From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S934928AbdCVON6 (ORCPT ); Wed, 22 Mar 2017 10:13:58 -0400 Received: from conuserg-07.nifty.com ([210.131.2.74]:47655 "EHLO conuserg-07.nifty.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S934436AbdCVOLW (ORCPT ); Wed, 22 Mar 2017 10:11:22 -0400 DKIM-Filter: OpenDKIM Filter v2.10.3 conuserg-07.nifty.com v2ME8LDJ010154 X-Nifty-SrcIP: [153.142.97.92] From: Masahiro Yamada To: linux-mtd@lists.infradead.org Cc: laurent.monat@idquantique.com, thorsten.christiansson@idquantique.com, Enrico Jorns , Jason Roberts , Artem Bityutskiy , Dinh Nguyen , Boris Brezillon , Marek Vasut , Brian Norris , Graham Moore , David Woodhouse , Masami Hiramatsu , Chuanxiao Dong , Jassi Brar , Masahiro Yamada , devicetree@vger.kernel.org, linux-kernel@vger.kernel.org, Richard Weinberger , Cyrille Pitchen , Rob Herring , Mark Rutland Subject: [PATCH v2 00/53] mtd: nand: denali: 2nd round of Denali NAND IP patch bomb Date: Wed, 22 Mar 2017 23:07:07 +0900 Message-Id: <1490191680-14481-1-git-send-email-yamada.masahiro@socionext.com> X-Mailer: git-send-email 2.7.4 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org It took a couple months to update this series, but finally here is v2. (v1: https://lkml.org/lkml/2016/11/26/144 ) This driver includes many problems. One of the biggest one is a bunch of hard-coded parameters. This IP has many parameters that can be customized when a delivery RTL is generated. However, this driver was upstreamed by Intel, with Intel parameters hard-coded. Later, Altera added denali_dt.c to use this driver for embedded boards, but they did not fix the code in denali.c So, this driver has never worked. Even some DT bindings actually turned out wrong. There are more problems: [1] The driver just retrieves the OOB area as-is whereas the controller uses syndrome page layout. [2] Many NAND chip specific parameters are hard-coded in the driver. [3] ONFi devices are not working [4] It can not read Bad Block Marker This patch series intends to solve those problems. Since v1, here are more fixes/improvements: - Fix raw/oob callbacks for syndrome page layout - Implement setup_data_interface() callback - Fix/implement more commands for ONFi devices - Allow to skip the driver internal bounce buffer - Support PIO in case DMA is not supported - Switch from ->cmdfunc over to ->cmd_ctrl Masahiro Yamada (53): mtd: nand: allow to set only one of ECC size and ECC strength from DT mtd: nand: use read_oob() instead of cmdfunc() for bad block check mtd: nand: denali: remove unused CONFIG option and macros mtd: nand: denali: remove redundant define of BANK(x) mtd: nand: denali: remove more unused struct members mtd: nand: denali: fix comment of denali_nand_info::flash_mem mtd: nand: denali: consolidate INTR_STATUS__* and INTR_EN__* macros mtd: nand: denali: introduce capability flag mtd: nand: denali: use int where no reason to use fixed width variable mtd: nand: denali: fix erased page checking mtd: nand: denali: fix bitflips calculation in handle_ecc() mtd: nand: denali: support HW_ECC_FIXUP capability mtd: nand: denali_dt: enable HW_ECC_FIXUP for Altera SOCFPGA variant mtd: nand: denali: support 64bit capable DMA engine mtd: nand: denali_dt: remove dma-mask DT property mtd: nand: denali_dt: use pdev instead of ofdev for platform_device mtd: nand: denali: allow to override revision number mtd: nand: denali: use nand_chip to hold frequently accessed data mtd: nand: denali: call nand_set_flash_node() to set DT node mtd: nand: denali: do not set mtd->name mtd: nand: denali: move multi device fixup code to a helper function mtd: nand: denali: simplify multi device fixup code mtd: nand: denali: set DEVICES_CONNECTED 1 if not set mtd: nand: denali: remove meaningless writes to read-only registers mtd: nand: denali: remove unnecessary writes to ECC_CORRECTION mtd: nand: denali: support 1024 byte ECC step size mtd: nand: denali: avoid hard-coding ecc.strength and ecc.bytes mtd: nand: denali: support "nand-ecc-strength" DT property mtd: nand: denali: remove Toshiba and Hynix specific fixup code mtd: nand: denali_dt: add compatible strings for UniPhier SoC variants mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS mtd: nand: denali: do not propagate NAND_STATUS_FAIL to waitfunc() mtd: nand: denali: use BIT() and GENMASK() for register macros mtd: nand: denali: remove unneeded find_valid_banks() mtd: nand: denali: handle timing parameters by setup_data_interface() mtd: nand: denali: remove meaningless pipeline read-ahead operation mtd: nand: denali: rework interrupt handling mtd: nand: denali: fix NAND_CMD_STATUS handling mtd: nand: denali: fix NAND_CMD_PARAM handling mtd: nand: do not check R/B# for CMD_READID in nand_command(_lp) mtd: nand: do not check R/B# for CMD_SET_FEATURES in nand_command(_lp) mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc mtd: nand: denali: fix bank reset function mtd: nand: denali: use interrupt instead of polling for bank reset mtd: nand: denali: propagate page to helpers via function argument mtd: nand: denali: merge struct nand_buf into struct denali_nand_info mtd: nand: denali: use flag instead of register macro for direction mtd: nand: denali: fix raw and oob accessors for syndrome page layout mtd: nand: denali: support hardware-assisted erased page detection mtd: nand: allocate aligned buffers if NAND_OWN_BUFFERS is unset mtd: nand: denali: skip driver internal bounce buffer when possible mtd: nand: denali: use non-managed kmalloc() for DMA buffer mtd: nand: denali: enable bad block table scan .../devicetree/bindings/mtd/denali-nand.txt | 24 +- drivers/mtd/nand/Kconfig | 11 - drivers/mtd/nand/denali.c | 2073 +++++++++----------- drivers/mtd/nand/denali.h | 453 ++--- drivers/mtd/nand/denali_dt.c | 104 +- drivers/mtd/nand/denali_pci.c | 10 +- drivers/mtd/nand/nand_base.c | 78 +- 7 files changed, 1278 insertions(+), 1475 deletions(-) -- 2.7.4