[PATCH v5,1/5] drm/mediatek: Adjust the timing of mipi signal from LP00 to LP11

[<xinlei.lee@mediatek.com>]

From: Jitao Shi <jitao.shi@mediatek.com>

Old sequence:
1. Pull the MIPI signal high
2. Delay & Dsi_reset
3. Set the dsi timing register
4. dsi clk & lanes leave ulp mode and enter hs mode

The sequence after patching is:
1. Set the dsi timing register
2. Pull the MIPI signal high
3. Delay & Dsi_reset
4. dsi clk & lanes leave ulp mode and enter hs mode

Fixes: 75374fc2c152 ("drm/mediatek: add dphy reset after setting lanes number")

Signed-off-by: Jitao Shi <jitao.shi@mediatek.com>
Signed-off-by: Xinlei Lee <xinlei.lee@mediatek.com>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Reviewed-by: Rex-BC Chen <rex-bc.chen@mediatek.com>
---
 drivers/gpu/drm/mediatek/mtk_dsi.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/mediatek/mtk_dsi.c b/drivers/gpu/drm/mediatek/mtk_dsi.c
index bd3f5b485085..02e31a7d9257 100644
--- a/drivers/gpu/drm/mediatek/mtk_dsi.c
+++ b/drivers/gpu/drm/mediatek/mtk_dsi.c
@@ -661,14 +661,14 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi)
 	mtk_dsi_reset_engine(dsi);
 	mtk_dsi_phy_timconfig(dsi);
 
-	mtk_dsi_rxtx_control(dsi);
-	usleep_range(30, 100);
-	mtk_dsi_reset_dphy(dsi);
 	mtk_dsi_ps_control_vact(dsi);
 	mtk_dsi_set_vm_cmd(dsi);
 	mtk_dsi_config_vdo_timing(dsi);
 	mtk_dsi_set_interrupt_enable(dsi);
 
+	mtk_dsi_rxtx_control(dsi);
+	usleep_range(30, 100);
+	mtk_dsi_reset_dphy(dsi);
 	mtk_dsi_clk_ulp_mode_leave(dsi);
 	mtk_dsi_lane0_ulp_mode_leave(dsi);
 	mtk_dsi_clk_hs_mode(dsi, 0);
-- 
2.18.0