From: Jilin Yuan <yuanjilin@cdjrlc.com>
To: gregory.greenman@intel.com, kvalo@kernel.org,
davem@davemloft.net, edumazet@google.com, kuba@kernel.org,
pabeni@redhat.com, keescook@chromium.org
Cc: linux-wireless@vger.kernel.org, netdev@vger.kernel.org,
linux-kernel@vger.kernel.org, Jilin Yuan <yuanjilin@cdjrlc.com>
Subject: [PATCH] wifi: api: fix repeated words in comments
Date: Sat, 9 Jul 2022 22:03:47 +0800 [thread overview]
Message-ID: <20220709140347.52290-1-yuanjilin@cdjrlc.com> (raw)
Delete the redundant word 'the'.
Delete the redundant word 'to'.
Delete the redundant word 'be'.
Signed-off-by: Jilin Yuan <yuanjilin@cdjrlc.com>
---
drivers/net/wireless/intel/iwlwifi/fw/api/power.h | 2 +-
drivers/net/wireless/intel/iwlwifi/fw/api/time-event.h | 2 +-
drivers/net/wireless/intel/iwlwifi/fw/api/tx.h | 4 ++--
3 files changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/net/wireless/intel/iwlwifi/fw/api/power.h b/drivers/net/wireless/intel/iwlwifi/fw/api/power.h
index f92cac1da764..d05a8e2fab30 100644
--- a/drivers/net/wireless/intel/iwlwifi/fw/api/power.h
+++ b/drivers/net/wireless/intel/iwlwifi/fw/api/power.h
@@ -575,7 +575,7 @@ struct iwl_sar_offset_mapping_cmd {
* regardless of whether its temerature has been changed.
* @bf_enable_beacon_filter: 1, beacon filtering is enabled; 0, disabled.
* @bf_debug_flag: beacon filtering debug configuration
- * @bf_escape_timer: Send beacons to to driver if no beacons were passed
+ * @bf_escape_timer: Send beacons to driver if no beacons were passed
* for a specific period of time. Units: Beacons.
* @ba_escape_timer: Fully receive and parse beacon if no beacons were passed
* for a longer period of time then this escape-timeout. Units: Beacons.
diff --git a/drivers/net/wireless/intel/iwlwifi/fw/api/time-event.h b/drivers/net/wireless/intel/iwlwifi/fw/api/time-event.h
index 904cd78a9fa0..019bf23ebffc 100644
--- a/drivers/net/wireless/intel/iwlwifi/fw/api/time-event.h
+++ b/drivers/net/wireless/intel/iwlwifi/fw/api/time-event.h
@@ -359,7 +359,7 @@ struct iwl_hs20_roc_res {
* listen mode. Will be fragmented. Valid only on the P2P Device MAC.
* Valid only on the P2P Device MAC. The firmware will take into account
* the duration, the interval and the repetition count.
- * @SESSION_PROTECT_CONF_P2P_GO_NEGOTIATION: Schedule the P2P Device to be be
+ * @SESSION_PROTECT_CONF_P2P_GO_NEGOTIATION: Schedule the P2P Device to be
* able to run the GO Negotiation. Will not be fragmented and not
* repetitive. Valid only on the P2P Device MAC. Only the duration will
* be taken into account.
diff --git a/drivers/net/wireless/intel/iwlwifi/fw/api/tx.h b/drivers/net/wireless/intel/iwlwifi/fw/api/tx.h
index ecc6706f66ed..194de9545989 100644
--- a/drivers/net/wireless/intel/iwlwifi/fw/api/tx.h
+++ b/drivers/net/wireless/intel/iwlwifi/fw/api/tx.h
@@ -200,7 +200,7 @@ enum iwl_tx_offload_assist_bz {
* cleared. Combination of RATE_MCS_*
* @sta_id: index of destination station in FW station table
* @sec_ctl: security control, TX_CMD_SEC_*
- * @initial_rate_index: index into the the rate table for initial TX attempt.
+ * @initial_rate_index: index into the rate table for initial TX attempt.
* Applied if TX_CMD_FLG_STA_RATE_MSK is set, normally 0 for data frames.
* @reserved2: reserved
* @key: security key
@@ -858,7 +858,7 @@ struct iwl_extended_beacon_notif {
/**
* enum iwl_dump_control - dump (flush) control flags
- * @DUMP_TX_FIFO_FLUSH: Dump MSDUs until the the FIFO is empty
+ * @DUMP_TX_FIFO_FLUSH: Dump MSDUs until the FIFO is empty
* and the TFD queues are empty.
*/
enum iwl_dump_control {
--
2.36.1
next reply other threads:[~2022-07-09 14:31 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-07-09 14:03 Jilin Yuan [this message]
2022-07-09 16:35 ` [PATCH] wifi: api: fix repeated words in comments Joe Perches
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20220709140347.52290-1-yuanjilin@cdjrlc.com \
--to=yuanjilin@cdjrlc.com \
--cc=davem@davemloft.net \
--cc=edumazet@google.com \
--cc=gregory.greenman@intel.com \
--cc=keescook@chromium.org \
--cc=kuba@kernel.org \
--cc=kvalo@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-wireless@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).