46 ` Pratyush Yadav
2020-05-11 9:43 ` Vignesh Raghavendra
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200430121737.37dghomlluzqcxxi@ti.com \
--to=p.yadav@ti.com \
--cc=alexandre.belloni@bootlin.com \
--cc=broonie@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=linux-spi@vger.kernel.org \
--cc=ludovic.desroches@microchip.com \
--cc=miquel.raynal@bootlin.com \
--cc=nicolas.ferre@microchip.com \
--cc=nsekhar@ti.com \
--cc=richard@nod.at \
--cc=tudor.ambarus@microchip.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).