Hi,

just booted 2.5.36-mm1. The following part from dmesg appeared a little
strange or rather wrong to me. The systems runs fine as far as I can see.

ide1 at 0x170-0x177,0x376 on irq 15
ICH: IDE controller at PCI slot 00:1f.1
PCI: Unable to reserve I/O region #5:10@f000 for device 00:1f.1
ICH: not 100% native mode: will probe irqs later
ICH: port 0x01f0 already claimed by ide0
ICH: port 0x0170 already claimed by ide1
ICH: neither IDE port enabled (BIOS)

Are these messages bad?


Best regards,
Axel


Linux prester 2.5.36-mm1 #0 Wed Sep 18 17:38:19 CEST 2002 i686 unknown

Gnu C                  gcc (GCC) 3.2.1 20020915 (prerelease) Copyright (C)
2002
Free Software Foundation, Inc. This is free software; see the source for
copying conditions. There is NO warranty; not even for MERCHANTABILITY or
FITNESS FOR A PARTICULAR PURPOSE.
Gnu make               3.79.1
util-linux             2.11r
mount                  2.11r
modutils               2.4.19
e2fsprogs              1.27
PPP                    2.4.1
Linux C Library        2.2.5
Dynamic linker (ldd)   2.2.5
Procps                 2.0.8
Net-tools              1.60
Kbd                    1.06
Sh-utils               2.0
Modules Loaded         8250 core rtc nls_iso8859-1 nls_cp437 minix

00:00.0 Host bridge: Intel Corp. 82810 GMCH [Graphics Memory Controller Hub]
(rev 03)
        Subsystem: Intel Corp. 82810 GMCH [Graphics Memory Controller Hub]
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort-
<TAbort-
<MAbort+ >SERR- <PERR-
        Latency: 0

00:01.0 VGA compatible controller: Intel Corp. 82810 CGC [Chipset Graphics
Controller] (rev 03) (prog-if 00 [VGA])
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at d0000000 (32-bit, prefetchable) [size=64M]
        Region 1: Memory at d4000000 (32-bit, non-prefetchable) [size=512K]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

00:1e.0 PCI bridge: Intel Corp. 82801AA PCI Bridge (rev 02) (prog-if 00
[Normal
decode])
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR+ FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort-
<TAbort-
<MAbort- >SERR- <PERR-
        Latency: 0
        Bus: primary=00, secondary=01, subordinate=01, sec-latency=32
        I/O behind bridge: 0000f000-00000fff
        Memory behind bridge: fff00000-000fffff
        Prefetchable memory behind bridge: fff00000-000fffff
        BridgeCtl: Parity- SERR+ NoISA+ VGA- MAbort- >Reset- FastB2B-

00:1f.0 ISA bridge: Intel Corp. 82801AA ISA Bridge (LPC) (rev 02)
        Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0

00:1f.1 IDE interface: Intel Corp. 82801AA IDE (rev 02) (prog-if 80
[Master])
        Subsystem: Intel Corp. 82801AA IDE
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Region 4: I/O ports at f000 [size=16]

00:1f.2 USB Controller: Intel Corp. 82801AA USB (rev 02) (prog-if 00 [UHCI])
        Subsystem: Intel Corp. 82801AA USB
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin D routed to IRQ 5
        Region 4: I/O ports at d000 [size=32]

00:1f.5 Multimedia audio controller: Intel Corp. 82801AA AC'97 Audio (rev
02)
        Subsystem: Analog Devices: Unknown device 5348
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin B routed to IRQ 5
        Region 0: I/O ports at d800 [size=256]
        Region 1: I/O ports at dc00 [size=64]