Hi,

On Tue, Dec 05, 2017 at 05:24:47PM +0800, Chen-Yu Tsai wrote:
> On Fri, Dec 1, 2017 at 9:44 PM, Quentin Schulz
> <quentin.schulz@free-electrons.com> wrote:
> > This adds DT node for the GPIO/pinctrl part present in AXP813/AXP818.
> >
> > Signed-off-by: Quentin Schulz <quentin.schulz@free-electrons.com>
> > ---
> >  arch/arm/boot/dts/axp81x.dtsi | 6 ++++++
> >  1 file changed, 6 insertions(+)
> >
> > diff --git a/arch/arm/boot/dts/axp81x.dtsi b/arch/arm/boot/dts/axp81x.dtsi
> > index 73b761f..0ef959d 100644
> > --- a/arch/arm/boot/dts/axp81x.dtsi
> > +++ b/arch/arm/boot/dts/axp81x.dtsi
> > @@ -48,6 +48,12 @@
> >         interrupt-controller;
> >         #interrupt-cells = <1>;
> >
> > +       axp_gpio: axp-gpio {
> > +               compatible = "x-powers,axp813-gpio";
> > +               gpio-controller;
> > +               #gpio-cells = <2>;
> 
> What about interrupt-controller for directly referenced interrupts from
> the GPIO pins?

There's a bit more to it to enable interrupts. You would probably need
to set up a chained interrupt controller in the GPIO driver, and in
the DTS with a interrupt-parent and interrupts properties pointing to
the AXP device itself.

> Otherwise,
> 
> Acked-by: Chen-Yu Tsai <wens@csie.org>

Applied 9 and 10, thanks!
Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com