On Sun, Mar 28, 2021 at 06:59:28PM -0700, Brad Larson wrote:

> @@ -56,7 +56,7 @@ struct dw_spi_mscc {
>  /*
>   * The Designware SPI controller (referred to as master in the documentation)
>   * automatically deasserts chip select when the tx fifo is empty. The chip
> - * selects then needs to be either driven as GPIOs or, for the first 4 using the
> + * selects then needs to be either driven as GPIOs or, for the first 4 using
>   * the SPI boot controller registers. the final chip select is an OR gate
>   * between the Designware SPI controller and the SPI boot controller.
>   */

This is an unrelated fix, please send as a separate patch as covered in
submitting-patches.rst.

> @@ -237,6 +237,31 @@ static int dw_spi_canaan_k210_init(struct platform_device *pdev,
>  	return 0;
>  }
>  
> +static void dw_spi_elba_set_cs(struct spi_device *spi, bool enable)
> +{
> +	struct dw_spi *dws = spi_master_get_devdata(spi->master);
> +
> +	if (!enable) {
> +		/*
> +		 * Using a GPIO-based chip-select, the DW SPI
> +		 * controller still needs its own CS bit selected
> +		 * to start the serial engine.  On Elba the specific
> +		 * CS doesn't matter to start the serial engine,
> +		 * so using CS0.
> +		 */

Why does this comment only apply to one branch of the conditional?