From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from relais.videotron.ca ([24.201.245.36]:43992 "EHLO relais.videotron.ca" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1751140Ab0GYN5O (ORCPT ); Sun, 25 Jul 2010 09:57:14 -0400 MIME-version: 1.0 Content-type: TEXT/PLAIN; charset=US-ASCII Date: Sun, 25 Jul 2010 09:56:28 -0400 (EDT) From: Nicolas Pitre To: Ohad Ben-Cohen Cc: Roger Quadros , "linux-wireless@vger.kernel.org" , "linux-mmc@vger.kernel.org" , "linux-omap@vger.kernel.org" , "linux-arm-kernel@lists.infradead.org" , "linux@arm.linux.org.uk" , Chikkature Rajashekar Madhusudhan , "Coelho Luciano (Nokia-MS/Helsinki)" , "akpm@linux-foundation.org" , San Mehat , Tony Lindgren , Pandita Vikram , Kalle Valo Subject: Re: [PATCH v2 18/20] mmc: sdio: enable a default power off mode of the card In-reply-to: Message-id: References: <1279733634-21974-1-git-send-email-ohad@wizery.com> <1279733634-21974-19-git-send-email-ohad@wizery.com> <4C482D01.1040109@nokia.com> Sender: linux-wireless-owner@vger.kernel.org List-ID: On Sun, 25 Jul 2010, Ohad Ben-Cohen wrote: > On Thu, Jul 22, 2010 at 2:35 PM, Roger Quadros wrote: > > On 07/21/2010 08:33 PM, ext Ohad Ben-Cohen wrote: > >> > >> Add support for an SDIO device to stay powered off even without > >> the presence of an SDIO function driver. A host should explicitly > >> ask for it by means of MMC_CAP_DONT_POWER_CARD, and the SDIO > >> function driver should know it needs to call sdio_claim_power > >> before accessing the device. > >> > >> Signed-off-by: Ohad Ben-Cohen > > > > Shouldn't this be the default behaviour? If there is no function driver for > > any of the functions of the card, then sdio core shold power off the card. > > > > I don't see a need for a special capability flag for this. > > > > in fact MMC_CAP_DONT_POWER_CARD does not seem like an mmc host's capability > > Totally agree. > > I didn't want to change the current behavior of the cards/funcs so I > looked for a way to explicitly power down only specific cards. > > Alternatively we could power down all cards at the end > mmc_attach_sdio, and then power them up selectively in sdio_bus_probe, > just before calling probe. If the probe succeeds, the function driver > takes over. If the probe fails, we can power them down again. Exactly! > Is that what you meant ? > > This would work both if the sdio function driver is already loaded, or > will only be loaded at a later time. But I'm not too fond of the extra > power on/off cycles that it will introduce for each card.. This is still way better than introducing knowledge about specific cards in the host drivers. Nicolas