Hi,

On Fri, Apr 27, 2018 at 06:03:02PM +0200, Paweł Chmiel wrote:
> This patch adds devicetree bindings documentation for
> battery charging controller as the subnode of MAX8998 PMIC.
> It's based on current behavior of driver.
> 
> Fixes: ee999fb3f17f ("mfd: max8998: Add support for Device Tree")
> Signed-off-by: Paweł Chmiel <pawel.mikolaj.chmiel@gmail.com>
> ---
>  Documentation/devicetree/bindings/mfd/max8998.txt | 22 ++++++++++++++++++++++
>  1 file changed, 22 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/mfd/max8998.txt b/Documentation/devicetree/bindings/mfd/max8998.txt
> index 23a3650ff2a2..f95610afb57f 100644
> --- a/Documentation/devicetree/bindings/mfd/max8998.txt
> +++ b/Documentation/devicetree/bindings/mfd/max8998.txt
> @@ -50,6 +50,21 @@ Additional properties required if max8998,pmic-buck2-dvs-gpio is defined:
>  - max8998,pmic-buck2-dvs-voltage: An array of 2 voltage values in microvolts
>    for buck2 regulator that can be selected using dvs gpio.
>  
> +Charger: Configuration for battery charging controller should be added
> +inside a child node named 'charger'.
> +  Required properties:
> +  - max8998,charge-eoc: Setup "End of Charge". If value equals 0,
> +    remain value set from bootloader or default value will be used.
> +    Valid values: 0, 10 - 45
> +
> +  - max8998,charge-restart: Setup "Charge Restart Level". If value equals 0,
> +    remain value set from bootloader or default value will be used.
> +    Valid values: -1, 0, 100, 150, 200
> +
> +  - max8998,charge-timeout: Setup "Charge Full Timeout". If value equals 0,
> +    remain value set from bootloader or default value will be used.
> +    Valid values: -1, 0, 5, 6, 7

What are those values? seconds?

> +
>  Regulators: All the regulators of MAX8998 to be instantiated shall be
>  listed in a child node named 'regulators'. Each regulator is represented
>  by a child node of the 'regulators' node.
> @@ -99,6 +114,13 @@ Example:
>  		max8998,pmic-buck2-dvs-gpio = <&gpx0 0 3 0 0>; /* SET3 */
>  		max8998,pmic-buck2-dvs-voltage = <1350000>, <1300000>;
>  
> +		/* Charger configuration */
> +		charger {
> +			max8998,charge-eoc = <0>;
> +			max8998,charge-restart = <(-1)>;
> +			max8998,charge-timeout = <7>;
> +		};
> +
>  		/* Regulators to instantiate */
>  		regulators {
>  			ldo2_reg: LDO2 {
> -- 
> 2.7.4
>