Re: [PATCH v6 1/3] phy: core: Reword the comment specifying the units of max_link_rate to be Mbps

[Aswath Govindraju <a-govindraju@ti.com>]

Hi Vinod,

On 31/05/21 2:04 pm, Aswath Govindraju wrote:
> Hi Vinod,
> 
> On 31/05/21 12:48 pm, Vinod Koul wrote:
>> On 10-05-21, 10:40, Aswath Govindraju wrote:
>>> In some subsystems (eg. CAN, SPI), the max link rate supported can be less
>>> than 1 Mbps and if the unit for max_link_rate is Mbps then it can't be
>>> used. Therefore, leave the decision of units to be used, to the producer
>>> and consumer.
>>>
>>> Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
>>> Acked-by: Marc Kleine-Budde <mkl@pengutronix.de>
>>> ---
>>>  include/linux/phy/phy.h | 2 +-
>>>  1 file changed, 1 insertion(+), 1 deletion(-)
>>>
>>> diff --git a/include/linux/phy/phy.h b/include/linux/phy/phy.h
>>> index 0ed434d02196..f3286f4cd306 100644
>>> --- a/include/linux/phy/phy.h
>>> +++ b/include/linux/phy/phy.h
>>> @@ -125,7 +125,7 @@ struct phy_ops {
>>>  /**
>>>   * struct phy_attrs - represents phy attributes
>>>   * @bus_width: Data path width implemented by PHY
>>> - * @max_link_rate: Maximum link rate supported by PHY (in Mbps)
>>> + * @max_link_rate: Maximum link rate supported by PHY (units to be decided by producer and consumer)
>>
>> So there are a few users of max_link_rate. It would be better that we
>> document all previous users of max_link_rate that unit is in Mbps and
>> then modify it here
>>
> 
> I was able to see that the max_link_rate attribute was used at,
> 
> drivers/phy/cadence/phy-cadence-torrent.c:2514:
> gphy->attrs.max_link_rate = cdns_phy->max_bit_rate;
> 
> and in the bindings there is indication that the units to be used is Mbps.
> 
> Can you please point me if there is any other place that I might have
> missed to look at or that might need documentation update?
> 

May I know if this patch series is good to be merged ?

Thanks,
Aswath

> Thanks,
> Aswath
> 
>