[PATCH v2 38/47] iwlwifi: add an extra firmware state in the transport

[Luca Coelho <luca@coelho.fi>]

From: Johannes Berg <johannes.berg@intel.com>

Start tracking not just if the firmware is dead or alive,
but also if it's starting.

Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
---
 drivers/net/wireless/intel/iwlwifi/iwl-trans.h | 18 +++++++++++++-----
 1 file changed, 13 insertions(+), 5 deletions(-)

diff --git a/drivers/net/wireless/intel/iwlwifi/iwl-trans.h b/drivers/net/wireless/intel/iwlwifi/iwl-trans.h
index 7b244cdeb185..2c9dd3ff21eb 100644
--- a/drivers/net/wireless/intel/iwlwifi/iwl-trans.h
+++ b/drivers/net/wireless/intel/iwlwifi/iwl-trans.h
@@ -590,12 +590,14 @@ struct iwl_trans_ops {
 /**
  * enum iwl_trans_state - state of the transport layer
  *
- * @IWL_TRANS_NO_FW: no fw has sent an alive response
- * @IWL_TRANS_FW_ALIVE: a fw has sent an alive response
+ * @IWL_TRANS_NO_FW: firmware wasn't started yet, or crashed
+ * @IWL_TRANS_FW_STARTED: FW was started, but not alive yet
+ * @IWL_TRANS_FW_ALIVE: FW has sent an alive response
  */
 enum iwl_trans_state {
-	IWL_TRANS_NO_FW = 0,
-	IWL_TRANS_FW_ALIVE	= 1,
+	IWL_TRANS_NO_FW,
+	IWL_TRANS_FW_STARTED,
+	IWL_TRANS_FW_ALIVE,
 };
 
 /**
@@ -1025,12 +1027,18 @@ static inline int iwl_trans_start_fw(struct iwl_trans *trans,
 				     const struct fw_img *fw,
 				     bool run_in_rfkill)
 {
+	int ret;
+
 	might_sleep();
 
 	WARN_ON_ONCE(!trans->rx_mpdu_cmd);
 
 	clear_bit(STATUS_FW_ERROR, &trans->status);
-	return trans->ops->start_fw(trans, fw, run_in_rfkill);
+	ret = trans->ops->start_fw(trans, fw, run_in_rfkill);
+	if (ret == 0)
+		trans->state = IWL_TRANS_FW_STARTED;
+
+	return ret;
 }
 
 static inline void iwl_trans_stop_device(struct iwl_trans *trans)
-- 
2.29.2