linux-spi.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Vignesh Raghavendra <vigneshr@ti.com>
To: Tudor Ambarus <tudor.ambarus@microchip.com>,
	Mark Brown <broonie@kernel.org>
Cc: Vignesh Raghavendra <vigneshr@ti.com>,
	Boris Brezillon <bbrezillon@kernel.org>,
	Ramuthevar Vadivel Murugan 
	<vadivel.muruganx.ramuthevar@linux.intel.com>,
	<linux-mtd@lists.infradead.org>, <linux-kernel@vger.kernel.org>,
	<linux-spi@vger.kernel.org>, <simon.k.r.goldschmidt@gmail.com>,
	<dinguyen@kernel.org>, <marex@denx.de>
Subject: [PATCH 1/6] mtd: spi-nor: cadence-quadspi: Drop cdns,is-decoded-cs property
Date: Sat, 9 May 2020 00:24:06 +0530	[thread overview]
Message-ID: <20200508185411.487-2-vigneshr@ti.com> (raw)
In-Reply-To: <20200508185411.487-1-vigneshr@ti.com>

Cadence QSPI provides a way to automatically decode CS based on the
offset accessed within memory map window. This feature cannot be
supported in spi-mem framework as controller driver would not have
access to flash geometry. Therefore drop this feature in preparation to
moving to spi-mem.

Note that, this feature never worked in the driver (Direct/Indirect mode
accesses did not take into account size of flash on other CSs) and there
are no users of this feature in kernel. Therefore dropping this should
not cause a regression

Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
---
 .../mtd/spi-nor/controllers/cadence-quadspi.c | 59 +++----------------
 1 file changed, 9 insertions(+), 50 deletions(-)

diff --git a/drivers/mtd/spi-nor/controllers/cadence-quadspi.c b/drivers/mtd/spi-nor/controllers/cadence-quadspi.c
index 494dcab4aaaa..fa54f85e16d7 100644
--- a/drivers/mtd/spi-nor/controllers/cadence-quadspi.c
+++ b/drivers/mtd/spi-nor/controllers/cadence-quadspi.c
@@ -77,11 +77,7 @@ struct cqspi_st {
 	dma_addr_t		mmap_phys_base;
 
 	int			current_cs;
-	int			current_page_size;
-	int			current_erase_size;
-	int			current_addr_width;
 	unsigned long		master_ref_clk_hz;
-	bool			is_decoded_cs;
 	u32			fifo_depth;
 	u32			fifo_width;
 	bool			rclk_en;
@@ -715,19 +711,15 @@ static void cqspi_chipselect(struct spi_nor *nor)
 	unsigned int reg;
 
 	reg = readl(reg_base + CQSPI_REG_CONFIG);
-	if (cqspi->is_decoded_cs) {
-		reg |= CQSPI_REG_CONFIG_DECODE_MASK;
-	} else {
-		reg &= ~CQSPI_REG_CONFIG_DECODE_MASK;
+	reg &= ~CQSPI_REG_CONFIG_DECODE_MASK;
 
-		/* Convert CS if without decoder.
-		 * CS0 to 4b'1110
-		 * CS1 to 4b'1101
-		 * CS2 to 4b'1011
-		 * CS3 to 4b'0111
-		 */
-		chip_select = 0xF & ~(1 << chip_select);
-	}
+	/* Convert CS if without decoder.
+	 * CS0 to 4b'1110
+	 * CS1 to 4b'1101
+	 * CS2 to 4b'1011
+	 * CS3 to 4b'0111
+	 */
+	chip_select = 0xF & ~(1 << chip_select);
 
 	reg &= ~(CQSPI_REG_CONFIG_CHIPSELECT_MASK
 		 << CQSPI_REG_CONFIG_CHIPSELECT_LSB);
@@ -736,32 +728,6 @@ static void cqspi_chipselect(struct spi_nor *nor)
 	writel(reg, reg_base + CQSPI_REG_CONFIG);
 }
 
-static void cqspi_configure_cs_and_sizes(struct spi_nor *nor)
-{
-	struct cqspi_flash_pdata *f_pdata = nor->priv;
-	struct cqspi_st *cqspi = f_pdata->cqspi;
-	void __iomem *iobase = cqspi->iobase;
-	unsigned int reg;
-
-	/* configure page size and block size. */
-	reg = readl(iobase + CQSPI_REG_SIZE);
-	reg &= ~(CQSPI_REG_SIZE_PAGE_MASK << CQSPI_REG_SIZE_PAGE_LSB);
-	reg &= ~(CQSPI_REG_SIZE_BLOCK_MASK << CQSPI_REG_SIZE_BLOCK_LSB);
-	reg &= ~CQSPI_REG_SIZE_ADDRESS_MASK;
-	reg |= (nor->page_size << CQSPI_REG_SIZE_PAGE_LSB);
-	reg |= (ilog2(nor->mtd.erasesize) << CQSPI_REG_SIZE_BLOCK_LSB);
-	reg |= (nor->addr_width - 1);
-	writel(reg, iobase + CQSPI_REG_SIZE);
-
-	/* configure the chip select */
-	cqspi_chipselect(nor);
-
-	/* Store the new configuration of the controller */
-	cqspi->current_page_size = nor->page_size;
-	cqspi->current_erase_size = nor->mtd.erasesize;
-	cqspi->current_addr_width = nor->addr_width;
-}
-
 static unsigned int calculate_ticks_for_ns(const unsigned int ref_clk_hz,
 					   const unsigned int ns_val)
 {
@@ -867,18 +833,13 @@ static void cqspi_configure(struct spi_nor *nor)
 	int switch_cs = (cqspi->current_cs != f_pdata->cs);
 	int switch_ck = (cqspi->sclk != sclk);
 
-	if ((cqspi->current_page_size != nor->page_size) ||
-	    (cqspi->current_erase_size != nor->mtd.erasesize) ||
-	    (cqspi->current_addr_width != nor->addr_width))
-		switch_cs = 1;
-
 	if (switch_cs || switch_ck)
 		cqspi_controller_enable(cqspi, 0);
 
 	/* Switch chip select. */
 	if (switch_cs) {
 		cqspi->current_cs = f_pdata->cs;
-		cqspi_configure_cs_and_sizes(nor);
+		cqspi_chipselect(nor);
 	}
 
 	/* Setup baudrate divisor and delays */
@@ -1145,8 +1106,6 @@ static int cqspi_of_get_pdata(struct platform_device *pdev)
 	struct device_node *np = pdev->dev.of_node;
 	struct cqspi_st *cqspi = platform_get_drvdata(pdev);
 
-	cqspi->is_decoded_cs = of_property_read_bool(np, "cdns,is-decoded-cs");
-
 	if (of_property_read_u32(np, "cdns,fifo-depth", &cqspi->fifo_depth)) {
 		dev_err(&pdev->dev, "couldn't determine fifo-depth\n");
 		return -ENXIO;
-- 
2.26.2


  reply	other threads:[~2020-05-08 18:54 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-05-08 18:54 [PATCH 0/6] mtd: spi-nor: Move cadence-qaudspi to spi-mem framework Vignesh Raghavendra
2020-05-08 18:54 ` Vignesh Raghavendra [this message]
2020-05-26  9:31   ` [PATCH 1/6] mtd: spi-nor: cadence-quadspi: Drop cdns,is-decoded-cs property Vignesh Raghavendra
2020-05-08 18:54 ` [PATCH 2/6] mtd: spi-nor: cadence-quadspi: Provide a way to disable DAC mode Vignesh Raghavendra
2020-05-28 18:37   ` Tudor.Ambarus
2020-05-08 18:54 ` [PATCH 3/6] mtd: spi-nor: cadence-quadspi: Don't initialize rx_dma_complete on failure Vignesh Raghavendra
2020-05-08 18:54 ` [PATCH 4/6] mtd: spi-nor: cadence-quadspi: Fix error path on failure to acquire reset lines Vignesh Raghavendra
2020-05-08 18:54 ` [PATCH 5/6] mtd: spi-nor: Convert cadence-quadspi to use spi-mem framework Vignesh Raghavendra
2020-05-08 18:54 ` [PATCH 6/6] spi: Move cadence-quadspi driver to drivers/spi/ Vignesh Raghavendra
2020-05-11 10:20 ` [PATCH 0/6] mtd: spi-nor: Move cadence-qaudspi to spi-mem framework Ramuthevar, Vadivel MuruganX

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200508185411.487-2-vigneshr@ti.com \
    --to=vigneshr@ti.com \
    --cc=bbrezillon@kernel.org \
    --cc=broonie@kernel.org \
    --cc=dinguyen@kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mtd@lists.infradead.org \
    --cc=linux-spi@vger.kernel.org \
    --cc=marex@denx.de \
    --cc=simon.k.r.goldschmidt@gmail.com \
    --cc=tudor.ambarus@microchip.com \
    --cc=vadivel.muruganx.ramuthevar@linux.intel.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).