From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1752602AbdFZWfg (ORCPT ); Mon, 26 Jun 2017 18:35:36 -0400 Received: from mail-qt0-f194.google.com ([209.85.216.194]:35423 "EHLO mail-qt0-f194.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752225AbdFZWeB (ORCPT ); Mon, 26 Jun 2017 18:34:01 -0400 From: Florian Fainelli To: linux-arm-kernel@lists.infradead.org Cc: Florian Fainelli , Rob Herring , Mark Rutland , Brian Norris , Gregory Fong , bcm-kernel-feedback-list@broadcom.com (maintainer:BROADCOM BCM7XXX ARM ARCHITECTURE), Hauke Mehrtens , =?UTF-8?q?Rafa=C5=82=20Mi=C5=82ecki?= , Ralf Baechle , Markus Mayer , Arnd Bergmann , Eric Anholt , Justin Chen , Doug Berger , devicetree@vger.kernel.org (open list:OPEN FIRMWARE AND FLATTENED DEVICE TREE BINDINGS), linux-kernel@vger.kernel.org (open list), linux-mips@linux-mips.org (open list:BROADCOM BCM47XX MIPS ARCHITECTURE), linux-pm@vger.kernerl.org, "Rafael J. Wysocki" Subject: [PATCH v2 3/4] dt-bindings: Document MIPS Broadcom STB power management nodes Date: Mon, 26 Jun 2017 15:32:45 -0700 Message-Id: <20170626223248.14199-6-f.fainelli@gmail.com> X-Mailer: git-send-email 2.9.3 In-Reply-To: <20170626223248.14199-1-f.fainelli@gmail.com> References: <20170626223248.14199-1-f.fainelli@gmail.com> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Document the different nodes required for supporting S2/S3/S5 suspend states on MIPS-based Broadcom STB SoCs. Signed-off-by: Florian Fainelli --- .../devicetree/bindings/mips/brcm/soc.txt | 153 +++++++++++++++++++++ 1 file changed, 153 insertions(+) diff --git a/Documentation/devicetree/bindings/mips/brcm/soc.txt b/Documentation/devicetree/bindings/mips/brcm/soc.txt index e4e1cd91fb1f..6bfe217668d6 100644 --- a/Documentation/devicetree/bindings/mips/brcm/soc.txt +++ b/Documentation/devicetree/bindings/mips/brcm/soc.txt @@ -11,3 +11,156 @@ Required properties: The experimental -viper variants are for running Linux on the 3384's BMIPS4355 cable modem CPU instead of the BMIPS5000 application processor. + +Power management +---------------- + +For power management (particularly, S2/S3/S5 system suspend), the following SoC +components are needed: + += Always-On control block (AON CTRL) + +This hardware provides control registers for the "always-on" (even in low-power +modes) hardware, such as the Power Management State Machine (PMSM). + +Required properties: +- compatible : should be one of + "brcm,bcm7425-aon-ctrl" + "brcm,bcm7429-aon-ctrl" + "brcm,bcm7435-aon-ctrl" and + "brcm,brcmstb-aon-ctrl" +- reg : the register start and length for the AON CTRL block + +Example: + +syscon@410000 { + compatible = "brcm,bcm7425-aon-ctrl", "brcm,brcmstb-aon-ctrl"; + reg = <0x410000 0x400>; +}; + += Memory controllers + +A Broadcom STB SoC typically has a number of independent memory controllers, +each of which may have several associated hardware blocks, which are versioned +independently (control registers, DDR PHYs, etc.). One might consider +describing these controllers as a parent "memory controllers" block, which +contains N sub-nodes (one for each controller in the system), each of which is +associated with a number of hardware register resources (e.g., its PHY. + +== MEMC (MEMory Controller) + +Represents a single memory controller instance. + +Required properties: +- compatible : should contain "brcm,brcmstb-memc" and "simple-bus" +- ranges : should contain the child address in the parent address + space, must be 0 here, and the register start and length of + the entire memory controller (including all sub nodes: DDR PHY, + arbiter, etc.) +- #address-cells : must be 1 +- #size-cells : must be 1 + +Example: + + memory-controller: memc@0 { + compatible = "brcm,brcmstb-memc", "simple-bus"; + ranges = <0x0 0x0 0xa000>; + #address-cells = <1>; + #size-cells = <1>; + + memc-arb@1000 { + ... + }; + + memc-ddr@2000 { + ... + }; + + ddr-phy@6000 { + ... + }; + }; + +Should contain subnodes for any of the following relevant hardware resources: + +== DDR PHY control + +Control registers for this memory controller's DDR PHY. + +Required properties: +- compatible : should contain one of these + "brcm,brcmstb-ddr-phy-v64.5" + "brcm,brcmstb-ddr-phy" + +- reg : the DDR PHY register range and length + +Example: + + ddr-phy@6000 { + compatible = "brcm,brcmstb-ddr-phy-v64.5"; + reg = <0x6000 0xc8>; + }; + +== DDR memory controller sequencer + +Control registers for this memory controller's DDR memory sequencer + +Required properties: +- compatible : should contain one of these + "brcm,bcm7425-memc-ddr" + "brcm,bcm7429-memc-ddr" + "brcm,bcm7435-memc-ddr" and + "brcm,brcmstb-memc-ddr" + +- reg : the DDR sequencer register range and length + +Example: + + memc-ddr@2000 { + compatible = "brcm,bcm7425-memc-ddr", "brcm,brcmstb-memc-ddr"; + reg = <0x2000 0x300>; + }; + +== MEMC Arbiter + +The memory controller arbiter is responsible for memory clients allocation +(bandwidth, priorities etc.) and needs to have its contents restored during +deep sleep states (S3). + +Required properties: + +- compatible : should contain one of these + "brcm,brcmstb-memc-arb-v10.0.0.0" + "brcm,brcmstb-memc-arb" + +- reg : the DDR Arbiter register range and length + +Example: + + memc-arb@1000 { + compatible = "brcm,brcmstb-memc-arb-v10.0.0.0"; + reg = <0x1000 0x248>; + }; + +== Timers + +The Broadcom STB chips contain a timer block with several general purpose +timers that can be used. + +Required properties: + +- compatible : should contain one of: + "brcm,bcm7425-timers" + "brcm,bcm7429-timers" + "brcm,bcm7435-timers and + "brcm,brcmstb-timers" +- reg : the timers register range +- interrupts : the interrupt line for this timer block + +Example: + + timers: timers@4067c0 { + compatible = "brcm,bcm7425-timers", "brcm,brcmstb-timers"; + reg = <0x4067c0 0x40>; + interrupts = <&periph_intc 19>; + }; -- 2.9.3