From: Lina Iyer <ilina@codeaurora.org>
To: swboyd@chromium.org, maz@kernel.org, linus.walleij@linaro.org,
bjorn.andersson@linaro.org
Cc: evgreen@chromium.org, linux-kernel@vger.kernel.org,
linux-arm-msm@vger.kernel.org, mkshah@codeaurora.org,
linux-gpio@vger.kernel.org, agross@kernel.org,
dianders@chromium.org, Lina Iyer <ilina@codeaurora.org>
Subject: [PATCH 00/12] Support wakeup capable GPIOs
Date: Thu, 14 Nov 2019 11:35:09 -0700 [thread overview]
Message-ID: <1573756521-27373-1-git-send-email-ilina@codeaurora.org> (raw)
Hi all,
Thanks for all the reviews.
Here is the next spin of the wakeup capable GPIO support. In order to
facilitate basic support available in the kernel, I have dropped the SPI
register configuration. The feature was added when this series was
restarted based on new hierarchy support in gpiolib. But, the SPI
configuration can be done in the firmware. This would avoid a whole lot
of code in linux that serve little to no purpose. Users of GPIO never
have the need to change the trigger type (level edge and vice-versa) and
the basic configuration can be set in the firmware before boot.
Changes in v1:
- Address review comments
- Add Reviewed-by tags
- Drop SPI config patches
- Rebase on top of Rajendra's PDC changes [6]
Changes in RFC v2[5]:
- Address review comments #3, #4, #6, #7, #8, #9, #10
- Rebased on top of linux-next GPIO latest patches [1],[3],[4]
- Increase PDC max irqs in #2 (avoid merge conflicts with
downstream)
- Add Reviewed-by #5
Please consider reviewing these patches.
Thanks,
Lina
[1].
https://lore.kernel.org/linux-gpio/20190808123242.5359-1-linus.walleij@linaro.org/
[2].
https://lkml.org/lkml/2019/5/7/1173
[3].
https://lore.kernel.org/r/20190819084904.30027-1-linus.walleij@linaro.org
[4].
https://lore.kernel.org/r/20190724083828.7496-1-linus.walleij@linaro.org
[5].
https://lore.kernel.org/linux-gpio/5da6b849.1c69fb81.a9b04.1b9f@mx.google.com/t/
[6].
https://lore.kernel.org/linux-arm-msm/d622482d92059533f03b65af26c69b9b@www.loen.fr/
Lina Iyer (10):
irqdomain: add bus token DOMAIN_BUS_WAKEUP
drivers: irqchip: qcom-pdc: update max PDC interrupts
drivers: irqchip: pdc: Do not toggle IRQ_ENABLE during mask/unmask
drivers: irqchip: add PDC irqdomain for wakeup capable GPIOs
of: irq: document properties for wakeup interrupt parent
drivers: pinctrl: msm: setup GPIO chip in hierarchy
drivers: pinctrl: sdm845: add PDC wakeup interrupt map for GPIOs
arm64: dts: qcom: add PDC interrupt controller for SDM845
arm64: dts: qcom: setup PDC as the wakeup parent for TLMM on SDM845
arm64: defconfig: enable PDC interrupt controller for Qualcomm SDM845
Maulik Shah (2):
genirq: Introduce irq_chip_get/set_parent_state calls
drivers: irqchip: pdc: Add irqchip set/get state calls
.../bindings/interrupt-controller/interrupts.txt | 12 ++
arch/arm64/boot/dts/qcom/sdm845.dtsi | 10 ++
arch/arm64/configs/defconfig | 1 +
drivers/irqchip/qcom-pdc.c | 147 +++++++++++++++++++--
drivers/pinctrl/qcom/pinctrl-msm.c | 113 ++++++++++++++++
drivers/pinctrl/qcom/pinctrl-msm.h | 16 +++
drivers/pinctrl/qcom/pinctrl-sdm845.c | 23 +++-
include/linux/irq.h | 6 +
include/linux/irqdomain.h | 1 +
include/linux/soc/qcom/irq.h | 34 +++++
kernel/irq/chip.c | 44 ++++++
11 files changed, 393 insertions(+), 14 deletions(-)
create mode 100644 include/linux/soc/qcom/irq.h
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
next reply other threads:[~2019-11-14 18:35 UTC|newest]
Thread overview: 34+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-11-14 18:35 Lina Iyer [this message]
2019-11-14 18:35 ` [PATCH 01/12] irqdomain: add bus token DOMAIN_BUS_WAKEUP Lina Iyer
2019-11-15 18:48 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 02/12] drivers: irqchip: qcom-pdc: update max PDC interrupts Lina Iyer
2019-11-15 18:48 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 03/12] drivers: irqchip: pdc: Do not toggle IRQ_ENABLE during mask/unmask Lina Iyer
2019-11-15 18:49 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 04/12] drivers: irqchip: add PDC irqdomain for wakeup capable GPIOs Lina Iyer
2019-11-15 19:03 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 05/12] of: irq: document properties for wakeup interrupt parent Lina Iyer
2019-11-15 19:03 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 06/12] genirq: Introduce irq_chip_get/set_parent_state calls Lina Iyer
2019-11-15 19:04 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 07/12] drivers: irqchip: pdc: Add irqchip set/get state calls Lina Iyer
2019-11-15 19:05 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 08/12] drivers: pinctrl: msm: setup GPIO chip in hierarchy Lina Iyer
2019-11-14 18:43 ` Linus Walleij
2019-11-14 18:57 ` Lina Iyer
2019-11-15 19:33 ` Stephen Boyd
2019-11-15 20:55 ` Lina Iyer
2019-11-15 21:57 ` Lina Iyer
2019-11-15 22:09 ` Stephen Boyd
2019-11-15 22:13 ` Lina Iyer
2019-11-14 18:35 ` [PATCH 09/12] drivers: pinctrl: sdm845: add PDC wakeup interrupt map for GPIOs Lina Iyer
2019-11-15 19:33 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 10/12] arm64: dts: qcom: add PDC interrupt controller for SDM845 Lina Iyer
2019-11-15 19:34 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 11/12] arm64: dts: qcom: setup PDC as the wakeup parent for TLMM on SDM845 Lina Iyer
2019-11-15 19:34 ` Stephen Boyd
2019-11-14 18:35 ` [PATCH 12/12] arm64: defconfig: enable PDC interrupt controller for Qualcomm SDM845 Lina Iyer
2019-11-15 19:34 ` Stephen Boyd
2019-11-15 10:08 ` [PATCH 00/12] Support wakeup capable GPIOs Marc Zyngier
2019-11-15 16:20 ` Lina Iyer
2019-11-15 19:35 ` Stephen Boyd
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1573756521-27373-1-git-send-email-ilina@codeaurora.org \
--to=ilina@codeaurora.org \
--cc=agross@kernel.org \
--cc=bjorn.andersson@linaro.org \
--cc=dianders@chromium.org \
--cc=evgreen@chromium.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=maz@kernel.org \
--cc=mkshah@codeaurora.org \
--cc=swboyd@chromium.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).