[PATCH v2] watchdog: iTCO_wdt: No need to stop the timer in probe

[Mika Westerberg <mika.westerberg@linux.intel.com>]

The watchdog core can handle pinging of the watchdog before userspace
opens the device. For this reason instead of stopping the timer, just
mark it as running and let the watchdog core take care of it.

Cc: Malin Jonsson <malin.jonsson@ericsson.com>
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
---
Changes from v1:

 - Only set the WDOG_HW_RUNNING flag.

 drivers/watchdog/iTCO_wdt.c | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/watchdog/iTCO_wdt.c b/drivers/watchdog/iTCO_wdt.c
index 643c6c2d0b72..a0e8ad3901a4 100644
--- a/drivers/watchdog/iTCO_wdt.c
+++ b/drivers/watchdog/iTCO_wdt.c
@@ -430,6 +430,16 @@ static unsigned int iTCO_wdt_get_timeleft(struct watchdog_device *wd_dev)
 	return time_left;
 }
 
+static void iTCO_wdt_set_running(struct iTCO_wdt_private *p)
+{
+	u16 val;
+
+	/* Bit 11: TCO Timer Halt -> 0 = The TCO timer is * enabled */
+	val = inw(TCO1_CNT(p));
+	if (!(val & BIT(11)))
+		set_bit(WDOG_HW_RUNNING, &p->wddev.status);
+}
+
 /*
  *	Kernel Interfaces
  */
@@ -572,8 +582,7 @@ static int iTCO_wdt_probe(struct platform_device *pdev)
 	watchdog_set_drvdata(&p->wddev, p);
 	platform_set_drvdata(pdev, p);
 
-	/* Make sure the watchdog is not running */
-	iTCO_wdt_stop(&p->wddev);
+	iTCO_wdt_set_running(p);
 
 	/* Check that the heartbeat value is within it's range;
 	   if not reset to the default */
-- 
2.33.0