* audio problem with 2.4.22-pre10 and 2.4.22-pre10-ac1
@ 2003-08-02 7:31 Pasi Savilaakso
2003-08-02 12:19 ` Nuno Monteiro
0 siblings, 1 reply; 3+ messages in thread
From: Pasi Savilaakso @ 2003-08-02 7:31 UTC (permalink / raw)
To: linux-kernel
I have one asus a7v8x-x, which I just installed. Everything else is fine but
no audio. when I got this on first time after compiling kernel and tried many
different configs but no success at all. current audio config is at the end of
mail.
dmesg tells:
Via 686a/8233/8235 audio driver 1.9.1-ac3
via82cxxx: Six channel audio available
PCI: Setting latency timer of device 00:11.5 to 64
via82cxxx: timeout while reading AC97 codec (0x8000000)
ac97_codec: AC97 Audio codec, id: ADS112 (Unknown)
via82cxxx: board #1 at 0xE000, IRQ 22
<--cut-->
via_audio: ignoring drain playback error -11
lspci:
00:00.0 Host bridge: VIA Technologies, Inc. VT8377 [KT400 AGP] Host Bridge
00:01.0 PCI bridge: VIA Technologies, Inc. VT8235 PCI Bridge
00:10.0 USB Controller: VIA Technologies, Inc. USB (rev 80)
00:10.1 USB Controller: VIA Technologies, Inc. USB (rev 80)
00:10.2 USB Controller: VIA Technologies, Inc. USB (rev 80)
00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
00:11.1 IDE interface: VIA Technologies, Inc. VT82C586/B/686A/B PIPC Bus
Master IDE (rev 06)
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233 AC97 Audio
Controller (rev 50)
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 74)
01:00.0 VGA compatible controller: nVidia Corporation NV17 [GeForce4 MX 420]
(rev a3)
lspci -n
00:00.0 Class 0600: 1106:3189
00:01.0 Class 0604: 1106:b168
00:10.0 Class 0c03: 1106:3038 (rev 80)
00:10.1 Class 0c03: 1106:3038 (rev 80)
00:10.2 Class 0c03: 1106:3038 (rev 80)
00:10.3 Class 0c03: 1106:3104 (rev 82)
00:11.0 Class 0601: 1106:3177
00:11.1 Class 0101: 1106:0571 (rev 06)
00:11.5 Class 0401: 1106:3059 (rev 50)
00:12.0 Class 0200: 1106:3065 (rev 74)
01:00.0 Class 0300: 10de:0172 (rev a3)
kernel config:
# Sound
#
CONFIG_SOUND=y
# CONFIG_SOUND_ALI5455 is not set
# CONFIG_SOUND_BT878 is not set
# CONFIG_SOUND_CMPCI is not set
# CONFIG_SOUND_EMU10K1 is not set
# CONFIG_MIDI_EMU10K1 is not set
# CONFIG_SOUND_FUSION is not set
# CONFIG_SOUND_CS4281 is not set
# CONFIG_SOUND_ES1370 is not set
# CONFIG_SOUND_ES1371 is not set
# CONFIG_SOUND_ESSSOLO1 is not set
# CONFIG_SOUND_MAESTRO is not set
# CONFIG_SOUND_MAESTRO3 is not set
# CONFIG_SOUND_FORTE is not set
# CONFIG_SOUND_ICH is not set
# CONFIG_SOUND_RME96XX is not set
# CONFIG_SOUND_SONICVIBES is not set
# CONFIG_SOUND_TRIDENT is not set
# CONFIG_SOUND_MSNDCLAS is not set
# CONFIG_SOUND_MSNDPIN is not set
CONFIG_SOUND_VIA82CXXX=y
# CONFIG_SOUND_OSS is not set
# CONFIG_SOUND_TVMIXER is not set
CONFIG_SOUND_AD1980=y
# CONFIG_SOUND_WM97XX is not set
^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: audio problem with 2.4.22-pre10 and 2.4.22-pre10-ac1
2003-08-02 7:31 audio problem with 2.4.22-pre10 and 2.4.22-pre10-ac1 Pasi Savilaakso
@ 2003-08-02 12:19 ` Nuno Monteiro
2003-08-03 4:46 ` Pasi Savilaakso
0 siblings, 1 reply; 3+ messages in thread
From: Nuno Monteiro @ 2003-08-02 12:19 UTC (permalink / raw)
To: Pasi Savilaakso; +Cc: Linux Kernel ML
On 2003.08.02 08:31, Pasi Savilaakso wrote:
> I have one asus a7v8x-x, which I just installed. Everything else is
> fine
> but
> no audio. when I got this on first time after compiling kernel and
> tried
> many
> different configs but no success at all. current audio config is at the
> end of
> mail.
>
<snip snip>
Hi Pasi,
I have a similar board lying around and I had some trouble getting sound
to work with OSS/2.4 drivers also. As I remember. the trick was to
connect the speakers to the microphone port (the pink one, on the far
left), instead of the regular speaker-out. With ALSA, both on 2.4 or
2.5/6, the sound output is on the speaker-out port, as it should. One
small quirk though, as the sound volume is controled by the "Surround"
mixer setting, rather than "Master" -- this has the most annoying effect
of making the sound-volume task bar applets useless. Eventually I just
gave up on the on-board sound and plugged in a pci soundblaster.
Hope this can help you.
Regards,
Nuno
^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: audio problem with 2.4.22-pre10 and 2.4.22-pre10-ac1
2003-08-02 12:19 ` Nuno Monteiro
@ 2003-08-03 4:46 ` Pasi Savilaakso
0 siblings, 0 replies; 3+ messages in thread
From: Pasi Savilaakso @ 2003-08-03 4:46 UTC (permalink / raw)
To: Nuno Monteiro; +Cc: Linux Kernel ML
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Viestissä Lauantai 2. Elokuuta 2003 15:19, Nuno Monteiro kirjoitti:
> Hi Pasi,
>
>
> I have a similar board lying around and I had some trouble getting sound
> to work with OSS/2.4 drivers also. As I remember. the trick was to
> connect the speakers to the microphone port (the pink one, on the far
> left), instead of the regular speaker-out. With ALSA, both on 2.4 or
> 2.5/6, the sound output is on the speaker-out port, as it should. One
> small quirk though, as the sound volume is controled by the "Surround"
> mixer setting, rather than "Master" -- this has the most annoying effect
> of making the sound-volume task bar applets useless. Eventually I just
> gave up on the on-board sound and plugged in a pci soundblaster.
>
> Hope this can help you.
Thanks for the tip but It wasn't the solution. all 3 lines out are dead. It is
shame since I sold my sblive a while back.
Pasi
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (GNU/Linux)
iD8DBQE/LJOuCATNOy4O2C4RAlZFAKDCeR6dHcLYR9j7ro7ZicsIxEntnQCfbzJ7
CsI/+8jx6u0/G1IZam+XaYI=
=gyaq
-----END PGP SIGNATURE-----
^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2003-08-03 4:44 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2003-08-02 7:31 audio problem with 2.4.22-pre10 and 2.4.22-pre10-ac1 Pasi Savilaakso
2003-08-02 12:19 ` Nuno Monteiro
2003-08-03 4:46 ` Pasi Savilaakso
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).