From: Peter Chen <hzpeterchen@gmail.com>
To: Stephen Boyd <stephen.boyd@linaro.org>
Cc: linux-usb@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
linux-kernel@vger.kernel.org, linux-arm-msm@vger.kernel.org,
Andy Gross <andy.gross@linaro.org>,
Bjorn Andersson <bjorn.andersson@linaro.org>,
Neil Armstrong <narmstrong@baylibre.com>,
Arnd Bergmann <arnd@arndb.de>, Felipe Balbi <balbi@kernel.org>,
Peter Chen <peter.chen@nxp.com>,
Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Subject: Re: [PATCH 12/21] usb: chipidea: msm: Keep device runtime enabled
Date: Wed, 29 Jun 2016 14:46:00 +0800 [thread overview]
Message-ID: <20160629064600.GG25236@shlinux2> (raw)
In-Reply-To: <20160626072838.28082-13-stephen.boyd@linaro.org>
On Sun, Jun 26, 2016 at 12:28:29AM -0700, Stephen Boyd wrote:
> Sometimes the usb wrapper device is part of a power domain that
> needs to stay on as long as the device is active. Let's get and
> put the device in driver probe/remove so that we keep the power
> domain powered as long as the device is attached. We can fine
> tune this later to handle wakeup interrupts, etc. for finer grain
> power management later, but this is necessary to make sure we can
> keep accessing the device right now.
Since some of the controllers work abnormal if we enables runtime
pm unconditionally, so I use one system flag CI_HDRC_SUPPORTS_RUNTIME_PM
for it. I can't understand why you can't access device without enable
parent's runtime pm, the controller will not enter runtime suspend
without that flag.
Peter
>
> Cc: Peter Chen <peter.chen@nxp.com>
> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
> Signed-off-by: Stephen Boyd <stephen.boyd@linaro.org>
> ---
> drivers/usb/chipidea/ci_hdrc_msm.c | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/drivers/usb/chipidea/ci_hdrc_msm.c b/drivers/usb/chipidea/ci_hdrc_msm.c
> index 520c85e701ef..430856ef1be3 100644
> --- a/drivers/usb/chipidea/ci_hdrc_msm.c
> +++ b/drivers/usb/chipidea/ci_hdrc_msm.c
> @@ -80,6 +80,7 @@ static int ci_hdrc_msm_probe(struct platform_device *pdev)
>
> pm_runtime_no_callbacks(&pdev->dev);
> pm_runtime_enable(&pdev->dev);
> + pm_runtime_get(&pdev->dev);
>
> return 0;
> }
> @@ -88,6 +89,7 @@ static int ci_hdrc_msm_remove(struct platform_device *pdev)
> {
> struct platform_device *plat_ci = platform_get_drvdata(pdev);
>
> + pm_runtime_put(&pdev->dev);
> pm_runtime_disable(&pdev->dev);
> ci_hdrc_remove_device(plat_ci);
>
> --
> 2.9.0.rc2.8.ga28705d
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-usb" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
Best Regards,
Peter Chen
next prev parent reply other threads:[~2016-06-29 6:53 UTC|newest]
Thread overview: 69+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-06-26 7:28 [PATCH 00/21] Support qcom's HSIC USB and rewrite USB2 HS phy support Stephen Boyd
2016-06-26 7:28 ` [PATCH 01/21] of: device: Support loading a module with OF based modalias Stephen Boyd
2016-06-28 4:17 ` Bjorn Andersson
2016-06-26 7:28 ` [PATCH 02/21] usb: ulpi: Support device discovery via DT Stephen Boyd
2016-06-27 4:21 ` kbuild test robot
2016-06-27 14:34 ` Heikki Krogerus
[not found] ` <146706544012.30684.15569003844798199881@sboyd-linaro>
2016-06-28 11:42 ` Heikki Krogerus
2016-06-29 1:53 ` Peter Chen
2016-06-28 20:56 ` Rob Herring
[not found] ` <146715176149.31418.10938517376423447782@sboyd-linaro>
2016-07-01 0:59 ` Rob Herring
2016-06-26 7:28 ` [PATCH 03/21] usb: ulpi: Avoid reading/writing in device creation with OF devices Stephen Boyd
2016-06-26 7:28 ` [PATCH 04/21] usb: chipidea: Only read/write OTGSC from one place Stephen Boyd
2016-06-27 8:04 ` Jun Li
2016-06-27 19:07 ` Stephen Boyd
2016-06-28 9:36 ` Peter Chen
2016-06-26 7:28 ` [PATCH 05/21] usb: chipidea: Handle extcon events properly Stephen Boyd
2016-06-28 10:01 ` Peter Chen
2016-06-26 7:28 ` [PATCH 06/21] usb: chipidea: Initialize and reinitialize phy later Stephen Boyd
2016-06-29 2:30 ` Peter Chen
[not found] ` <146724983020.16253.12640673678669134952@sboyd-linaro>
2016-06-30 1:22 ` Peter Chen
2016-06-26 7:28 ` [PATCH 07/21] usb: chipidea: Notify of reset when switching into host mode Stephen Boyd
2016-06-26 7:28 ` [PATCH 08/21] usb: chipidea: Kick OTG state machine for AVVIS with vbus extcon Stephen Boyd
2016-06-29 3:09 ` Peter Chen
[not found] ` <146724959973.16253.818114721999543873@sboyd-linaro>
2016-06-30 1:26 ` Peter Chen
2016-06-30 1:50 ` Jun Li
2016-06-26 7:28 ` [PATCH 09/21] usb: chipidea: Add support for ULPI PHY bus Stephen Boyd
2016-06-29 6:26 ` Peter Chen
2016-06-26 7:28 ` [PATCH 10/21] usb: chipidea: msm: Rely on core to override AHBBURST Stephen Boyd
2016-06-29 6:32 ` Peter Chen
[not found] ` <146722676163.16253.15476996138920236894@sboyd-linaro>
2016-06-30 1:18 ` Peter Chen
2016-06-26 7:28 ` [PATCH 11/21] usb: chipidea: msm: Use hw_write_id_reg() instead of writel directly Stephen Boyd
2016-06-29 6:37 ` Peter Chen
2016-06-26 7:28 ` [PATCH 12/21] usb: chipidea: msm: Keep device runtime enabled Stephen Boyd
2016-06-29 6:46 ` Peter Chen [this message]
[not found] ` <146724741028.16253.4741331543289283958@sboyd-linaro>
2016-06-30 1:39 ` Peter Chen
[not found] ` <146731865461.12823.6532384101517870130@sboyd-linaro>
2016-07-01 3:20 ` Peter Chen
2016-06-26 7:28 ` [PATCH 13/21] usb: chipidea: msm: Allow core to get usb phy Stephen Boyd
2016-06-29 6:48 ` Peter Chen
2016-06-29 11:34 ` Peter Chen
[not found] ` <146722867837.16253.5338887948471498730@sboyd-linaro>
2016-06-30 1:43 ` Peter Chen
2016-06-26 7:28 ` [PATCH 14/21] usb: chipidea: msm: Add proper clk and reset support Stephen Boyd
2016-06-29 7:02 ` Peter Chen
2016-06-26 7:28 ` [PATCH 15/21] usb: chipidea: msm: Mux over secondary phy at the right time Stephen Boyd
2016-06-28 4:51 ` Bjorn Andersson
2016-06-29 8:08 ` Peter Chen
[not found] ` <146722853892.16253.6137643683844696922@sboyd-linaro>
2016-06-30 1:52 ` Peter Chen
2016-06-26 7:28 ` [PATCH 16/21] usb: chipidea: msm: Restore wrapper settings after reset Stephen Boyd
2016-06-29 8:26 ` Peter Chen
[not found] ` <146722762509.16253.13062209537472705701@sboyd-linaro>
2016-06-30 8:54 ` Peter Chen
2016-06-30 16:24 ` Stephen Boyd
2016-06-26 7:28 ` [PATCH 17/21] usb: chipidea: msm: Make platform data driver local instead of global Stephen Boyd
2016-06-29 11:29 ` Peter Chen
[not found] ` <146722783258.16253.8246581455698560411@sboyd-linaro>
2016-06-30 9:08 ` Peter Chen
2016-06-26 7:28 ` [PATCH 18/21] usb: chipidea: msm: Add reset controller for PHY POR bit Stephen Boyd
2016-06-27 3:41 ` kbuild test robot
2016-06-27 4:51 ` kbuild test robot
2016-06-27 7:50 ` kbuild test robot
2016-06-29 11:45 ` Peter Chen
2016-06-26 7:28 ` [PATCH 19/21] usb: chipidea: msm: Be silent on probe defer errors Stephen Boyd
2016-06-30 1:06 ` Peter Chen
2016-06-26 7:28 ` [PATCH 20/21] phy: Add support for Qualcomm's USB HSIC phy Stephen Boyd
2016-06-28 8:49 ` Neil Armstrong
2016-06-28 21:58 ` Stephen Boyd
2016-06-29 9:16 ` Neil Armstrong
2016-06-29 18:54 ` Stephen Boyd
2016-06-26 7:28 ` [PATCH 21/21] phy: Add support for Qualcomm's USB HS phy Stephen Boyd
2016-06-28 3:09 ` [PATCH 00/21] Support qcom's HSIC USB and rewrite USB2 HS phy support John Stultz
[not found] ` <146710289677.3879.15364764209076318827@sboyd-linaro>
2016-07-02 6:03 ` John Stultz
[not found] ` <146774653916.32648.3323628902201136171@sboyd-linaro>
2016-07-05 19:33 ` John Stultz
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20160629064600.GG25236@shlinux2 \
--to=hzpeterchen@gmail.com \
--cc=andy.gross@linaro.org \
--cc=arnd@arndb.de \
--cc=balbi@kernel.org \
--cc=bjorn.andersson@linaro.org \
--cc=gregkh@linuxfoundation.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=narmstrong@baylibre.com \
--cc=peter.chen@nxp.com \
--cc=stephen.boyd@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).