On Tue, 2012-09-11 at 11:48 +0300, Dan Carpenter wrote:
> On Mon, Sep 10, 2012 at 10:51:46AM +0200, Samuel Iglesias Gonsálvez wrote:
> > From: Jens Taprogge <jens.taprogge@taprogge.org>
> > 
> > Reading the ID space at 8 MHz is always supported.  Most carriers will
> > boot up in 8MHz mode.  Still, play it safe and ensure we are operating at
> > 8Mhz.
> > 
> > Signed-off-by: Jens Taprogge <jens.taprogge@taprogge.org>
> > Signed-off-by: Samuel Iglesias Gonsálvez <siglesias@igalia.com>
> > ---
> >  drivers/staging/ipack/ipack.c |   11 ++++++++---
> >  1 file changed, 8 insertions(+), 3 deletions(-)
> > 
> > diff --git a/drivers/staging/ipack/ipack.c b/drivers/staging/ipack/ipack.c
> > index 4f3c945..95f56b8 100644
> > --- a/drivers/staging/ipack/ipack.c
> > +++ b/drivers/staging/ipack/ipack.c
> > @@ -376,6 +376,9 @@ struct ipack_device *ipack_device_register(struct ipack_bus_device *bus,
> >  	dev_set_name(&dev->dev,
> >  		     "ipack-dev.%u.%u", dev->bus_nr, dev->slot);
> >  
> > +	if (bus->ops->set_clockrate(dev, 8))
> > +		dev_warn(&dev->dev, "failed to switch to 8 MHz operation for reading of device ID.\n");
> > +
> >  	ret = ipack_device_read_id(dev);
> >  	if (ret < 0) {
> >  		dev_err(&dev->dev, "error reading device id section.\n");
> > @@ -384,9 +387,11 @@ struct ipack_device *ipack_device_register(struct ipack_bus_device *bus,
> >  	}
> >  
> >  	/* if the device supports 32 MHz operation, use it. */
> > -	ret = bus->ops->set_clockrate(dev, dev->speed_32mhz ? 32 : 8);
> > -	if (ret < 0)
> > -		dev_err(&dev->dev, "failed to switch to 32 MHz operation.\n");
> > +	if (dev->speed_32mhz) {
> > +		ret = bus->ops->set_clockrate(dev, 32);
> > +		if (ret < 0)
> > +			dev_err(&dev->dev, "failed to switch to 32 MHz operation.\n");
> > +	}
> 
> Ah.  Well done.  That's what I suggested earlier.  I think you
> should get rid of the ->speed_8mhz all together.

I will do it in a follow-up patch. The rest of suggestions have been
integrated in the patches. I will submit the patches very soon.

Thanks,

Sam