Re: [net-next RFC V5 5/5] virtio_net: support negotiating the number of queues through ctrl vq

[Sasha Levin <levinsasha928@gmail.com>]

On Fri, 2012-07-06 at 11:20 +0800, Jason Wang wrote:
> On 07/05/2012 08:51 PM, Sasha Levin wrote:
> > On Thu, 2012-07-05 at 18:29 +0800, Jason Wang wrote:
> >> @@ -1387,6 +1404,10 @@ static int virtnet_probe(struct virtio_device *vdev)
> >>          if (virtio_has_feature(vdev, VIRTIO_NET_F_CTRL_VQ))
> >>                  vi->has_cvq = true;
> >>
> >> +       /* Use single tx/rx queue pair as default */
> >> +       vi->num_queue_pairs = 1;
> >> +       vi->total_queue_pairs = num_queue_pairs;
> > The code is using this "default" even if the amount of queue pairs it
> > wants was specified during initialization. This basically limits any
> > device to use 1 pair when starting up.
> >
> 
> Yes, currently the virtio-net driver would use 1 txq/txq by default 
> since multiqueue may not outperform in all kinds of workload. So it's 
> better to keep it as default and let user enable multiqueue by ethtool -L.

I think it makes sense to set it to 1 if the amount of initial queue
pairs wasn't specified.

On the other hand, if a virtio-net driver was probed to provide
VIRTIO_NET_F_MULTIQUEUE and has set something reasonable in
virtio_net_config.num_queues, then that setting shouldn't be quietly
ignored and reset back to 1.

What I'm basically saying is that I agree that the *default* should be 1
- but if the user has explicitly asked for something else during
initialization, then the default should be overridden.