From: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
To: linux-wireless@vger.kernel.org
Cc: Eran Harary <eran.harary@intel.com>,
Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Subject: [PATCH 06/31] iwlwifi: mvm: increase the number of PAPD channel groups to 9
Date: Sun, 1 Mar 2015 21:31:19 +0200 [thread overview]
Message-ID: <1425238304-498-6-git-send-email-emmanuel.grumbach@intel.com> (raw)
In-Reply-To: <1425238186.30202.5.camel@egrumbacBox>
From: Eran Harary <eran.harary@intel.com>
Newer devices have more PAPD channel groups.
Signed-off-by: Eran Harary <eran.harary@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
---
drivers/net/wireless/iwlwifi/iwl-phy-db.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/wireless/iwlwifi/iwl-phy-db.c b/drivers/net/wireless/iwlwifi/iwl-phy-db.c
index d4fb5ca..e893c6e 100644
--- a/drivers/net/wireless/iwlwifi/iwl-phy-db.c
+++ b/drivers/net/wireless/iwlwifi/iwl-phy-db.c
@@ -72,7 +72,7 @@
#include "iwl-trans.h"
#define CHANNEL_NUM_SIZE 4 /* num of channels in calib_ch size */
-#define IWL_NUM_PAPD_CH_GROUPS 7
+#define IWL_NUM_PAPD_CH_GROUPS 9
#define IWL_NUM_TXP_CH_GROUPS 9
struct iwl_phy_db_entry {
--
1.9.1
next prev parent reply other threads:[~2015-03-01 19:32 UTC|newest]
Thread overview: 39+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-03-01 19:29 pull request: iwlwifi-next 2015-03-01 Grumbach, Emmanuel
2015-03-01 19:31 ` [PATCH 01/31] iwlwifi: mvm: rs: better match tx response rate to the LQ table Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 02/31] iwlwifi: mvm: rs: fix BT Coex check to look at the correct ant Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 03/31] iwlwifi: mvm: rs: adapt rate matching to new STBC/BFER Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 04/31] iwlwifi: mvm: rs: disable MIMO for low latency P2P Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 05/31] iwlwifi: mvm: consider TDLS queues as used during drain Emmanuel Grumbach
2015-03-01 22:21 ` Julian Calaby
2015-03-01 19:31 ` Emmanuel Grumbach [this message]
2015-03-01 19:31 ` [PATCH 07/31] iwlwifi: mvm: rs: avoid ss_force from being reset after tx idle Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 08/31] iwlwifi: mvm: rs: print single stream params via debugfs Emmanuel Grumbach
2015-03-01 19:42 ` Joe Perches
2015-03-02 8:46 ` Eyal Shapira
2015-03-01 22:20 ` Julian Calaby
2015-03-01 19:31 ` [PATCH 09/31] iwlwifi: mvm: fix BT coex shared antenna activity check Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 10/31] iwlwifi: mvm: remove unused function in BT coex Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 11/31] iwlwifi: pcie: apply destination before releasing reset Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 12/31] iwlwifi: mvm: add statistics API version 10 Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 13/31] iwlwifi: mvm: support radio statistics as global survey Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 14/31] iwlwifi: deprecate -9.ucode for 3160 / 7260 / 7265 Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 15/31] iwlwifi: mvm: remove deprecated scan API code Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 16/31] iwlwifi: mvm: don't write to DBGC_OUT_CTRL when stopping the recording Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 17/31] iwlwifi: mvm: support beacon statistics for BSS client Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 18/31] iwlwifi: mvm: new Alive / error table API Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 19/31] iwlwifi: mvm: don't iterate interfaces to disconnect in net-detect Emmanuel Grumbach
2015-03-01 22:23 ` Julian Calaby
2015-03-02 6:24 ` Grumbach, Emmanuel
2015-03-01 19:31 ` [PATCH 20/31] iwlwifi: add new TLV capability flag for BT PLCR Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 21/31] iwlwifi: mvm: allow to force the Rx chains from debugfs Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 22/31] iwlwifi: mvm: use only 40 ms for fragmented scan Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 23/31] iwlwifi: mvm: add framework for triggers for fw dump Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 24/31] iwlwifi: mvm: add the cause of the firmware dump in the dump Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 25/31] iwlwifi: mvm: add trigger for firmware dump upon missed beacons Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 26/31] iwlwifi: mvm: add trigger for firmware dump upon channel switch Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 27/31] iwlwifi: mvm: add trigger for firmware dump upon command response Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 28/31] iwlwifi: mvm: restart firmware recording when no configuration is set Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 29/31] iwlwifi: mvm: add trigger for firmware dump upon statistics Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 30/31] iwlwifi: mvm: add trigger for firmware dump upon low RSSI Emmanuel Grumbach
2015-03-01 19:31 ` [PATCH 31/31] iwlwifi: mvm: don't override passive dwell in case of fragmented scan Emmanuel Grumbach
2015-03-03 11:52 ` pull request: iwlwifi-next 2015-03-01 Kalle Valo
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1425238304-498-6-git-send-email-emmanuel.grumbach@intel.com \
--to=emmanuel.grumbach@intel.com \
--cc=eran.harary@intel.com \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).