Re: Linux 2.6.29-rc6

[john stultz <johnstul@us.ibm.com>]

On Thu, 2009-03-05 at 09:43 +0100, Ingo Molnar wrote:
> * john stultz <johnstul@us.ibm.com> wrote:
> 
> > > Ingo, Thomas: On the hardware I'm testing the fast-pit 
> > > calibration only triggers probably 80-90% of the time. About 
> > > 10-20% of the time, the initial check to 
> > > pit_expect_msb(0xff) fails (count=0), so we may need to look 
> > > more at this approach.
> 
> We definitely need to improve calibration quality.
> 
> The question is - why does fast-calibration fail 10-20% of the 
> time on your test-system? Also, why exactly do we miscalibrate? 
> Could you please have a look at that?

Working on it, I just wanted to let you know I was seeing some different
odd behavior then Jesper.

> One theory would be that the PIT readout is unreliable. Windows 
> does not make use of it, so it's not the most tested aspect of 
> the PIT. Is that what happens on your box?

Still looking into it, but from my initial debugging it seems that by
reading the PIT very quickly after setting it, we may be getting junk
values. If I re-read the PIT again, I see the expected 0xff value. 

Its been somewhat of a heisenbug, as if I add any printk's or even just
a mb() after the outb it seems to make the problem go away (or just rare
enough I don't have the patience to reproduce it :)

So I don't know if a small delay is appropriate here (seems counter
productive to the whole fast-pit calibration ;) or if we should just try
to catch these bad reads and try again before failing?

Thoughts?

thanks
-john