[PATCH v2 0/3] mmc: Fixup HW reset for SDIO cards

[Ulf Hansson <ulf.hansson@linaro.org>]

Changes in v2:
	- Add adaptations to the mwifiex driver.
	- Keep existing syncronous reset behaviour if the SDIO card has a single
	func driver.

It has turned out that it's not a good idea to try to power cycle and to
re-initialize the SDIO card, as currently done through mmc_hw_reset(). This
because there may be multiple SDIO funcs attached to the same SDIO card and
some of the others that didn't execute the call to mmc_hw_reset(), may then
simply experience an undefined behaviour.

The following patches in this series attempts to address this problem, by
reworking the mmc_hw_reset() behaviour for SDIO and by adopting the Marvel
mwifiex driver to these changes.

Note that, I don't have the HW at hand so the the code has only compile tested.
Test on HW is greatly appreciated!

Ulf Hansson (3):
  mwifiex: Re-work support for SDIO HW reset
  mmc: core: Drop check for mmc_card_is_removable() in mmc_rescan()
  mmc: core: Re-work HW reset for SDIO cards

 drivers/mmc/core/core.c                     | 12 +++-----
 drivers/mmc/core/core.h                     |  2 ++
 drivers/mmc/core/sdio.c                     | 28 ++++++++++++++++-
 drivers/mmc/core/sdio_bus.c                 |  9 +++++-
 drivers/net/wireless/marvell/mwifiex/main.c |  6 +++-
 drivers/net/wireless/marvell/mwifiex/main.h |  1 +
 drivers/net/wireless/marvell/mwifiex/sdio.c | 33 ++++++++++++++-------
 include/linux/mmc/card.h                    |  1 +
 8 files changed, 70 insertions(+), 22 deletions(-)

-- 
2.17.1