IDE errors with HPT302

* IDE errors with HPT302
@ 2003-07-31  5:22 Aaron Lehmann
  0 siblings, 0 replies; only message in thread
From: Aaron Lehmann @ 2003-07-31  5:22 UTC (permalink / raw)
  To: linux-kernel

In a box, we have a HPT302 IDE card, sharing an IRQ with the 3c905C
Ethernet card:

HPT302: IDE controller at PCI slot 00:09.0
PCI: Found IRQ 11 for device 00:09.0
PCI: Sharing IRQ 11 with 00:0f.0
HPT302: chipset revision 1
HPT302: not 100% native mode: will probe irqs later
HPT37X: using 33MHz PCI clock
    ide2: BM-DMA at 0xb400-0xb407, BIOS settings: hde:pio, hdf:pio
    ide3: BM-DMA at 0xb408-0xb40f, BIOS settings: hdg:pio, hdh:pio

There is also a HPT370 in the system and a PIIX4.

Here are the errors, which make the card unusable:

Partition check:
 hda: hda1 hda2 < hda5 >
 hde:<4>hde: dma_timer_expiry: dma status == 0x61
hde: error waiting for DMA
hde: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }

hde: status timeout: status=0xd0 { Busy }

hdf: DMA disabled
hde: drive not ready for command
ide2: reset: success
blk: queue c02d1ff8, I/O limit 4095Mb (mask 0xffffffff)
 hde1
 hdf: unknown partition table
 hdg:<4>hdg: dma_timer_expiry: dma status == 0x01
hdg: error waiting for DMA
hdg: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }

blk: queue c02d2464, I/O limit 4095Mb (mask 0xffffffff)
 unknown partition table
 hdh:<4>hdh: dma_timer_expiry: dma status == 0x21
hdh: error waiting for DMA
hdh: dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }

I'm assuming this is a driver issue since it happens with all 4 of the
drives. This happens with 2.4.21 and 2.4.22-pre9. Anyone had similar
experiences?

^ permalink raw reply	[flat|nested] only message in thread