linux-wireless.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: "Heiko Stübner" <heiko@sntech.de>
To: Soeren Moch <smoch@web.de>
Cc: Kalle Valo <kvalo@codeaurora.org>,
	linux-wireless@vger.kernel.org,
	brcm80211-dev-list.pdl@broadcom.com,
	brcm80211-dev-list@cypress.com, netdev@vger.kernel.org,
	linux-arm-kernel@lists.infradead.org,
	linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH 8/8] arm64: dts: rockchip: RockPro64: enable wifi module at sdio0
Date: Tue, 10 Dec 2019 00:08:37 +0100	[thread overview]
Message-ID: <2668270.pdtvSLGib8@diego> (raw)
In-Reply-To: <20191209223822.27236-8-smoch@web.de>

Hi Soeren,

Am Montag, 9. Dezember 2019, 23:38:22 CET schrieb Soeren Moch:
> RockPro64 supports an Ampak AP6359SA based wifi/bt combo module.
> The BCM4359/9 wifi controller in this module is connected to sdio0,
> enable this interface.
> 
> Signed-off-by: Soeren Moch <smoch@web.de>
> ---
> Not sure where to place exactly the sdio0 node in the dts because
> existing sd nodes are not sorted alphabetically.
> 
> This last patch in this brcmfmac patch series probably should be picked
> up by Heiko independently of the rest of this series. It was sent together
> to show how this brcmfmac extension for 4359-sdio support with RSDB is
> used and tested.

node placement looks good so I can apply it, just a general questions
I only got patch 8/8 are patches 1-7 relevant for this one and what are they?

Thanks
Heiko


> 
> Cc: Heiko Stuebner <heiko@sntech.de>
> Cc: Kalle Valo <kvalo@codeaurora.org>
> Cc: linux-wireless@vger.kernel.org
> Cc: brcm80211-dev-list.pdl@broadcom.com
> Cc: brcm80211-dev-list@cypress.com
> Cc: netdev@vger.kernel.org
> Cc: linux-arm-kernel@lists.infradead.org
> Cc: linux-rockchip@lists.infradead.org
> Cc: linux-kernel@vger.kernel.org
> ---
>  .../boot/dts/rockchip/rk3399-rockpro64.dts    | 21 ++++++++++++-------
>  1 file changed, 14 insertions(+), 7 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts b/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
> index 7f4b2eba31d4..9fa92790d6e0 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dts
> @@ -71,13 +71,6 @@
>  		clock-names = "ext_clock";
>  		pinctrl-names = "default";
>  		pinctrl-0 = <&wifi_enable_h>;
> -
> -		/*
> -		 * On the module itself this is one of these (depending
> -		 * on the actual card populated):
> -		 * - SDIO_RESET_L_WL_REG_ON
> -		 * - PDN (power down when low)
> -		 */
>  		reset-gpios = <&gpio0 RK_PB2 GPIO_ACTIVE_LOW>;
>  	};
> 
> @@ -650,6 +643,20 @@
>  	status = "okay";
>  };
> 
> +&sdio0 {
> +	bus-width = <4>;
> +	cap-sd-highspeed;
> +	cap-sdio-irq;
> +	disable-wp;
> +	keep-power-in-suspend;
> +	mmc-pwrseq = <&sdio_pwrseq>;
> +	non-removable;
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&sdio0_bus4 &sdio0_cmd &sdio0_clk>;
> +	sd-uhs-sdr104;
> +	status = "okay";
> +};
> +
>  &sdmmc {
>  	bus-width = <4>;
>  	cap-sd-highspeed;
> --
> 2.17.1
> 





  reply	other threads:[~2019-12-09 23:08 UTC|newest]

Thread overview: 27+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-12-09 22:38 [PATCH 1/8] brcmfmac: reset two D11 cores if chip has two D11 cores Soeren Moch
2019-12-09 22:38 ` [PATCH 2/8] brcmfmac: set F2 blocksize and watermark for 4359 Soeren Moch
2019-12-10  3:37   ` Chi-Hsien Lin
2019-12-09 22:38 ` [PATCH 3/8] brcmfmac: fix rambase for 4359/9 Soeren Moch
2019-12-09 22:38 ` [PATCH 4/8] brcmfmac: make errors when setting roaming parameters non-fatal Soeren Moch
2019-12-10  3:37   ` Chi-Hsien Lin
2019-12-09 22:38 ` [PATCH 5/8] brcmfmac: add support for BCM4359 SDIO chipset Soeren Moch
2019-12-10  3:38   ` Chi-Hsien Lin
2019-12-10  6:32     ` Chi-Hsien Lin
2019-12-10 10:12       ` Soeren Moch
2019-12-09 22:38 ` [PATCH 6/8] brcmfmac: add RSDB condition when setting interface combinations Soeren Moch
2019-12-10  3:38   ` Chi-Hsien Lin
2019-12-09 22:38 ` [PATCH 7/8] brcmfmac: not set mbss in vif if firmware does not support MBSS Soeren Moch
2019-12-10  3:38   ` Chi-Hsien Lin
2019-12-09 22:38 ` [PATCH 8/8] arm64: dts: rockchip: RockPro64: enable wifi module at sdio0 Soeren Moch
2019-12-09 23:08   ` Heiko Stübner [this message]
2019-12-09 23:29     ` Soeren Moch
2019-12-10  1:18       ` Heiko Stübner
2019-12-10  9:14         ` Kalle Valo
2019-12-10 10:08         ` Soeren Moch
2019-12-10 10:13           ` Heiko Stübner
     [not found]             ` <5d3bde69-9102-cc81-c1d2-d71b60258906@web.de>
2019-12-11 15:50               ` Soeren Moch
     [not found]         ` <0101016eef171394-2c71e1b8-45b9-4e38-96f9-2841dd0607ba-000000@us-west-2.amazonses.com>
2019-12-10 10:15           ` Soeren Moch
2019-12-10  3:36 ` [PATCH 1/8] brcmfmac: reset two D11 cores if chip has two D11 cores Chi-Hsien Lin
2019-12-10  9:08 ` Kalle Valo
     [not found] ` <0101016eef117d24-d6de85e6-6356-4c73-bff4-f787e8c982bc-000000@us-west-2.amazonses.com>
2019-12-10 10:14   ` Soeren Moch
2019-12-10 10:20     ` Kalle Valo

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=2668270.pdtvSLGib8@diego \
    --to=heiko@sntech.de \
    --cc=brcm80211-dev-list.pdl@broadcom.com \
    --cc=brcm80211-dev-list@cypress.com \
    --cc=kvalo@codeaurora.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-rockchip@lists.infradead.org \
    --cc=linux-wireless@vger.kernel.org \
    --cc=netdev@vger.kernel.org \
    --cc=smoch@web.de \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).