Re: [PATCHv2] fpga: stratix10-soc: remove the pre-set reconfiguration condition

[Richard Gong <richard.gong@linux.intel.com>]

Hi Moritz,

Sorry for asking.

When you get chance, can you review my version 2 patch submitted on 
05/15/20?

Regards,
Richard

On 5/15/20 9:35 AM, richard.gong@linux.intel.com wrote:
> From: Richard Gong <richard.gong@intel.com>
> 
> The reconfiguration mode is pre-set by driver as the full reconfiguration.
> As a result, user have to change code and recompile the drivers if he or
> she wants to perform a partial reconfiguration. Removing the pre-set
> reconfiguration condition so that user can select full or partial
> reconfiguration via overlay device tree without recompiling the drivers.
> 
> Also add an error message if the configuration request is failure.
> 
> Signed-off-by: Richard Gong <richard.gong@intel.com>
> ---
> v2: define and use constant values
> ---
>   drivers/fpga/stratix10-soc.c | 9 +++++++--
>   1 file changed, 7 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/fpga/stratix10-soc.c b/drivers/fpga/stratix10-soc.c
> index 44b7c56..4d52a80 100644
> --- a/drivers/fpga/stratix10-soc.c
> +++ b/drivers/fpga/stratix10-soc.c
> @@ -14,9 +14,13 @@
>   /*
>    * FPGA programming requires a higher level of privilege (EL3), per the SoC
>    * design.
> + * SoC firmware supports full and partial reconfiguration.
>    */
>   #define NUM_SVC_BUFS	4
>   #define SVC_BUF_SIZE	SZ_512K
> +#define FULL_RECONFIG_FLAG	0
> +#define PARTIAL_RECONFIG_FLAG	1
> +
>   
>   /* Indicates buffer is in use if set */
>   #define SVC_BUF_LOCK	0
> @@ -182,12 +186,12 @@ static int s10_ops_write_init(struct fpga_manager *mgr,
>   	uint i;
>   	int ret;
>   
> -	ctype.flags = 0;
>   	if (info->flags & FPGA_MGR_PARTIAL_RECONFIG) {
>   		dev_dbg(dev, "Requesting partial reconfiguration.\n");
> -		ctype.flags |= BIT(COMMAND_RECONFIG_FLAG_PARTIAL);
> +		ctype.flags = PARTIAL_RECONFIG_FLAG;
>   	} else {
>   		dev_dbg(dev, "Requesting full reconfiguration.\n");
> +		ctype.flags = FULL_RECONFIG_FLAG;
>   	}
>   
>   	reinit_completion(&priv->status_return_completion);
> @@ -210,6 +214,7 @@ static int s10_ops_write_init(struct fpga_manager *mgr,
>   
>   	ret = 0;
>   	if (!test_and_clear_bit(SVC_STATUS_OK, &priv->status)) {
> +		dev_err(dev, "RECONFIG_REQUEST failed\n");
>   		ret = -ETIMEDOUT;
>   		goto init_done;
>   	}
>