linux-kernel.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: John Keeping <john@metanate.com>
To: Mark Yao <mark.yao@rock-chips.com>
Cc: Chris Zhong <zyw@rock-chips.com>,
	dri-devel@lists.freedesktop.org,
	linux-arm-kernel@lists.infradead.org,
	linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org,
	John Keeping <john@metanate.com>
Subject: [PATCH v3 19/24] drm/rockchip: dw-mipi-dsi: use positive check for N{H,V}SYNC
Date: Sun, 29 Jan 2017 13:24:39 +0000	[thread overview]
Message-ID: <20170129132444.25251-20-john@metanate.com> (raw)
In-Reply-To: <20170129132444.25251-1-john@metanate.com>

This matches other drivers.

Signed-off-by: John Keeping <john@metanate.com>
---
Unchanged in v3
Unchanged in v2

 drivers/gpu/drm/rockchip/dw-mipi-dsi.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
index be395c3c5c06..f5b15377ef85 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
@@ -774,9 +774,9 @@ static void dw_mipi_dsi_dpi_config(struct dw_mipi_dsi *dsi,
 		break;
 	}
 
-	if (!(mode->flags & DRM_MODE_FLAG_PVSYNC))
+	if (mode->flags & DRM_MODE_FLAG_NVSYNC)
 		val |= VSYNC_ACTIVE_LOW;
-	if (!(mode->flags & DRM_MODE_FLAG_PHSYNC))
+	if (mode->flags & DRM_MODE_FLAG_NHSYNC)
 		val |= HSYNC_ACTIVE_LOW;
 
 	dsi_write(dsi, DSI_DPI_VCID, DPI_VID(dsi->channel));
-- 
2.11.0.197.gb556de5.dirty

  parent reply	other threads:[~2017-01-29 15:18 UTC|newest]

Thread overview: 70+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2017-01-29 13:24 [PATCH v3 00/24] drm/rockchip: MIPI fixes & improvements John Keeping
2017-01-29 13:24 ` [PATCH v3 01/24] drm/rockchip: dw-mipi-dsi: don't configure hardware in mode_set for MIPI John Keeping
2017-01-30 15:35   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 02/24] drm/rockchip: dw-mipi-dsi: pass mode in where needed John Keeping
2017-01-30 15:40   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 03/24] drm/rockchip: dw-mipi-dsi: remove mode_set hook John Keeping
2017-01-30 15:40   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 04/24] drm/rockchip: dw-mipi-dsi: fix command header writes John Keeping
2017-01-30 15:43   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 05/24] drm/rockchip: dw-mipi-dsi: fix generic packet status check John Keeping
2017-01-30 17:56   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 06/24] drm/rockchip: dw-mipi-dsi: avoid out-of-bounds read on tx_buf John Keeping
2017-01-30 18:01   ` Sean Paul
2017-01-30 18:16     ` John Keeping
2017-01-30 20:09       ` Sean Paul
2017-01-31 11:45         ` John Keeping
2017-01-31 14:48           ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 07/24] drm/rockchip: dw-mipi-dsi: include bad value in error message John Keeping
2017-01-30 18:02   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 08/24] drm/rockchip: dw-mipi-dsi: respect message flags John Keeping
2017-01-30 18:19   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 09/24] drm/rockchip: dw-mipi-dsi: only request HS clock when required John Keeping
2017-01-30 18:20   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 10/24] drm/rockchip: dw-mipi-dsi: don't assume buffer is aligned John Keeping
2017-01-30 20:08   ` Sean Paul
2017-01-31 11:56     ` John Keeping
2017-01-31 14:53       ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 11/24] drm/rockchip: dw-mipi-dsi: prepare panel after phy init John Keeping
2017-01-30 20:16   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 12/24] drm/rockchip: dw-mipi-dsi: allow commands in panel_disable John Keeping
2017-01-30 20:19   ` Sean Paul
2017-01-31 12:03     ` John Keeping
2017-01-29 13:24 ` [PATCH v3 13/24] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2017-01-30 20:25   ` Sean Paul
2017-02-01 17:23     ` John Keeping
2017-01-29 13:24 ` [PATCH v3 14/24] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
2017-01-30 20:25   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 15/24] drm/rockchip: dw-mipi-dsi: configure PHY before enabling John Keeping
2017-01-30 20:28   ` Sean Paul
2017-01-31 12:14     ` John Keeping
2017-01-29 13:24 ` [PATCH v3 16/24] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
2017-01-30 21:57   ` Sean Paul
2017-01-31 12:39     ` John Keeping
2017-01-29 13:24 ` [PATCH v3 17/24] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2017-01-31 19:03   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 18/24] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2017-01-31 18:45   ` Sean Paul
2017-01-29 13:24 ` John Keeping [this message]
2017-01-31 19:12   ` [PATCH v3 19/24] drm/rockchip: dw-mipi-dsi: use positive check for N{H, V}SYNC Sean Paul
2017-01-29 13:24 ` [PATCH v3 20/24] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2017-01-31 19:14   ` Sean Paul
2017-01-29 13:24 ` [PATCH v3 21/24] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2017-01-31 19:21   ` Sean Paul
2017-02-10 17:27     ` John Keeping
2017-01-29 13:24 ` [PATCH v3 22/24] drm/rockchip: dw-mipi-dsi: support non-burst modes John Keeping
2017-01-31 19:22   ` Sean Paul
2017-02-16  3:01     ` Chris Zhong
2017-02-16 14:22       ` John Keeping
2017-01-29 13:24 ` [PATCH v3 23/24] drm/rockchip: dw-mipi-dsi: add reset control John Keeping
2017-01-31 19:28   ` Sean Paul
2017-02-15  3:38   ` Chris Zhong
2017-02-15 12:39     ` John Keeping
2017-02-16  2:12       ` Chris Zhong
2017-02-16 14:11         ` John Keeping
2017-01-29 13:24 ` [PATCH v3 24/24] drm/rockchip: dw-mipi-dsi: support read commands John Keeping
2017-01-30 15:26   ` Sean Paul
2017-01-30 18:14     ` John Keeping
2017-01-30 20:16       ` Sean Paul
2017-01-31 12:41         ` John Keeping
2017-01-31 14:47           ` Sean Paul

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20170129132444.25251-20-john@metanate.com \
    --to=john@metanate.com \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-rockchip@lists.infradead.org \
    --cc=mark.yao@rock-chips.com \
    --cc=zyw@rock-chips.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body. 
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).