[PATCH v5 10/46] leds: pwm: use pwm_get_args() where appropriate

[Boris Brezillon <boris.brezillon@free-electrons.com>]

The PWM framework has clarified the concept of reference PWM config
(the platform dependent config retrieved from the DT or the PWM
lookup table) and real PWM state.

Use pwm_get_args() when the PWM user wants to retrieve this reference
config and not the current state.

This is part of the rework allowing the PWM framework to support
hardware readout and expose real PWM state even when the PWM has
just been requested (before the user calls pwm_config/enable/disable()).

Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com>
---
 drivers/leds/leds-pwm.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/leds/leds-pwm.c b/drivers/leds/leds-pwm.c
index 4783bac..b48231c 100644
--- a/drivers/leds/leds-pwm.c
+++ b/drivers/leds/leds-pwm.c
@@ -91,6 +91,7 @@ static int led_pwm_add(struct device *dev, struct led_pwm_priv *priv,
 		       struct led_pwm *led, struct device_node *child)
 {
 	struct led_pwm_data *led_data = &priv->leds[priv->num_leds];
+	struct pwm_args pargs = { };
 	int ret;
 
 	led_data->active_low = led->active_low;
@@ -117,7 +118,8 @@ static int led_pwm_add(struct device *dev, struct led_pwm_priv *priv,
 	else
 		led_data->cdev.brightness_set_blocking = led_pwm_set_blocking;
 
-	led_data->period = pwm_get_period(led_data->pwm);
+	pwm_get_args(led_data->pwm, &pargs);
+	led_data->period = pargs.period;
 	if (!led_data->period && (led->pwm_period_ns > 0))
 		led_data->period = led->pwm_period_ns;
 
-- 
2.5.0