[PATCH v3 1/3] dt-bindings: display: bridge: Document THC63LVD1024 LVDS decoder

[Jacopo Mondi <jacopo+renesas@jmondi.org>]

Document Thine THC63LVD1024 LVDS decoder device tree bindings.

Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
---
 .../bindings/display/bridge/thine,thc63lvd1024.txt | 63 ++++++++++++++++++++++
 1 file changed, 63 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt

diff --git a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
new file mode 100644
index 0000000..5b5afcd
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
@@ -0,0 +1,63 @@
+Thine Electronics THC63LVD1024 LVDS decoder
+-------------------------------------------
+
+The THC63LVD1024 is a dual link LVDS receiver designed to convert LVDS streams
+to parallel data outputs. The chip supports single/dual input/output modes,
+handling up to two two input LVDS stream and up to two digital CMOS/TTL outputs.
+
+Required properties:
+- compatible: Shall be "thine,thc63lvd1024",
+
+Optional properties:
+- vcc-supply: Power supply for TTL output and digital circuitry
+- cvcc-supply: Power supply for TTL CLOCKOUT signal
+- lvcc-supply: Power supply for LVDS inputs
+- pvcc-supply: Power supply for PLL circuitry
+- pwnd-gpios: Power down GPIO signal. Active low.
+- oe-gpios: Output enable GPIO signal. Active high.
+
+The THC63LVD1024 video port connections are modeled according
+to OF graph bindings specified by Documentation/devicetree/bindings/graph.txt
+
+Required video port nodes:
+- Port@0: First LVDS input port
+- Port@2: First digital CMOS/TTL parallel output
+
+Optional video port nodes:
+- Port@1: Second LVDS input port
+- Port@3: Second digital CMOS/TTL parallel output
+
+Example:
+--------
+
+	thc63lvd1024: lvds-decoder {
+		compatible = "thine,thc63lvd1024";
+
+		vcc-supply = <&reg_lvds_vcc>;
+		lvcc-supply = <&reg_lvds_lvcc>;
+
+		pwdn-gpio = <&gpio4 15 GPIO_ACTIVE_LOW>;
+
+		ports {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			port@0 {
+				reg = <0>;
+
+				lvds_dec_in_0: endpoint {
+					remote-endpoint = <&lvds_out>;
+				};
+			};
+
+			port@2{
+				reg = <2>;
+
+				lvds_dec_out_2: endpoint {
+					remote-endpoint = <&adv7511_in>;
+				};
+
+			};
+
+		};
+	};
-- 
2.7.4