From: Lee Jones <lee.jones@linaro.org>
To: linux-arm-kernel@lists.infradead.org,
linux-kernel@vger.kernel.org, dwmw2@infradead.org,
linux-mtd@lists.infradead.org, angus.clark@st.com
Cc: linus.walleij@linaro.org
Subject: [PATCH 00/23] mtd: st_spi_fsm: Add new device
Date: Fri, 22 Nov 2013 16:22:37 +0000 [thread overview]
Message-ID: <1385137380-28968-1-git-send-email-lee.jones@linaro.org> (raw)
The first bunch of these patches have been on the MLs before, but
didn't receive a great deal of attention for the most part. We are
a little more featureful this time however. We can now successfully
setup and configure the N25Q256. We still can't read/write/erase
it though. I'll start work on that next week and will provide it in
the next instalment.
arch/arm/boot/dts/stih416-b2105.dts | 14 +++
arch/arm/boot/dts/stih416-pinctrl.dtsi | 12 ++
drivers/mtd/devices/Kconfig | 7 ++
drivers/mtd/devices/Makefile | 1 +
drivers/mtd/devices/serial_flash_cmds.h | 91 ++++++++++++++
drivers/mtd/devices/st_spi_fsm.c | 737 ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
drivers/mtd/devices/st_spi_fsm.h | 419 ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
7 files changed, 1281 insertions(+)
next reply other threads:[~2013-11-22 16:23 UTC|newest]
Thread overview: 31+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-11-22 16:22 Lee Jones [this message]
2013-11-22 16:22 ` [PATCH 01/23] mtd: st_spi_fsm: Allocate resources and register with MTD framework Lee Jones
2013-11-22 16:22 ` [PATCH 02/23] mtd: st_spi_fsm: Supply all register address and bit logic defines Lee Jones
2013-11-22 16:22 ` [PATCH 03/23] mtd: st_spi_fsm: Initialise and configure the FSM for normal working conditions Lee Jones
2013-11-22 16:22 ` [PATCH 04/23] mtd: st_spi_fsm: Supply framework for device requests Lee Jones
2013-11-22 16:22 ` [PATCH 05/23] mtd: st_spi_fsm: Supply a method to read from the FSM's FIFO Lee Jones
2013-11-22 16:22 ` [PATCH 06/23] mtd: st_spi_fsm: Supply defines for the possible flash command opcodes Lee Jones
2013-11-22 16:22 ` [PATCH 07/23] mtd: st_spi_fsm: Add support for JEDEC ID extraction Lee Jones
2013-11-22 16:22 ` [PATCH 08/23] mtd: devices: Provide header for shared OPCODEs and SFDP commands Lee Jones
2013-11-22 16:22 ` [PATCH 09/23] mtd: st_spi_fsm: Provide device look-up table Lee Jones
2013-11-22 16:22 ` [PATCH 10/23] mtd: st_spi_fsm: Dynamically setup flash device based on JEDEC ID Lee Jones
2013-11-22 16:22 ` [PATCH 11/23] ARM: STi: Add support for the FSM Serial Flash Controller Lee Jones
2013-11-22 16:22 ` [PATCH 12/23] mtd: st_spi_fsm: Search for preferred FSM message sequence configurations Lee Jones
2013-11-22 16:22 ` [PATCH 13/23] mtd: st_spi_fsm: Fetch platform specific configurations Lee Jones
2013-11-22 16:22 ` [PATCH 14/23] mtd: st_spi_fsm: Prepare the read/write FSM message sequence(s) Lee Jones
2013-11-22 16:22 ` [PATCH 15/23] mtd: st_spi_fsm: Fetch boot-device from mode pins Lee Jones
2013-11-22 16:22 ` [PATCH 16/23] mtd: st_spi_fsm: Provide the erase one sector sequence Lee Jones
2013-11-22 16:22 ` [PATCH 17/23] mtd: st_spi_fsm: Provide the sequence for enabling 32bit addressing mode Lee Jones
2013-11-22 16:22 ` [PATCH 18/23] mtd: st_spi_fsm: Prepare read/write sequences according to configuration Lee Jones
2013-11-22 16:22 ` [PATCH 19/23] mtd: st_spi_fsm: Add a check to if the chip can handle an SoC reset Lee Jones
2013-11-22 16:22 ` [PATCH 20/23] mtd: st_spi_fsm: Provide a method to put the chip into 32bit addressing mode Lee Jones
2013-11-22 16:22 ` [PATCH 21/23] mtd: st_spi_fsm: Update the flash Volatile Configuration Register Lee Jones
2013-11-22 16:22 ` [PATCH 22/23] mtd: st_spi_fsm: Provide the default read/write configurations Lee Jones
2013-11-22 16:23 ` [PATCH 23/23] mtd: st_spi_fsm: Supply the N25Qxxx specific read configurations Lee Jones
2013-11-27 4:07 ` [PATCH 00/23] mtd: st_spi_fsm: Add new device Brian Norris
2013-11-27 11:52 ` Lee Jones
2013-11-28 3:34 ` Huang Shijie
2013-11-28 9:07 ` Angus Clark
2013-11-28 9:29 ` Lee Jones
2013-11-29 11:05 ` Huang Shijie
2013-11-29 11:53 ` Lee Jones
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1385137380-28968-1-git-send-email-lee.jones@linaro.org \
--to=lee.jones@linaro.org \
--cc=angus.clark@st.com \
--cc=dwmw2@infradead.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).